Husqvarna MZ 6128 Support Question
Husqvarna MZ 6128 Support Question
Find answers below for this question about Husqvarna MZ 6128.Need a Husqvarna MZ 6128 manual? We have 2 online manuals for this item!
Question posted by JohnnyBarnett on April 26th, 2022
Ignition
I've charged the battery, says it's good but I turn key switch on and I get no lights or anything from the electronic ignition area, will not turn over, where should I start
Current Answers
Answer #1: Posted by SonuKumar on April 26th, 2022 8:06 AM
SonuKumar
Member since:
May 9th, 2021 Points: 16,673,060
Member since:
May 9th, 2021 Points: 16,673,060
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna MZ 6128 Manual Pages
Owners Manual - Page 3
... Ignition Switch 20 Fuses 21 Cutting Height Adjuster 22 Fuel Shut Off Valve 22 Refueling 23 OPERATION 24 Training 24 Steering 24 Before Starting 25 Starting the Engine 25
Jumper Cables 28 Running 29 Operating on Hills 30
Stopping the Engine 31 Mowing Tips 32 Manual Transport 33 MAINTENANCE 34 Battery 36 Safety System 37...
Owners Manual - Page 5
... machine is well anchored. Safety requires good judgment, careful use in accordance with delivery. ...Travel slowly and allow children or others .
Lawn mowers and all who are used improperly. Accident ...mow primarily large areas.
INTRODUCTION
Congratulations
Thank you must always ... to avoid jack-knifing. Make wide turns to change without notice.
Operating instructions for...
Owners Manual - Page 13
...start the engine near spilled fuel.
• Never use extreme care in handling gasoline. Gasoline is extremely flammable and the vapors are explosive.
• Extinguish all times until problem has been resolved.
• Check the fuel level before each use a nozzle lock-open flame, spark, or pilot light...of ignition.
...started when the driver's floor plate or any protective plate for the mower...
Owners Manual - Page 17
...belt-driven hydraulic pumps. Motion control levers 2. Hydro release levers
6. Right tracking bolt 12. Blade switch
12
11
10
10. Mass production engines may differ from the engine is regulated and thereby the ... CONTROLS
This operator's manual describes the Husqvarna Zero Turn Rider. Tracking knob 4. Height adjustment 13.
Fuel tank 5. Ignition switch 7. Hour meter 8.
Owners Manual - Page 19
...(1 bar).
1. Rotate the knob clockwise (as an empty parking lot or open , unobstructed area such as viewed from the operation position) to decrease speed. The flash duration is not tracking ... Rotate counter clockwise to increase the speed on and shut off automatically. Tracking
If the mower is one hour before and one hour after the interval. Hour meter Tracking adjustment
8058-...
Owners Manual - Page 20
Always set the parking brake before moving the mower. Turn the key clockwise to start and stop the engine.
Blade switch
Ignition Switch
The ignition key is placed on the left of the machine. CONTROLS
Parking Brake
The parking brake is found on the control panel and is used to start the engine. Ignition switch 20
8058-044 8058-043 8058-043 Pull...
Owners Manual - Page 21
.... RUN position For using "accessory", turn the key counter clockwise.
8058-046
Fuses
Fuses are flat pin fuses type as used in automobiles. Ignition switch -
They are two fuses with ratings and functions:
1. 20 A, Primary fuse
2. 7.5 A, Mower deck coupling
Ignition switch - CONTROLS
Release the key to the RUN position when the engine has started. There are accessed by tilting...
Owners Manual - Page 27
... valve.
Fuel valve in enclosed spaces. Turn to cause cancer, birth defects or other reproductive system damage. Set the desired engine speed with Electronic Fuel Management (EFM).
IMPORTANT INFORMATION
The Briggs & Stratton engine on this unit is equipped with the throttle. When the engine starts, immediately release the ignition key back to run at a moderate...
Owners Manual - Page 28
... end of the BLACK cable to the NEGATIVE (-) terminal of the fully charged battery. • Connect the other end of the BLACK cable to start other vehicle must also be a 12-volt negative grounded system.
Do not use the mower to a good CHASSIS GROUND on the mower with a 12-volt negative grounded system.
The other vehicles.
Owners Manual - Page 31
... the machine is standing still, activate the parking brake by depressing the blade switch.
8058-046
Disengage the mower deck and move throttle to the stop
8061-012
31 Move the throttle to the minimum position (tortoise symbol) Turn the ignition key to minimum
2. Move the steering controls outward.
6. Raise deck to transport position
8058...
Owners Manual - Page 32
... mower deck...lawn, clumps build, and the grass clippings fasten under the cowling.
• Hose the mower... Clear the lawn of the deck. The average lawn should be mowed...lawns are obtained by the blades. The lawn becomes more even and the grass clippings more than 10 degrees. For healthier and better looking lawns... results.
• Avoid mowing wet lawns.
OPERATION
Mowing Tips
• Observe...
Owners Manual - Page 33
... and out of the unit below the rear engine plate. No adjustments or maintenance should be carried out unless: • the engine stopped • the ignition key removed • the parking brake activated
2 1
When pushing or pulling the mower, engage the IZT (Integrated Zeroturn Transaxle) bypass linkages. IZT locked into the bypass setting.
Owners Manual - Page 35
...filter (every 500 hours) Dismantle and inspect starter 3) (every 500 hours) Check/adjust the mower deck Check the engine valve clearance 3) Perform the 500-hour service 3)
Daily Before After
... Engage the parking brake. • Place the Blade-switch in the disengaged position. • Turn the ignition switch to "OFF" position and remove the key. • Make sure the blades and all moving parts...
Owners Manual - Page 36
..., temperature and efficiency of the battery with grease or petroleum jelly 6. Disconnect BLACK battery cable first, then the
RED battery cable and remove the battery from the mower. 6. Lower seat. STANDARD BATTERY
12.6V 12.4V 12.2V 12.0V 11.8V
STATE OF
CHARGE
100% 75% 50% 25% 0%
APPROXIMATE BATTERY CHARGING TIME* TO FULL CHARGE AT 80OF / 27OC Maximum...
Owners Manual - Page 40
...sharpening. WARNING! Torque blade bolt to "OFF" position and remove the key. 4. Blade bolt (special) 3. Cutter housing
Blade attachment
IMPORTANT INFORMATION ...Engage the parking brake. 2.
Blades are well sharpened and not damaged. The service workshop should be replaced.
Turn ignition switch to 45-55 ft-lbs (60-75 Nm).
1. Make sure the blades and all spark plugs and...
Owners Manual - Page 44
... high grade molybdenum disulphide grease. Wipe away excess grease after cleaning, it must not be lubricated twice weekly. p See Engine Manufacturer's manual
General Remove the ignition key to avoid getting lubricant on the belts or the drive surfaces on the belt pulleys. Gasoline or other petroleum products must be replaced. Lubrication Schedule...
Owners Manual - Page 48
...8226; Faulty ignition system.
Engine seems weak.
• Clogged air filter. • Fouled spark plugs. • Carburetor incorrectly adjusted.
48 Problem Engine will not start. See Safety
...the battery terminal cable
connections. • Fuse blown. • Ignition system faulty. • Fault in the fuel. • Clogged air filter. troubleshooting guide
Cause
• Blade switch is...
Parts Manual - Page 3
CONTENTS
FRAME 4 ENGINE PLATE 6 STEERING 8 IGNITION 10 PARKING BRAKE 12 HYDRAULIC PUMP-MOTOR 14 WHEELS 16 MOWER LIFT / DECK LIFT 18 MOWER DECK / CUTTING DECK 20
SEAT 22 DECALS 24 ACCESSORIES
Blower 26 Bagger 28 Chutes 30 Guard, Mount and Belt 32 Mulch Kit 34
NOTE: ALL FASTENERS ARE GRADE 5 UNLESS OTHERWISE SPECIFIED.
Parts Manual - Page 7
... MUFFLER, BLK 19.. 539 101714 1 SOLENOID 20.. 539 101362 1 HOSE, DRAIN 21.. 539 101364 1 PLUG, OIL 22.. 539 912757 1 KEY ¼ SQ x 1¼ 23.. 539 102759 3 INSULATOR 24.. 539 101363 1 CLAMP 25.. 532 165931 2 GASKET, MUFFLER 26.. 539 ... ½" BELLEVILLE 52.. 539 104763 4 RETAINER, U TYPE 5/16-18 NOT SHOWN
576 413201 1 PIGTAIL, MZ
7
QTY. QTY. ENGINE PLATE
ITEM PART NO.
Parts Manual - Page 11
... TANK, FUEL LT 16.. 575 018101 1 FUEL CAP w /TETHER 17.. 539 103178 1 CAP, IGNITION SWITCH NUT 18.. 539 107765 1 HOSE, FUEL 19.. 539 932956 1 HOSE, FUEL 10" 20.. 576...BATTERY HOLD DOWN 29.. 539 102678 2 PLATE, TAPPED 30.. 539 107593 1 CONSOLE, RT 31.. 539 104974 1 CABLE, POSITIVE 31" 32.. 539 102757 1 CABLE, POSITIVE 8" 33.. 539 107645 1 CABLE, NEGATIVE 32" 34.. 574 455501 1 KEY...
Similar Questions
What Is A 2012 Husqvarna Hu 775l Lawn Mower In Very Good Condition Worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
What is a 2012 Husqvarna HU 775L lawn mower in Very good condition worth ?
(Posted by kpcastles 7 years ago)
The Mower Will Start The Blades Will Turn But It Wont Drive
(Posted by erickmorris89 8 years ago)
Husqvarna Mz 6128 20 Amp Fuse Keeps Blowing
Every time you would turn the Key the 20 Amp fuse blows. have replaced the switch and have check all...
Every time you would turn the Key the 20 Amp fuse blows. have replaced the switch and have check all...
(Posted by JonathanWilliams2961 9 years ago)
My Husqvarnarz4623 Lawn Mower
My husqvarna lawn mower will not start. It wont even try to turn over or click.
My husqvarna lawn mower will not start. It wont even try to turn over or click.
(Posted by teresaandbryancates 9 years ago)
Mower Won't Start
Was mowing.....got off the mower & won't restart.
Was mowing.....got off the mower & won't restart.
(Posted by bobbirkimer 10 years ago)