KitchenAid KUDC10IXSS Support Question
KitchenAid KUDC10IXSS Support Question
Find answers below for this question about KitchenAid KUDC10IXSS.Need a KitchenAid KUDC10IXSS manual? We have 4 online manuals for this item!
Question posted by Davidbueche on May 23rd, 2020
No Power To Control Panel
I have a kitchenaid kudc10fxss1. Checked power coming into control board & I have 120v. I check fuse & have continuity What should I check nex
Current Answers
Answer #1: Posted by INIMITABLE on May 23rd, 2020 12:09 PM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,082,030
Member since:
April 3rd, 2020 Points: 2,082,030
Possible SolutionsIs the oven control set correctly?
Refer to your Use & Care Guide for more information.
Is the control lock on?
Set the control(s) correctly.
Refer to the Use and Care Guide for detailed control operation instructions.
If you would like to download or view product literature for your appliance, please visit our Manuals and Literature page.
Has a household circuit breaker tripped or fuse blown?Check to make sure a household fuse has not blown or that a circuit breaker has tripped. Reset the circuit breaker or replace the fuse if necessary.
- Power unit down by turning off the circuit breaker(s) for thirty (30) seconds.
- Power unit up by turning on the circuit breaker(s).
- If the problem continues, contact a licensed electrician.
If not resolved, please note the following:
- Disconnect the power cord and/or turn off the circuit breaker that controls the appliance.
During a power outage, if there was an unexpected amount of power supply line "noise" that the control detected as incorrect voltage amount, the control could display the F9 or F9 E0 error code. Also, if any keys were pressed before the 10-second delay interval on power-up, this could cause the F9 or F9 E0 to appear.
If a recent power outage has occurred, turn off the household circuit breaker for the range for one (1) minute. Then reset the circuit breaker and monitor the range for one (1) minute to ensure the error code does not display again. Verify range operation is normal.
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related KitchenAid KUDC10IXSS Manual Pages
Dimension Guide - Page 1
...30" (834.37Dc"m)
3 "-4 " (8.8 cm -10.6 cm)
3" (9.4 cm)
A.
Copper wire only. A timedelay fuse or circuit breaker and separate circuit is 28" (70 cm).
(532.31"cm)
Because Whirlpool Corporation policy includes a continuous commitment to change without notice. ® Undercounter Dishwasher
PRODUCT MODEL NUMBERS
KUDC10FX KUDC10IX KUDE20FX KUDE20IX KUDE40FX KUDE50CX KUDE60FX KUDE60HX...
Installation Guide - Page 2
... Line 8 Install Drain Hose 10 Install Moisture Barrier 11 Prepare Dishwasher 11 Make Power Supply Cord Connection 12 Determine Cabinet Opening 13
Installation Instructions (cont.) Install the Door Handle 14 Custom Panel Dimensions 14 Install Custom Panel 15 Choose Attachment Option 17 Move Dishwasher Into Cabinet Opening 17 Connect to Water Supply 19 Connect to...
Installation Guide - Page 3
... must purchase screws locally. Check existing electrical supply. It is a registered trademark of Saturn Fasteners, Inc. INSTALLATION REQUIREMENTS
Tools and Parts
Gather the recommended tools and parts before starting installation.
For Direct Wire: use UL Listed/ CSA Approved strain relief
hole
For Power Supply Cord: use with
dishwasher
MSailkveersuGrreeaelnl these parts are used...
Installation Guide - Page 12
... Option B, proceed to "Determine Cabinet Opening," to continue with power supply cord kit) rated to dishwasher.
Do not use ? Do not remove tech sheet from access panel.
3 Remove terminal box cover
What type of electrical connection will you use door panel as a worktable without first covering with the power supply cord kit.
12 Make sure screwheads...
Installation Guide - Page 13
...in terminal box. Gently tug on strain relief
Electrical Shock Hazard Electrically ground dishwasher. Visit www.kitchenaid.com under FAQ tab. Close cover ensuring wires are tucked inside terminal box.....
13
Measure height of cabinet opening
NOTE: Twist on wire connectors (included with power supply cord kit). Connect ground wire
Tighten strain relief screws to secure cover. Connect ...
Installation Guide - Page 14
... Floors-Add
shims as needed
(140."1 cm)
(52c"m)
(7 cm)
14
Built-up to bring the dishwasher up floors: If the kitchen floor is higher than the cabinet opening's floor - Place handle on mounting studs with control panel on the top
23⁵⁄₈" (60 cm)
*29 76 cm)
* This dimension is for...
Installation Guide - Page 15
... not drill deeper then ⁵⁄₈" to the backside of the custom panel with control panel on both sides and all edges of the wooden panel inside dotted line. Pilot hole depths given are used, it to keep from moisture.
Stand dishwasher upright
2 Attach handle
6" (15.2 mm)
Install the custom hardware handle(s) on the...
Installation Guide - Page 19
... side of the unit.
7 Align front of dishwasher
with front of cabinet doors
Align front of dishwasher door panel with front of tub. Using pliers, check the tightness of dishwasher. Do not kink or pinch water line, drain hose, power supply cord or direct wire between dishwasher and cabinet. Check that leveling legs are firmly against the floor...
Installation Guide - Page 20
Visit www.kitchenaid.com/watersupply under drain hose to catch any water in terminal box. Make Direct Wire Electrical Connection
NOTE: If the power supply cord ...Check for leaks
Place paper towel under FAQ tab. Place the small green drain hose clamp onto the small end of dishwasher tub.
Owner must purchase a ⁷⁄₈" screw-in Cabinet Opening" section. Visit www.kitchenaid...
Installation Guide - Page 21
WARNING
Electrical Shock Hazard Electrically ground dishwasher. Visit www.kitchenaid.com/electrical under the washer. Connect wires black to black and... to green ground connector in death, fire, or electrical shock.
2 Direct Wire-Connect
ground wire
Wiring configuration
Power supply wire: white black
ground wire
Terminal box wire: white black ground connector
If needed, see website for ...
Installation Guide - Page 22
..., and place towel over pump assembly and lower spray arm of dishwasher. Check that dishwasher is not equal, loosen bracket screws secured and shift tub. Secure Dishwasher in Cabinet Opening
1 Double-check dishwasher
alignment in cabinet opening.
2 Remove lower dish rack
and place towel
3 Secure dishwasher
screw to side cabinet
NOTE: Do not drop screws into pump...
Installation Guide - Page 23
... obstacle.
4. Make sure the vinyl pad is facing up and hold the side panels down .
3. Visit www.kitchenaid.com/anchoring under FAQ tab. Complete Installation
1 Reinstall access panels
Insulation (on some models)
Access panel
Lower panel
Insulation
Grounding clip
23 Remove the bottom sound pad from dishwasher. Slowly slide the pad toward the back of the...
Installation Guide - Page 24
.... Reconnect Power
1 Reconnect power
Reconnect electrical power at the fuse box or circuit breaker box. Using a Phillips or ¹⁄₄" screwdriver, reinstall the screws through the holes in the access panel and the slots in death, fire, or electrical shock.
1 Power supply cord-Plug into
a grounded 3 prong outlet
Check that power supply cord does not touch dishwasher motor...
Installation Guide - Page 25
...set correctly to start the
dishwasher? • Is the water turned on? Check that dishwasher is water in Canada, call .
• Has the circuit breaker tripped or the house fuse blown?
• Is ...good drying performance and controlling hard water deposit buildup. Check that there is working properly, disconnect power or unplug dishwasher and see "If Dishwasher Does Not Operate" section.
Use & Care Guide - Page 2
...
WARNING: When using the dishwasher, follow instructions. For plastic items not so marked, check the manufacturer's recommendations.
■...instructions. and
2) Load sharp knives with controls.
■ Use the dishwasher only for its intended function.
■...alert symbol.
Always read and obey all enclosure panels are marked "dishwasher safe" or the equivalent. These words mean:...
Use & Care Guide - Page 4
... the dishwasher to grind food particles, which are flushed out the drain at the end of each cycle.
Lower spray arm
Overfill protection float
Food disposer-based wash system has four stainless steel blades to grind food particles, which are flushed out the drain at the end of each cycle."
Control panel
TOP...
Use & Care Guide - Page 10
...a cycle or the power is Started" sections.
Open the door slightly to Step 2).
2. Changing A Cycle After Dishwasher Is Started
1. Select ...control.
10
5. Check if Add a Dish indicator is finished, the Sanitized indicator glows. If detergent has not yet been used to stop the cycle. To cancel a wash cycle after 2 minutes. Dishwasher Feedback Section
CONTROLS AND CYCLE STATUS
CONTROL...
Use & Care Guide - Page 11
...raise or lower the top rack to keep the ProScrub® spray jets from the dishwasher.
1.
Adjusters are located on each side of the top rack.
Mix silverware types ... position and level.
NOTE: If your silverware separated for best cleaning results. Dishwasher Features
Your KitchenAid dishwasher may have 1 or 2 rows of flexible tines located in the 60°
angled position ...
Use & Care Guide - Page 13
...loading as cookie sheets, cutting boards, or large containers, etc., that typically run... dishwasher.
In the U.S.A., www.kitchenaid.com In Canada, www.kitchenaid.ca
PROBLEM
SOLUTION
DISHWASHER...Check for the dishwasher to near the dishwasher. Be sure your dishwasher is not part of a service call for improved results.
13 If it has not completed, you lift off the water supply and power...
Use & Care Guide - Page 16
... when it was purchased: nylon dish racks and electronic controls. Any food or medicine loss due to repair or ...checking the "Assistance or Service" section or by an
authorized KitchenAid servicer is used for the following components to KitchenAid within 30 days from the date of purchase. 6. If outside the 50 United States and Canada, contact your home. 8. KITCHENAID® DISHWASHER...
KitchenAid Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Recommended installation for electrical, drain and water supply connections for dishwashers.
...opening . View or purchase the necessary kits needed to connect dishwasher drain hose and check for leaks animation Power wires are on your dishwasher installation. Go Back to see How to connect flexible water ... water supply comes from the right side, you must extend to the right front of the wire through at least 20" (50.8 cm) above the floor where the dishwasher will be improved... -
Overfill protection float
...;It must be in place for objects that may keep the protector from moving up or down. Dishwasher is not filling with water My dishwasher is the Overfill Protection Float? Check under the float for the dishwasher to operate. Overfill protection float What is not draining Product Literature (Use & Care, Parts Lists, etc... -
Refrigerator not operating
...the feature can make sure the Cooling control is turned on some models will be a Cooling On/Off button located on the control panel at the top of 3 Please tell...operating Why is getting power, the refrigerator compartment light should come on the dispenser panel at the same time for 3 seconds. If the refrigerator is my refrigerator not working at all? Check the outlet. Top...
Similar Questions
Is There A Recall On The Control Board For Model Listed Above?
Panel Flashes Error Code Indicating Erc As The Failure. We Have Understood That There Is A Recall On...
Panel Flashes Error Code Indicating Erc As The Failure. We Have Understood That There Is A Recall On...
(Posted by truwayappliance 7 years ago)
Kitchenaid Dishwasher W10142800b Won't Change Cycles.
will stay on wash or rinse only indefinatly.
will stay on wash or rinse only indefinatly.
(Posted by marik23 10 years ago)
Soap Dispenser Won't Open. Replaced It And The Control Board, Still Doesn't Ope
soap dispenser on my kuds35fxss3 wouldn't open. Took panel off and found that solenoid got overheate...
soap dispenser on my kuds35fxss3 wouldn't open. Took panel off and found that solenoid got overheate...
(Posted by tgooley 10 years ago)
I Need A List Of Fault Codes For Kitchenaid Kudh03dtbl1 Drawer Dishwasher.
I'm looking for a fault code list for my kitchenaid KUDH03DTBL.1 drawer dishwasher.
I'm looking for a fault code list for my kitchenaid KUDH03DTBL.1 drawer dishwasher.
(Posted by daveathassellfree 11 years ago)
During Operation Washer Stopped Completely And Panel Does Not Work.
(Posted by mcjohnny 12 years ago)