Husqvarna HU675AWD Support Question
Husqvarna HU675AWD Support Question
Find answers below for this question about Husqvarna HU675AWD.Need a Husqvarna HU675AWD manual? We have 2 online manuals for this item!
Question posted by Dskradis on April 30th, 2019
My Awd Doesn't Work Should There Be A Cover On The Awd Above The Blades
The person who posted this question about this Husqvarna product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Answer #1: Posted by Odin on April 30th, 2019 10:58 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
A drive cover is supplied. For your issue, see https://www.repairclinic.com/RepairHelp/Lawn-Mower-Repair/21-311--SFU2NzVBV0Qg/Husqvarna-Lawn-Mower-Troubleshooting. The link most likely to solve is listed first. If the issue persists or if you require further explanation, you'll have to consult Husqvarna: use the contact information at https://www.contacthelp.com/Husqvarna/customer-service.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Husqvarna HU675AWD Manual Pages
Owners Manual - Page 2
BECOME ALERT!!! YOUR SAFETY IS INVOLVED. WARNING: This lawn mower is equipped with an internal combustion engine and should not be used on the machine and in effective working order by the blade.
• Be sure the area is used, it . I. Material may obscure vision. Always be maintained in the manual(s) before starting when setting...
Owners Manual - Page 3
... competent, well-trained technicians and the proper tools to prevent accidental starting.
• Keep nuts and bolts, especially blade attachement bolts, tight and keep wire away from plug to service or repair this lawn mower.
YOU SHOULD RECORD BOTH SERIAL NUMBER AND DATE OF PURCHASE AND KEEP IN A SAFE PLACE FOR FUTURE REFERENCE...
Owners Manual - Page 4
..., washers, bolts, etc., necessary to upper handle.
4. Refer to ensure proper tightness. TO REMOVE LAWN MOWER FROM CARTON
1. KNOB
LIFT UP
MOWING POSITION
UPPER HANDLE
UPPER HANDLE
"STAR" KNOB
FIG. 1
BOLT... KNOB
HANDLE BRACKET
FIG. 2
4 To ensure safe and proper operation of your lawn mower, all packing materials except padding between upper and lower handle and padding holding operator ...
Owners Manual - Page 5
...hold them in the Operation section of the bag top.
2. If bag gets wet, let it dry before using.
To convert mower to be used as a mulcher. INSTALL STARTER ROPE (See Fig. 4)
1. Loosen T-knob.
2. Tighten T-knob.
ASSEMBLY
TO ...HANDLE
ROPE GUIDE
T-KNOB
ENGINE STARTER ROPE
FIG. 4
TO INSTALL ATTACHMENTS
Your lawn mower was shipped ready to bagging or discharging, see "TO CONVERT...
Owners Manual - Page 6
...to start the engine.
OPERATION
KNOW YOUR LAWN MOWER
READ THIS OWNER'S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LAWN MOWER. WARNING: The blade turns when the engine is shipped WITHOUT OIL...CAP AIR FILTER DRIVE COVER
ENGINE OIL CAP WITH DIPSTICK
HOUSING
SPARK PLUG
MUFFLER
IMPORTANT: This lawn mower is running. Compare the illustrations with your lawn mower or in literature ...
Owners Manual - Page 7
...
OPERATOR PRESENCE CONTROL BAR
DRIVE CONTROL BAR
CAUTION: Federal regulations require an engine control to be positioned behind the mower handle to be replaced. The blade turns when the engine is running.
• Your lawn mower is worn and should be positioned between drive control cable and jam nut.
2.
The closer to the handle...
Owners Manual - Page 8
...8 Empty clippings from oil fill spout.
3.
OPERATION
TO CONVERT MOWER
Your lawn mower was shipped ready to change the oil more often under lawn
mower handle. 3.
BEFORE STARTING ENGINE
ADD OIL (See Fig. 10)
Your.... NOTE: Do not drag the bag when emptying;
For type and grade of the lawn mower and place the grass
catcher frame hooks onto the grass bag brackets. • To ...
Owners Manual - Page 9
... of acids during the initial use engine or carburetor cleaner products in the fuel tank or permanent damage may require that the lawn mower cuts off with your highest engine (blade) speed as very tall grass, it will disperse into the grass and not be present during storage. No priming or choking is...
Owners Manual - Page 10
... 100 OR SEASON HOURS
BEFORE STORAGE
Check for Loose Fasteners Clean / Inspect Grass Catcher * Check Tires Check Drive Wheels *** Clean Lawn Mower **** Clean under Drive Cover *** Check Drive Belt / Pulleys *** Check / Sharpen / Replace Blade Lubrication Clean and Recharge Battery **
Check Engine Oil level Change Engine Oil Clean Air Filter Inspect Muffler Replace Spark Plug...
Owners Manual - Page 11
... from inside the dust cover, pinion and/or drive wheel gear teeth.
4.
Remove blade and attaching hardware (bolt, lock washer and hardened washer).
6.
MAINTENANCE
LAWN MOWER
Always observe safety rules when...be cleaned to work properly. Be sure key in place. The wheels not turning freely means trash, grass cuttings, etc.
Be sure the trailing edge of blade (opposite sharp edge...
Owners Manual - Page 12
... ENGINE OIL (See Fig. 14)
NOTE: Before tipping lawn mower to check the oil level with water, but are not. • Slide blade on startup. 8.
Wait a minute to allow oil to spark plug. AIR FILTER (See Fig. 15)
Your engine will wear. Remove cover. 2. Give the lawn mower model number when ordering. The only time the...
Owners Manual - Page 13
...covered to the fitting where shown. Shut off water supply and remove hose from beneath the mower housing during the washout process.
6. Shut off the engine. 7. CAUTION: Do not remove hose from lawn mower. 3. CLEAN THE UNDERSIDE OF YOUR MOWER...er as follows: 1. WATER WASHOUT FEATURE (See Fig. 17)
Your lawn mower is running. If fuel filter becomes clogged, obstructing fuel &#...
Owners Manual - Page 14
... plug. Remove blade bolt, lockwasher, hardened washer and blade.
3. Disconnect cable from rear baffle / rear gearcase belt keeper.
6.
Disconnect spark plug wire from spark plug and place where it should be thrown out of the rear of this manual.
Remove debris shield.
4. Release control bar and stop engine. 2. LAWN MOWER
TO ADJUST CUTTING...
Owners Manual - Page 15
...) and loosening pulley with a 9/16" box wrench.
13. Reinstall rear gearcase pulley.
3. Reinstall all three idler pulleys from mower and discard. Install new belt on rear gearcase pulley. Reinstall drive cover.
10. Reinstall blade. Refer to "DRIVE CONTROL ADJUSTMENT" in housing to front gearcase pulley.
4. SERVICE AND ADJUSTMENTS
8. Place new belt on front...
Owners Manual - Page 16
... suspected carburetor problems, take your lawn mower handle for storage.
1. OVERSPEEDING THE ENGINE ABOVE THE FACTORY HIGH SPEED SETTING CAN BE DANGEROUS. LAWN MOWER
When lawn mower is to be used for 30..., you .
1. CARBURETOR
Your carburetor is running too fast or too slow, take your lawn mower has three (3) height positions - Remove knob and carriage bolt on sides of handle with ...
Owners Manual - Page 17
... fuel stabilizer.
Remove spark plug.
2. Pull starter handle slowly a few times to reach the carburetor. IMPORTANT: NEVER COVER MOWER WHILE ENGINE AND EXHAUST AREAS ARE STILL WARM.
CAUTION: Never store the lawn mower with a suitable protective cover that does not retain moisture. Add stabilizer to another.
• Replace your gasoline can if your unit with...
Owners Manual - Page 18
... upper handle before starting. Stale fuel.
3. Engine flywheel brake is released.
2. Belt wear. 2. Control bar defective.
9. Worn, bent or loose blade. 2. Grass catcher too full. 4. Raise rear of lawn mower housing one (1)
setting higher. 3. Too much grass. 3. TROUBLESHOOTING POINTS
PROBLEM
CAUSE
CORRECTION
Does not start
1. Clean/replace air filter.
2. Bad...
Owners Manual - Page 20
...or failure occurs.
9. These Limited Warranties are NOT covered:
(a) Abrasion to mower decks, including sand wear;
(b) Damage to cutting ...equipment by way of contact with engine speed governor or emission components, or running engines above specified and recommended engine speeds as belts, pulleys, spindle housings, bearings, blades...
Parts List - Page 3
...115 581 33 00-01 - - 115 66 18-96
DESCRIPTION
Screw, Dogpoint 3/8-16 x 1-1/8 Kit, Lawn Mower Housing Blade Adapter Blade, 22" Washer, Hardened Washer, Helical Bolt, Hex Head, Grade 8 3/8-24 x 1-3/8 Front Baf&#... given in U.S. HU675AWD (96143010801) PRODUCT NO. 961 43 01-08
KEY PART NO. inches. 1 inch = 25.4 mm. MODEL NO. Failure to do so could be hazardous, damage your lawn mower and void your...
Parts List - Page 5
HU675AWD (96143010801) PRODUCT NO. 961 43 01-08
KEY PART NO. IMPORTANT: Use only Original Equipment Manufacturer (O.E.M.) replacement parts. Failure to do so could be hazardous, damage your lawn mower and void your warranty. ...581 33 45-01 55 581 35 13-01 59 532 44 21-13
DESCRIPTION
E-Ring 7/16 Cover, Dust, Wheel Nut, Hex Pawl, Drive Wheel & Tire Assembly Nut, Flangelock 3/8-16 O-Ring...
Similar Questions
Drive Cable Replacement
can you tell me how to replace drive cable on hu675 awf
can you tell me how to replace drive cable on hu675 awf
(Posted by vbandpb 1 year ago)
Husqvarna Riding Lawn Mower Starts, Blade Spins, Won't Go Forward Nor Reverse
(Posted by shywolfalways82 3 years ago)
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
Engine Runs Way Too Fast And Shakes. Started After Hitting A Rock.
Any way to get the throttle backed down. Seems to be fully automatic. Not sure how hitting a rock co...
Any way to get the throttle backed down. Seems to be fully automatic. Not sure how hitting a rock co...
(Posted by Shall2home 7 years ago)