Husqvarna MZ 5225 Support Question
Husqvarna MZ 5225 Support Question
Find answers below for this question about Husqvarna MZ 5225.Need a Husqvarna MZ 5225 manual? We have 2 online manuals for this item!
Question posted by Anonymous-111526 on May 17th, 2013
Sloopy Steering
If I look under the seat at the steering pivot arms going thru the upper and lower blocks you can see that the bearing is sloopy in the blocks, what do I need to replace to tighten up the steering. The mower has about 935 hours.
Thank you,
Jeff
Current Answers
Related Husqvarna MZ 5225 Manual Pages
Owners Manual - Page 3
...(ROPS 17 Controls 18 Control Locations 18 Steering Control Levers 19 Parking Brake 20 Throttle ...Belt 45 Cutting Blades 45
Blade replacement 46 Adjusting the Mower Deck 47
Leveling deck 47 Anti...-scalp rollers 48 Cleaning and Washing 49 Caster Wheels 49 Hardware 49 LUBRICATION 50 Lubricating the Cables 51 Front Wheel Mount 51 Front Wheel Bearings...
Owners Manual - Page 5
...characteristics and who operate this machine, it may cause damage to the new owner. Lawn mowers and all who are used improperly. INTRODUCTION
Congratulations
Thank you for the maintenance and ... must be potentially dangerous if used in accordance with special accessories provided by steering controls both contribute to maintain this machine on public roads.
This machine is...
Owners Manual - Page 10
... or fuel spillage before storage. Allow machine to cool before operating or storing the machine. Never take passengers
8011-520
WARNING! Do not allow the mower deck to occur. The engine exhaust contains carbon monoxide, which can cause buildup to plow leaves or other debris which can touch hot exhaust / engine...
Owners Manual - Page 17
...no jerky turns, starts or stops. • When mower is stopped, set brakes securely and use park brake.... the entire ROPS must be replaced. • Check all bolts including seat belt for correct torque before ...each use. • Check ROPS structure for damage before
each use. • ROPS bar is NOT intended for safe operation. • Watch where you are going...
Owners Manual - Page 18
...English-18 Choke control 7. Fuses
*As rated by the engine manufacturer.
8. Deck lift 11. Seat adjustment lever 12. The rider is made via a belt-driven hydraulic pumps. Control Locations
98
7... 4. Hour meter 13. Motion control levers 2. Using the left and right steering controls, the flow is regulated and thereby the direction and speed.
13
2
1 10 11
12
6
54...
Owners Manual - Page 19
... equal amount forward or backward, the machine moves in a straight line forward or backward respectively. Use extra care when using the two steering controls. Steering controls
8011-789
WARNING!
Steering Control Levers
The machine's speed and direction are in uneven positions when standing still or do not fit in the neutral position (N), the...
Owners Manual - Page 24
... pressure in both rear tires. Tracking Knob
If the mower is one hour before and one hour after which the seat can be moved backward or forward.
Lengthways adjustment
12....tuning adjustments so the machine tracks straight with the steering control levers in the seat), after the interval. CONTROLS
11. Seat Adjustment Lever
The seat can be adjusted lengthways. Tracking must be manually...
Owners Manual - Page 25
.... We also suggest first time users, or new users to Zero Turn mowers to become familiar with mower controls and zero turning capability, they return to their unique steering capabilities. Until operator becomes comfortable with the mower's movement on each side of the mower's movements is effected by alternating one lever slightly to an open...
Owners Manual - Page 26
...the locked (outer) neutral position.
Sit on .
• Both steering controls must be in the fuel tank.
• Adjust the seat to the locked position (transport position).
3. The following conditions must be...8226; The blade switch for engaging the mower blades must be depressed.
• The parking brake must be on the seat.
2. Raise the mower deck by pulling the lifting lever backward ...
Owners Manual - Page 27
operation
Disengage the mower blades by pressing the blade switch downwards. Move the steering controls outward to the middle position.
Press the control for disengaging the mower deck
8061-002
Move the throttle to the locked (outer) neutral position.
Place controls in neutral position
8061-012b
Set the throttle
8061-001
English-27
Owners Manual - Page 31
...mower deck by setting the cutting height pin into the desired hole. By moving both controls are
continuously variable using the two steering... seat without first setting the parking brake will shut off the engine.
2. operation
Running
1.
When the engine is near mower ...-011
Engage the mower deck and move the right control towards the neutral position. Move the steering controls to full ...
Owners Manual - Page 32
...achieved by moving one control backward (behind the neutral position) and carefully moving the other steering control forward from its neutral position. operation
the right wheel is absolutely necessary, pull drive
...not drive up or down hills with slopes greater than 10 degrees.
This may cause the mower to suddenly stop.
• To restart movement, release the parking brake.
• Pull ...
Owners Manual - Page 33
...thrown out by mowing often. For best cutting performance, grass over the mown area. Make sure the mower is cooled and the engine is off.
• Use compressed air to avoid collisions.
• ... the cool season and over 3" (76 mm) during the hot months. WARNING! For healthier and better looking lawns, mow often after each use. If the grass is not too long and dense, the driving speed can...
Owners Manual - Page 34
Always remove key when leaving the mower to stop position.
8061-013
Disengage the mower deck and move throttle to attain normal operating temperature before stopping it, if it has been worked hard.
Cut height selection
8061-011
English-34
Place controls in order to minimum
• Move the steering controls outward.
• Remove...
Owners Manual - Page 39
... that the engine stops if the mower blades are engaged and the driver temporarily moves off and repair the safety system before the steering controls can be turned
1/8 of these conditions is seated, tighten it is on. A new spark plug should be turned a ¼ turn from the seated position.
7. Replace the ignition cable.
If the machine...
Owners Manual - Page 55
Cause
• Blade switch is engaged. • Steering controls are incorrectly balanced. • The engine is loose. The engine seems weak.
• ... are loose. • The blades are not locked in the neutral
position. • Driver is not sitting in the driver's seat. • Parking brake is not activated. • Battery is dead. • Contamination in the carburetor or fuel line. &#...
Owners Manual - Page 66
... switch. 5. Fill in the seat. Connect the contact box to Technical Data. 3. Check that there is in the engine. 6. Check that the right amount of following the service schedule. Check the mower deck adjustment. 11. The safety switch for the parking brake. Check the idle speed 13. The need and advantages of oil...
Owners Manual - Page 76
...Husqvarna ground-engaging commercial equipment. REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS THE EXCLUSIVE...consumer mowing decks with product at the owner's residence.) EZ & MZ Zero Turn Riders: 1 year commercial warranty or 600 hours of...CARE EQUIPMENT: 2 Year Consumer Warranty: Automatic mower, all Residential Zero Turn Riders, all lawn, yard and garden tractors, all consumer chain ...
Parts Manual - Page 3
CONTENTS
FRAME 4 ENGINE PLATE 6 STEERING 8 IGNITION 10 PARKING BRAKE 12 HYDRAULIC PUMP-MOTOR 14 WHEELS 16 MOWER LIFT / DECK LIFT 18 MOWER DECK / CUTTING DECK 20
SEAT 22 DECALS 24 ACCESSORIES 26
Blower 26 Bagger 28 Chutes 30 Guard, Mount and Belt 32 Mulch Kit 34
NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED.
Parts Manual - Page 9
...5/16-18 HEX WHIZLK 30.. 539 990188 ��12 WASHER 5/16 SAE FLT
9 STEERING
ITEM PART NO. QTY. QTY. DESCRIPTION
1.. 539 132009 1 LEVER w/ GRIP RT 2.. 539...539 131518 4 BEARING, FLANGE 6.. 576 140301 2 LEVER, CONTROL 7.. 577 420001 2 LEVER, HANDLE 8.. 577 252401 2 SPACER, PIVOT CONTROL 9.. 539 102720 2 DAMPENER 10.. 577 251801 ���2 BLOCK, TRACKING 11.....
Similar Questions
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
Lawnmower Will Not Crank Or Turn Over After Shut Off. Help!!!
turned mower off was running fine. The battery is fine oil level is fine
turned mower off was running fine. The battery is fine oil level is fine
(Posted by therevhub 7 years ago)
Blades Will Not Engage Once The Mower Has Been Running For A While.
Once mower has been running and after emptying bags, the PTO pulled up will not engage blades. If it...
Once mower has been running and after emptying bags, the PTO pulled up will not engage blades. If it...
(Posted by abecker4 7 years ago)
Hi, My Mz Won't Start! Battery Checked, Sparks Plugs Checked..! Can't Locate
where the starter motor is.
where the starter motor is.
(Posted by bestmatecleaning 8 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)