Husqvarna SRD17530 Support Question
Husqvarna SRD17530 Support Question
Find answers below for this question about Husqvarna SRD17530.Need a Husqvarna SRD17530 manual? We have 1 online manual for this item!
Question posted by dhilgemann on July 11th, 2022
Rear Axle Won't Engage.
The transmission switches gears just fine, however the rear axle spins slowly and the tires have free travel so the mower will not move with weight on it. I ensured that the wheel keys are in place and that the drive belt is in good shape and moving fine. Not sure how to engage the axle? Must be something I am missed.
Current Answers
Answer #1: Posted by hzplj9 on July 11th, 2022 12:15 PM
hzplj9
Member since:
June 25th, 2012 Points: 4,875,980
Member since:
June 25th, 2012 Points: 4,875,980
Each wheel will have a key which holds the wheel onto the shaft. If any of these keys are missing the wheel will turn when off the ground. However as in a car the device has a differential and it will drive the easiest wheel first. So that wheel will be the one that has the fault. Remove each wheel and check that there are links to hold the wheel on. They are called a 'woodruff key' which is a piece of metal shaped like a small rectangle which may also have a curved side. Refer to page 25 of the PDF downloadable here. The likely event is either the wheel has been removed and the key lost or has broken. View the picture.
https://www.manualslib.com/manual/636380/Husqvarna-Srd17530.html
I have added a video of how the drive works.
www.youtube.com/watch?v=SOgoejxzF8c
Hope that helps you solve your problem.
Answer #2: Posted by SonuKumar on July 11th, 2022 9:57 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,673,770
Member since:
May 9th, 2021 Points: 16,673,770
https://www.youtube.com/watch?v=5NYqIAeKt38
Why does my hydrostatic transmission won't move?
By far, the most common reason for hydrostatic transmission failure is old hydraulic fluid. John Deere states that "Operating outside of the recommended oil air temperature range may cause premature hydrostatic transmission failure." Oil must be changed when its anti-foam additive decays.
https://poweredoutdoors.com/common-husqvarna-lawn-mower-problems-solutions/
https://www.fixya.com/support/t3066956-transaxle_not_working
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Husqvarna SRD17530 Manual Pages
Owners Manual - Page 3
...lawn mower... free...place...Mower blades are sharp. Gasoline is clear of the fuel tank or
container opening at the hitch
point.
• Follow the manufacturer's recommendation for weight
limits for
towing. Stop machine if anyone enters the area. Never carry passengers. If the tires lose traction, disengage the blades and proceed slowly...Ensure...weight of control.
•
• Travel slowly...
Owners Manual - Page 6
... and year indicated on seat to engage pads in slots and pull seat towards rear of seat to tractor.
LOWER STEERING SHAFT
ADAPTER EXTENSION SHAFT
LABEL
Fig. 1
TO INSTALL STEERING WHEEL (See Fig. 2)
ASSEMBLE EXTENSION SHAFT AND BOOT • Slide extension shaft onto lower steering shaft. • Place tabs of carton. TOOLS REQUIRED FOR...
Owners Manual - Page 8
...end of front bagger frame. • Reinstall (1/4"-20) lock nuts (4) and tighten until it locks into place.
1
2
Fig. 9
HORIZONTAL ADJUSTMENT • Loosen nuts on carriage bolts (1) to slide forward or ... fully
seated. If necessary, this manner. • Remove bagger assembly. NOTE: Verify rear plastic bag shield (6) is approximately 0.2" (5.1mm). Move as needed . Move as needed...
Owners Manual - Page 9
... be shut off and parking brake engaged.
12
4 3
3 Fig. 13
5
9 Verify that are shown for replacing motion and mower blade drive belts in the Service and Adjustments section of this manual. CHECK BRAKE SYSTEM
After you . • Setting may be properly leveled. CHECK TIRE PRESSURE
The tires on side of tires. Fig. 12
NOTE: If the bagger...
Owners Manual - Page 10
... them before you start the engine.
✓ Be sure brake system is properly leveled side-to-side/ front-to-rear for best cutting results. (Tires must be properly inflated for leveling).
✓ Check mower and drive belts. Be sure they are working properly (See the Operation and Maintenance sections in safe operating condition. ✓ Be...
Owners Manual - Page 11
...serious injury and/or property damage. REVERSE
NEUTRAL
HIGH
LOW
CHOKE
FAST
SLOW
IGNITION SWITCH
P
ENGINE OFF REVERSE OPERATION
SYSTEM (ROS)
ENGINE ON
ENGINE START
PARKING BRAKE
PARKING...
MOWER HEIGHT
15
MOWER LIFT
15
ATTACHMENT
ATTACHMENT
CLUTCH DISENGAGED CLUTCH ENGAGED DANGER, KEEP HANDS
AND FEET AWAY
KEEP AREA CLEAR
SLOPE HAZARDS
(SEE SAFETY RULES SECTION)
FREE WHEEL ...
Owners Manual - Page 12
... for starting the engine.
(C) PARKING BRAKE - Used to engage the mower blades, or other attachments mounted to your tractor to your ...mower or other attachments mounted to familiarize yourself with your tractor.
(F) IGNITION SWITCH - H
D
E
B G
F
A
C
J
Fig. 14
Our tractors conform to raise and lower the mower or other powered attachment while in reverse.
(H) LIGHT SWITCH...
Owners Manual - Page 13
...'s operating efficiency. • Full speed (fast) offers the best mower performance. GROUND DRIVE -
• To stop engine when stopping tractor on grass areas.
tion and hold tractor securely. C
B
Fig. 15
STOPPING (See Fig. 16)
MOWER BLADES • To stop mower blades, place attachment clutch control
in "ENGAGED" position
and release pressure from clutch/brake pedal. OPERATION...
Owners Manual - Page 14
... changing gears. Be sure you restart movement. • To restart movement, slowly release parking brake and clutch/brake pedal. • Make all turns slowly. CAUTION: Do not operate the mower without either the entire grass catcher, on a flat level surface. • Adjust mower to desired height.
Any attempt by engaging attachment clutch
control. TO ADJUST MOWER CUTTING...
Owners Manual - Page 15
... ignition key is placed in ...Ensure bagger is down and behind before backing. • Move gear shift lever to reverse (R) position and slowly
release clutch/brake pedal to start movement. • When use gasoline near an open flame.
15 Tires...engaged while mowing is strongly discouraged.
Turning the ROS "ON", to allow mower... Raise attachment lift to travel in reverse unless absolutely...
Owners Manual - Page 18
...mower to highest position to allow access to open .
• Recharge at highest speed in all tires. (See the sides of tires for proper PSI.)
• Keep tires free...the manufacturer of your tractor. IMPORTANT: To ensure proper assembly, center hole in the seat... switch in the ROS "ON" position and the attachment clutch engaged,....)
TIRES
• Maintain proper air pressure in highest gear on...
Owners Manual - Page 20
..., etc. Debris can restrict clutch/brake pedal shaft movement, causing belt slip and loss of all gasoline,
oil, etc. • ...STEERING SYSTEM, DASH, FENDER AND MOWER NOT SHOWN
Fig. 30 • Keep finished surfaces and wheels free of drive. Use compressed air or a ...sections. • Place new fuel filter in position in engine or transmission will not run properly using a garden hose or pressure ...
Owners Manual - Page 21
... engine pulley (M) and belt keepers (G). • Remove cable (P) by depressing tab (L). • Remove clutch cable spring (Q) from idler arm (R). • Disconnect front link (E) from mower - HAVE A TIGHT GRIP ON LIFT LEVER WHEN CHANGING POSITION OF THE LEVER.
• Slide mower out from rear mower bracket (D) -
TO INSTALL MOWER (See Fig. 31 - 36)
Ensure tractor is centered under...
Owners Manual - Page 22
... LINKS (C) - Work from left side of link assembly through front hole in arm over pin (D) on rear mower bracket and secure with washer and retainer spring. IMPORTANT: CHECK BELT FOR PROPER ROUTING IN ALL MOWER PULLEY GROOVES. • Raise attachment lift lever to highest position. M
C
D
Fig. 33 • ATTACH FRONT LINK (E) -
Position hole in...
Owners Manual - Page 23
... tires properly inflated, park tractor on tires.
PRECISION SIDE-TO-SIDE ADJUSTMENT (See Fig. 38)
• With all tires properly inflated and if your lawn appears
unevenly cut, determine which side of mower is...is 1/8" to 3/8" lower than the rear
tip, go to the front of the adjustment nut will change
mower height about 3/16".
• Test your lawn and lead you are satisfied with heavy...
Owners Manual - Page 24
... from stationary idler (A) and clutching idler (B).
• Pull belt slack toward rear of manual). You may be serviced. Park the tractor on level surface.
Carefully work belt down and engage parking brake. • Place gear shift lever in this section of tractor. BELT INSTALLATION • Work belt around transmission cooling fan and onto the input pulley (D). Carefully remove...
Owners Manual - Page 25
...left to allow
wheel removal (rear wheel contains a square key -
however, ...axle cover. NOTE: When the tractor rear wheels move mower deck height to good chassis ground, away from both batteries. Always wear eye protection when around batteries. THE OTHER VEHICLE MUST ALSO BE A 12 VOLT SYSTEM.
Tire sealant also prevents tire dry rot and corrosion. SERVICE AND ADJUSTMENTS
TRANSAXLE GEAR...
Owners Manual - Page 28
... section. 3. Carburetor out of grass, leaves and trash
under mower. 4. Clean/replace air filter. 5. See "To Adjust Carburetor...out of adjustment.
1. Bad spark plug. 3. Attachment clutch is engaged. 3. Fill fuel tank. 2. Recharge or replace battery. 4. Stale...air filter. 6. Loose or damaged wiring. 7. Faulty ignition switch. 8. Dirty/clogged muffler. 13. Adjust throttle control. 3....
Owners Manual - Page 29
... blades listed in parts manual.
11. Replace mower drive belt.
9. Blades improperly installed.
9. Clogged mower deck vent holes from
buildup of grass, leaves, and trash around mandrels.
1. Faulty light switch. 4. Check wiring and connections. 5. Replace regulator. 4. Replace alternator.
1. Install axle key at rear wheel. If not corrected, contact an authorized service...
Owners Manual - Page 32
...Mowers, High Wheel Trimmer
Engine*
*
Battery
1 Year Pro-rated
Other Non-Expendable Components
3 Years
Hovering Trimmers
Engine*
*
Other Non-Expendable Components
2 Years
Front Mounted Deck Riders
Engine*
*
Transmission... Lawn Tractors:
Frame, Chassis, Front Axle
5 Years
No Warranty
Engine*
*
*
Transmission (if made by Husqvarna/Peerless)
3 Years
No Warranty
Transmission ...
Similar Questions
Husqvarna Lgt2654 Riding Mower
what would cause the mower to shut down when the pto is engaged? have already replaced the pto and a...
what would cause the mower to shut down when the pto is engaged? have already replaced the pto and a...
(Posted by markw1960 2 years ago)
Changed The Drive Belt. Once I Engage The Belts I Cannot Pull The Hills That U
i cannot pull the hills i used to pull it a husqvarna yt48xls.
i cannot pull the hills i used to pull it a husqvarna yt48xls.
(Posted by Roachmanfarms23 3 years ago)
Pto Mower Blade Won't Engage
PTO does not engage the mower blades I ran over some rocks and it just stopped working
PTO does not engage the mower blades I ran over some rocks and it just stopped working
(Posted by jamesdecastro70 7 years ago)
My Husqvarna Srd17530 Just Clicks When I Turn The Key
Fuse looks o.k.?
Fuse looks o.k.?
(Posted by pamelalcorbin 10 years ago)
Husqvarna Srd17530
SRD17530 can deck be raised above 3 1/2". It is scalping my lawn. Deck was level and matched spec.s ...
SRD17530 can deck be raised above 3 1/2". It is scalping my lawn. Deck was level and matched spec.s ...
(Posted by goreydan 11 years ago)