Honeywell TH5110D1006 Support Question
Honeywell TH5110D1006 Support Question
Find answers below for this question about Honeywell TH5110D1006.Need a Honeywell TH5110D1006 manual? We have 2 online manuals for this item!
Question posted by aeharrin on July 8th, 2013
Honeywell Th5110d1006 Not Working
The thermostat doesnt really respond to anything I do to it. If I have the cooling set to 78 and the heat set to 75 and let it run on auto or even cool the ac will run into the 60s and won't stop until I cut off the power to the circuit breaker. If I put the heat on then it will go to that temp but strangely will still blow out cold air, so I'm not even sure if the stat is displaying the actual temp. Is this a thermostat problem or do I need to replace the circuit breaker?.......please help
Current Answers
Related Honeywell TH5110D1006 Manual Pages
Owner's Manual - Page 1
Operating Manual
FocusPRO® TH5000 Series
Non-Programmable Digital Thermostat
69-1923EFS-01
Owner's Manual - Page 2
... these instructions.
® U.S. All rights reserved. MCR29404
This manual covers the following models:
TH5110D: For 1 Heat/1 Cool systems TH5220D: For up to 2 Heat/2 Cool systems TH5320U: For up to 3 Heat/2 Cool systems (Remove battery holder to remove batteries. Copyright © 2009 Honeywell International Inc. ENGLISH
Battery Holder Press down and pull to find model number)
Need Help?
Owner's Manual - Page 3
... (10°C).
1
69-1923EFS-01 ENGLISH
Table of contents
About your new thermostat Thermostat features 2 Setup at a glance 3 Quick reference to controls 4 Quick reference to display 5
Programming & Operation Fan setting (auto/on 6 System setting (heat/cool/auto 7 Auto-changeover (heat/cool 8 Compressor protection 9
FocusPRO® TH5000 Series
Appendices Battery replacement 10 In case...
Owner's Manual - Page 4
..., backlit display is easy to -use, push-button climate control. It has been designed to give you many years of your new Honeywell thermostat. ENGLISH
Operating Manual
About your new thermostat
Congratulations on the purchase of reliable service and easy-to read-even in the dark. • Displays both room temperature and temperature...
Owner's Manual - Page 5
... needed .
3
69-1923EFS-01 Just check the settings below and change , see page 6. System (Heat/Cool/Auto/Em. Auto is ready to Auto To change, see page 7. Fan (Auto/On): Preset to go!
You can select heating or cooling, or set the system to use. ENGLISH
This thermostat is the most commonly used setting, but you may prefer On for improved air...
Owner's Manual - Page 9
... the cooling system.
• Off: Heating and cooling systems are off.
• Auto: Thermostat automatically selects heating or cooling depending on how your thermostat was installed. Compressor is locked out.
7
69-1923EFS-01 Select the system setting
FocusPRO® TH5000 Series
ENGLISH
Fan Auto
Fan Auto
System Heat
System Cool
MCR29408
Note: The Auto and Em Heat system settings may...
Owner's Manual - Page 10
Heat and cool settings must be changed.
69-1923EFS-01
8
be at least 3 degrees apart. ENGLISH
Operating Manual
Auto changeover (heat/cool)
Fan Auto
System Auto
MCR29409
Press until screen displays "Auto"
Auto Changeover is fixed, and cannot
thermostat was installed. The thermostat will automatically adjust settings to Auto, the thermostat automatically selects heating or cooling ...
Owner's Manual - Page 12
...a year, or before the batteries are depleted. All settings are optional (to provide backup power) if your thermostat was wired to the display during power interruptions. AAA ...TH5110D - Batteries provide backup power to run on AC power when installed. Operating Manual
Battery replacement
ENGLISH
Press and pull to remove
Auto
Replace Batttery MCR29409
Insert fresh alkaline batteries,...
Owner's Manual - Page 13
... if necessary. • Make sure power switch at heating & cooling system is on. • Make sure furnace door is closed securely. • If thermostat is battery-powered, make sure fresh AA or AAA alkaline
batteries (depending on model) are set to acceptable ranges:
settings do not • Heat: 40° to 90°F (4.5° to 37...
Owner's Manual - Page 15
... holder Part No. 50007072-001 Cover plate assembly Part No. 50002883-001
*Use to cover marks left by old thermostats.
13
69-1923EFS-01
ENGLISH Accessories/replacement parts
To order, please call Honeywell Customer Care toll-free at 1-800-468-1502. Customer assistance
Model number
Date code
xxxxxxx
xxxxxxx
MCR29412
FocusPRO®...
Owner's Manual - Page 16
...
69-1923EFS-01
14 If the product is determined to be defective or malfunctions, Honeywell shall repair or replace it ; If at 1-800-468-1502. Customer Care will ...or whether a replacement product can be sent to you purchased it (at Honeywell's option).
ENGLISH
Operating Manual
5-year limited warranty
Honeywell warrants this product, excluding battery, to be free from defects in the ...
Owner's Manual - Page 17
...Some states do not allow the exclusion or limitation of a consumer. Honeywell's sole responsibility shall be to you.
15
69-1923EFS-01 HONEYWELL SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY KIND,...OR ANY OTHER FAILURE OF THIS PRODUCT.
This warranty shall not apply if it is shown by Honeywell that the defect or malfunction was caused by damage which occurred while the product was in the...
Owner's Manual - Page 18
... implied warranty lasts, so the above limitation may have other rights which vary from state to you have any questions concerning this warranty, please write Honeywell Customer Relations, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-468-1502.
This warranty gives you specific legal rights, and you may not...
Owner's Manual - Page 21
Manuel d'utilisation
FocusPRO® Série TH5000
Thermostat numérique non programmable
Installation Guide - Page 1
...; Warm air, hot water, highefficiency furnaces, heat pumps, steam, gravity
• Heat only -
Installation Guide
FocusPRO® TH5000 Series
Non-Programmable Digital Thermostat
This manual covers the following models
• TH5110D: For 1 Heat/1 Cool systems • TH5220D: For up to 2 Heat/2 Cool systems • TH5320U: For up to 3 Heat/2 Cool systems (Remove battery holder to follow...
Installation Guide - Page 2
... battery holder. M29368
Wire hole
Mounting screws
Wall anchors
Wallplate
M29369
! Disconnect power before
beginning installation.
! Separate wallplate from new thermostat. Drill 7/32" holes for plaster.
It's easier to remove wallplate from thermostat. 2. MERCURY NOTICE
If this product is replacing a control that contains mercury in a sealed tube, do not place the old...
Installation Guide - Page 4
...] Install field jumper between Aux and E if there is not required.
[7] In Installer Setup, set changeover valve to O or B.
[8] In Installer Setup, set to 2Heat/1Cool Heat Pump.
[1] Power supply. Heat. Shielded cable is no emergency heat relay.
4 Connect to Honeywell zoning panels to switch the panel to 22-gauge thermostat wire. Installation Guide
Wiring
Wiring guide -
Installation Guide - Page 5
... contactor
C
24VAC common [3]
O/B Changeover valve [7]
G
Fan relay
Aux/E Auxiliary/Emergency heat relay
L
Sends output when set to Em.
Plug wall opening . ENGLISH
M29386
5
69-1922EFS-01
Heat [11]
See [notes] on the back of the thermostat, then push gently until the thermostat snaps in place. Thermostat mounting
Align the 4 tabs on the wallplate with non-flammable...
Installation Guide - Page 6
... terminal energized in bold)
Shaded areas below to configure the thermostat to match the installed heating/cooling system, and customize feature operation as otherwise noted.
1 System type
0 1 heat/1 cool conventional 1 1 heat/1 cool heat pump (no aux. heat) 6 2 heat/2 cool conventional 7 2 heat/1 cool conventional 8 1 heat/2 cool conventional 9 2 heat/2 cool heat pump (no aux.
Installation Guide - Page 8
... 20-30 Vac
E Emergency heat 20-30 Vac
L Output
20-30 Vac
Running Current 0.02-1.0 A 100 mA DC 0.02-0.5 A 0.02-1.0 A 0.02-1.0 A 0.02-0.5 A 0.02-0.5 A 0.02-1.0 A 0.02-0.5 A
Automation and Control Solutions
Honeywell International Inc. Installation Guide
Special function
Auxiliary heat control (Setup Function 26):
• Comfort Setting: The thermostat will prioritize comfort over economy...
Similar Questions
Honeywell Thermostat Th5110d1006 How To Replace Battery
(Posted by spimoc 10 years ago)
How To Reset A Honeywell Thermostat Th5110d1006
(Posted by Raymotm79vd 10 years ago)
Cant Get The Thermostat To Blow Hot Air Out It Just Blows Cold Air
(Posted by rankinade18 11 years ago)
Thermostat Problem
I set the thermostat to 74....systems cools down room & thermostat reads 74, but cooling (system...
I set the thermostat to 74....systems cools down room & thermostat reads 74, but cooling (system...
(Posted by rob82268 12 years ago)
My Settings Were Once Locked And Not Now Heat Wont Go Above 40 Now Though
I am not sure what happened cause air would not drop below 72 and I dont remember what setting was f...
I am not sure what happened cause air would not drop below 72 and I dont remember what setting was f...
(Posted by aspores 12 years ago)