Husqvarna MZ 6128 Support Question
Husqvarna MZ 6128 Support Question
Find answers below for this question about Husqvarna MZ 6128.Need a Husqvarna MZ 6128 manual? We have 2 online manuals for this item!
Question posted by bayoudale2 on August 17th, 2014
Husqvarna Mz6128 Electrical Issues.
I have a 1 1/2 yr. old MZ6128. After mowing for about 2 hours I turned off the machine for a break. After approx. 15 minutes I tryed to re-start the mower but only got a solenoid "clicking" sound. Upon further inspection I found that the positive battery cable was loose at the battery terminal. After tightening the cable I still had the solenoid click so i hooked up jumper cables to my truck. The cables immediatly began to heat up. Very hot. I disconnected jumper cables. I checked solenoid and starter for heat and found that both were very hot. I let everything cool down overnight. I tested the solenoid and it checks out OK. I checked the battery, it showed 80 % charge. Any idea what may have caused this? I am charging the battery now and have not tried to re-start yet.
Current Answers
Related Husqvarna MZ 6128 Manual Pages
Owners Manual - Page 4
...accessories contain lead and lead compounds, chemicals known to the State of sound mind and body and must allow only trained persons who understand these instructions..., some of its constituents, and certain vehicle components contain or emit chemicals known to operate the mower. Failure to follow cautious operating practices can result in serious injury to cause cancer and birth defects...
Owners Manual - Page 5
...Lawn mowers and all who are used improperly. Do not tow on mower. Read the contents carefully before transporting on the towed equipment. General
In this machine is a valuable document.
Travel slowly and allow children or others .
All other hazards. Unauthorized modifications to the new owner.
INTRODUCTION
Congratulations
Thank you for purchasing a Husqvarna...
Owners Manual - Page 6
... at the rear.
©2010 HTC.
INTRODUCTION
Good Service
Husqvarna's products are : 1. Stated on the plate, from the top are sold all over the world and only in service questions, warranty issues, etc., please consult the following professional:
This manual belongs to the machine with complete service. The manufacturer's type number (Model). 3. All...
Owners Manual - Page 13
...started when the driver's floor plate or any protective plate for the mower deck's drive belt is risk for the fuel to cool at least two (2) minutes before refueling.
• Never fuel the machine indoors.
• Never store the machine...sun may otherwise cause the fuel to refuel, minimize the risk of static electricity by touching a metal surface.
• Never fill containers inside a ...
Owners Manual - Page 14
...8226; Never make any fuel-soaked debris. The machine must not be driven with manufacturer's recommended parts, when necessary.
• Mower blades are sharp. WARNING! The battery contains .... Repair, if necessary, before storing.
• If the machine strikes a foreign object, stop and inspect the machine. Allow machine to be sure the equipment is in good condition and that ...
Owners Manual - Page 15
...
15
Risk of the starter circuit. The exhaust fumes contain carbon monoxide, an odorless, poisonous, and lethal gas.
• Stop to run the starter.
6003-009
Do not smoke when performing maintenance on the machine.
• Allow the machine to cool before starting.
• Never make a bridge short circuit across the starter relay to inspect...
Owners Manual - Page 16
...strength using a slow speed.
The machine is not administered immediately. Do not lift!
This mower is equipped with an internal combustion...Husqvarna dealer.
Escaping hydraulic oil under pressure can cause serious crushing injuries. WARNING! Activate the parking brake, turn off the fuel supply, and fasten the machine with a tow hitch, use extreme caution when towing. Towing
If machine...
Owners Manual - Page 25
... on the seat. 2. Activate parking brake before starting
8058-044
Starting the Engine
1. Set mower deck to the transport position by
locking the lift pedal fully forward. 3. OPERATION
Before Starting
• Read the sections Safety Instructions and Controls before starting the machine.
• Perform the daily maintenance before starting (see maintenance schedule in the Maintenance...
Owners Manual - Page 32
... be cut relatively high; Make sure the mower is cooled and the engine is attained.
Never drive the rider on top surface, engine and electrical components.
• When the mulching kit is used without negatively affecting the mowing result.
• The finest lawns are obtained by the blades. Mow slopes up and down, never side...
Owners Manual - Page 34
...intake Check the mower deck Check for loose hardware (screws, nuts) Clean under the mower deck Start the engine and blades, listen for unusual sounds Check for damage...Inspect muffler/spark arrestor
Daily
Before After
At least once each year
Maintenance interval in this manual ♦ = Not described in hours
50
250
500
●●●
1) First change after 8-10 hours...
Owners Manual - Page 35
...brake. • Place the Blade-switch in the disengaged position. • Turn the ignition switch to the engine manufacturer's manual
WARNING! maintenance
MAINTENANCE Check/adjust...(every 500 hours) Replace the hydraulic oil filter (every 500 hours) Dismantle and inspect starter 3) (every 500 hours) Check/adjust the mower deck Check the engine valve clearance 3) Perform the 500-hour service 3)
...
Owners Manual - Page 37
..., the driver must be started when:
1.
specified tires. Parking Brake
Visually check that no damage is found on . WARNING! Change the conditions and try again. Tire Pressures
Fill tire... foam filled tires will stop. The mower deck is not met, turn the machine off the driver's seat. Make daily inspections to ensure that prevents starting
8061-032
IMPORTANT INFORMATION
To be moved...
Owners Manual - Page 38
...belt and that the routing matches the routing decal.
7. Wrap the deck belt around the electric clutch pulley that may have accumulated around the electric clutch on a level surface. Check that there are not twists in installing the deck belt...
Deck Belt
Deck Belt Removal Park on the engine shaft and off the mower deck. Lower the deck into the lowest cutting position.
1.
Owners Manual - Page 39
...both fan covers. Belt Installation 1. V-belts
Check every 100 hours of the deck: 1.
Idler arm release placement 3. Tilt ...the 3/8" hole in the plate.
6.
Reinstall the fan shields.
8. Electric clutch 2. Use the breaker bar to access fan covers.
Remove the ... cracks in the extended position and allow removal of the mower: 3. Place the belt on a level surface. Replace and...
Owners Manual - Page 43
...mower deck, will cause premature failures. maintenance
Caster Wheels
Check every 200 hours.
Make it is cooled), before washing.
If wheels do not rotate freely, take the unit to clean the top side of the deck with normal water pressure. Inspect the entire machine... underside of mower deck. Tighten caster bolt. Avoid spraying engine and electrical components with ...
Owners Manual - Page 50
... clean the machine, especially under the mower deck. Touch up at least 10 minutes after adding the stabilizer so that may have become loose.
3. Change the engine oil; dispose of properly.
4. Turn over the .... Use a degreaser and warm water. Inspect the machine for worn or damaged parts and tighten any nuts or screws that it reaches the carburetor. Start the engine and allow it to the fuel...
Owners Manual - Page 52
... Brakes Front caster tires, smooth tread Rear tires, turf pneumatic Tire pressures
MZ6128 / 966502301
Briggs & Stratton 1) ELS
28 HP 2) Pressure w/ Oil Filter Min 87 octane unleaded (Max ethyl alcohol 10%, Max MTBE 15%)
5 gallons / 9 liters Air cooled
12v 15 amp @ 3600 rpm Electric
ZT-3400 Hydro Gear Dual levers, foam gripped
0-9 mph - 0-17.7 Km...
Owners Manual - Page 59
Check underside of deck. 5. Check safety system. 8. Check brake adjustment. Clean debris from mower. 2. Check/clean the engine's cooling air intake. 7. Inspect safety guards and shields. 11.
Check fuel system for leaks. 10. Check seat belt. 9. Date, mtr reading, stamp, sign
59 Check engine oil level. 3. SERVICE ...
Owners Manual - Page 62
... blade spindles 15. Inspect battery connections 24. Load test battery 25. Inspect frame 4. Inspect spark plug 10. Inspect deck idler pulleys 19. Change air filter 9. Check neutral position 23. Grease fittings (caster pivots and caster wheels) 2. Inspect dampeners 3. Check blade pitch 14. Inspect the clutch 24. Inspect hardware 6. SERVICE JOURNAL
Action
300-Hour Service...
Parts Manual - Page 25
...;�� DECAL, HEIGHT ADJUST
14.. 539 132187 ���1 ��� DECAL, SERVICE
15.. 532 429196 ���2 DECAL, HUSQVARNA
16.. 532 428676 ���2 DECAL, CROWN H
17.. 521 988002 1 DECAL, MZ6128
18.. 574 841103 1 DECAL, CONSOLE
19.. 532 124433 1 DECAL, 80 DBA
20.. 539 110279 1 DECAL, ECM...
Similar Questions
Location Of Battery On A Hu675fe Lawn Mower.
Where is the battery located on a Husqvarna HU675FE lawn mower
Where is the battery located on a Husqvarna HU675FE lawn mower
(Posted by wrileythree 3 years ago)
The Mower Will Start The Blades Will Turn But It Wont Drive
(Posted by erickmorris89 8 years ago)
Mz6128 Won't Start.
mz6128 would start and run but sometimes would not start when hot. Now it will not start at all. No ...
mz6128 would start and run but sometimes would not start when hot. Now it will not start at all. No ...
(Posted by scottdixiescott 9 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)
Mower Won't Start
Was mowing.....got off the mower & won't restart.
Was mowing.....got off the mower & won't restart.
(Posted by bobbirkimer 10 years ago)