KitchenAid KDRS407VSS Support Question
KitchenAid KDRS407VSS Support Question
Find answers below for this question about KitchenAid KDRS407VSS.Need a KitchenAid KDRS407VSS manual? We have 3 online manuals for this item!
Question posted by linda56976 on July 20th, 2015
How Can I Calibrate My Kitchenaid Kdrs407vss Oven
My KitchenAid KDRS407VSS electric oven runs hot. It was hot by about 25 degrees F. but yesterday it was 75 degrees over the set level of 325 degrees. (The thermometer showed 400 degrees F. )Can I calibrate this oven myself? I have an extended warranty.
Current Answers
Answer #1: Posted by Odin on July 20th, 2015 4:59 PM
Odin
Member since:
April 10th, 2010 Points: 41,236,650
Member since:
April 10th, 2010 Points: 41,236,650
You question implies that your (extended) warranty is in force. If so, let KitchenAid take care of it. (Call the company using this customer service information: https://www.contacthelp.com/KitchenAid/customer-service.) There are various possible causes of this malfunction, of which this one is the most common.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related KitchenAid KDRS407VSS Manual Pages
Dimension Guide - Page 1
... both sides of range's final location. q A circuit breaker is recommended. 30", 36", and 48" Professional Dual Fuel Convection Ranges
PRODUCT MODEL NUMBERS
KDRS407VSS KDRS462VSS KDRS463VSS
KDRS467VSS...This range is factory set for planning purposes only. This oven has been designed in the "Product Dimensions" section of electrical connection you must be connected to the range location...
Dimension Guide - Page 2
...25" (63.5 cm) countertop; Specifications subject to change without notice. Cabinet Dimensions
Cabinet opening dimensions shown are for dimensional clearances above the range, follow the range...D **
B
C E
D
O***
F
A F
H
I
J
Electrical
installation
K
area*
E
I G
L
N
M
J
Gas installation area...oven door protrudes 1⁷⁄₈" (4.8 cm) beyond 24" (61.0 cm) base cabinet.
Installation Guide - Page 5
...the cooktop for elevations above the range.
■ It is recommended that the materials used . Location Requirements
IMPORTANT: Observe all electrical connections be used will not discolor...setting on the model/serial rating plate. See "Gas Supply Requirements" section.
■ Contact a qualified floor covering installer to check that a microwave hood combination be available.
This oven...
Installation Guide - Page 6
... top of oven door protrudes 1⁷⁄₈" (4.8 cm) beyond 24" (61.0 cm) base cabinet. clearance from both sides of range to side wall...cm) depth with 25" (63.5 cm) countertop; front of range, see NOTE* C. 35¾" (90.2 cm) cooktop height when setting on 48" (121.9 cm) models
F. 6" (15.2 cm) min. For minimum clearance to backwall. 6
A F
H
I J
Electrical
installation
K
area...
Installation Guide - Page 7
... ranges.
If you have questions about your water pressure, call a licensed, qualified plumber.
A copy of the range needs to setting the range in extreme hot ...Hot Cold
Filter assembly location
Water Supply Requirements
A cold water supply with water pressure between 30 and 120 psi (207 and 827 kPa). Electrical Requirements - Do not use a 50-amp rated cord with the rating of the oven...
Installation Guide - Page 9
... can be level with your range and see the "Gas Conversions" section.
All strains must be level and in the...oven door frame has information on longer runs may be located in line. If the types of gas listed do so can be used for connecting range...parts for connection to the range. Gas supply line B. To range
†®TEFLON is factory set for use with American National Standard, ...
Installation Guide - Page 10
...304.8 m). Set range on the model/serial rating plate are not sure about 3" (8.0 cm) and move and install range. Line pressure testing at ½ psi gauge (14" WCP) or lower The range must be isolated...is used . Push down on the floor behind range. Kickplate B. B
A
A. Excessive Weight Hazard
4. Remove oven racks, grates and parts package from the gas supply piping system during any ...
Installation Guide - Page 15
... water column. H. Route flexible codes approved water supply line through undersink cabinet and oven cabinet cutout.
5. B
F
C
D
A
E
A. Oven copper tubing F. Check all gas connections. Failure to the adapters. Assemble flexible connector ...use .
Open valve
15 Water supply tubing to range
Sink
Water supply connection
Yellow WATER
IN
Shutoff valve
Water supply tubing to the smaller...
Installation Guide - Page 16
...
1. Check that the range is adequate as long as it into the slots. For further information, please refer to assure correct placement of the grill basin and hook it conforms to slide into the appropriate outlet (see the "Electrical Requirements" section).
5. 2. If bubbles appear, a leak is not level, adjust the leveling rods. Cut and...
Installation Guide - Page 18
...valve stem. 7. Put a control knob onto the valve stem of the range that burner caps are properly positioned on each control knob to light the ... blown. ■ Check that the gas shutoff valves are set to Off. NOTE: Make sure to adjust. Upper flame B. Flame .... 5. Open the oven door and remove the 2 screws on each side of the burner you want
to leave oven door open "
position...
Installation Guide - Page 19
... are now installed. To set it back into place. If you purchased your tools. 3.
Single flame burner adjustment screw (on . 2. Remove the control knob.
13. A
B
A. Front lip of Oven(s) 1.
Kickplate B. Shoulder screw mounting hole
Complete Installation
1. Dispose of your range.
19 Turn power on right side of the range.
3. When oven has been on the...
Use & Care Guide - Page 5
... OF THE APPLIANCE, VERIFY THE REINSTALLATION OF THE RANGE INTO THE ANTI-TIP DEVICE PROVIDED, AND EXTEND LEVELING FEET AFTER RETURNING THE RANGE TO THE ORIGINAL INSTALLED POSITION.
■ WARNING:...electrical shock, injury to
heat or warm the room. Areas near surface units may become hot enough to children in an oven or near units until they are dark in or on the backguard of the range...
Use & Care Guide - Page 6
... does not extend over adjacent surface units.
■ Clean Cooktop With Caution - No commercial oven cleaner or oven liner protective coating of any part of local codes, with Canadian Electrical Code. The range, when installed, must be used to a hot surface.
■ Use Care When Opening Door - among these surfaces are dark in accordance with...
Use & Care Guide - Page 16
... Celsius conversion
2
Tones On/Off
3
Tones High/Low
4
Cooking Time Completion Tones On/Off
6
Oven Temperature Calibration
7
Sabbath Mode
Fahrenheit and Celsius -
Control Lock
The Control Lock feature shuts down the set in use of time. 3. Repeat to set using the timer for functions other than cooking.
NOTE: The Timer does not start the...
Use & Care Guide - Page 17
...°F (107°C)
4
250°F (120°C)
17 Oven Temperature Calibration Option 6
IMPORTANT: Do not use a thermometer to measure oven temperature because opening the oven door during cycling may cook faster or slower than one time only setup.
1. The oven provides accurate temperatures; When the oven door is set between 170°F and 500°F (77°C and...
Use & Care Guide - Page 26
...oven cools. At high temperatures, foods react with a damp sponge before running cycle. OVEN DOOR EXTERIOR
STAINLESS STEEL
To avoid damage to stainless steel surfaces, do not bang grates and caps against each other knobs have temperature settings... damaging. ■ KitchenAid® Stainless Steel Cleaner and Polish Part Number
4396920 (not included) or KitchenAid® Stainless Steel Wipes...
Use & Care Guide - Page 28
... trained repair specialist.
See "Cooktop Controls" section.
■ Is the range level? See "Electronic Oven Control" section.
■ Has a delay start been set ? See "Control Lock" section.
■ Is the Sabbath Mode set to the locked position. See "Oven Temperature Control" section. Display shows messages
■ Is the display showing a letter followed by a number reappears, call for...
Use & Care Guide - Page 29
... has a delay start been set? See "Timed/Delay Cooking" section.
■ On 48" (121.9 cm) ranges, is one oven is level in your telephone directory Yellow ...Oven peeking releases oven heat and can result in a reliable cookbook.
■ Is the proper oven temperature calibration set ? If you need replacement parts If you can write to KitchenAid with the same precision used ? KitchenAid...
Use & Care Guide - Page 30
...KitchenAid Canada designated service technicians are trained to obtain service under this appliance is required to fulfill the product warranty and provide after-warranty service, anywhere in materials or workmanship:
■ Electric... cm) Ranges and Cooktops Order Part Number W10225948
KitchenAid® Architect® II 30" (76.2 cm) Handle Kit Order Part Number W10188342
KitchenAid® ...
Use & Care Guide - Page 31
...OVEN CAVITY AND DOORS
In the second through due to defects in materials or workmanship. Consumable parts are excluded from unauthorized modifications made to correct house wiring or plumbing.
2. Damage resulting from your home of consumables or cleaning products not approved by KitchenAid.
5. Major appliances with electrical... be borne by calling KitchenAid. Repairs when your major...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
My microwave oven will not run
... Please enter at 100% cooking power. Extended warranty information - See "Child Lock" section below . Child Lock (on some models, is locked, only the Vent Fan and Light pads will not run Why won't my microwave oven run? Touch and hold Cancel (on some models) or Start (on some models) set correctly? Is a spacer (on other... -
Extension cord to power Immersion Blender
Answers others found helpful Extended warranty information - Extension cord to power Immersion Blender Can I use . Please follow these recommendations; KitchenAid products The marked electrical rating of the extension cord should be arranged so it will not drape ...tripped over unintentionally. An extension cord can be at least as great as the electrical rating of the appliance. -
Adjusting Pro Line Coffee Grinder Burrs
... to provide maximum fineness will increase throughout the grinding range and the finest level may wish to adjust the cutting burrs to provide...may need to be visible once the grind control dial is now calibrated to provide maximum fineness. Using a 5⁄32-inch (4 mm... Recall Information PRO LINE™ Empty the bean hopper, then run the mill a few seconds to the burrs, readjust the burrs...
Similar Questions
Self Clean Cycle Ran; Now Oven Doesn't Work
This is the second time this has happened . First time it was under warranty; no such luck this time...
This is the second time this has happened . First time it was under warranty; no such luck this time...
(Posted by Feileacan42 7 years ago)
Remove Splash Guard On Model Kdrs807sss
If I removed the splash guard for looks, would that be a problem. How would it look from top?
If I removed the splash guard for looks, would that be a problem. How would it look from top?
(Posted by mjfm5 9 years ago)
Kdrs407vss Range
Is this model a side in or a freestanding range?
Is this model a side in or a freestanding range?
(Posted by yolanda33039 12 years ago)
Has Anyone Had Any Problems With This Kitchenaid Duel Fuel Range?
The touch panel is on the same plane as the cooking surface, so spills will get on it. I can run my ...
The touch panel is on the same plane as the cooking surface, so spills will get on it. I can run my ...
(Posted by dcarlick 12 years ago)
How Do You Calibrate The Oven? It Won't Go Over 174*
(Posted by Rfamlee5 13 years ago)