LiftMaster Miracle-One Support Question
LiftMaster Miracle-One Support Question
Find answers below for this question about LiftMaster Miracle-One.Need a LiftMaster Miracle-One manual? We have 1 online manual for this item!
Question posted by danricksconstruction on June 28th, 2011
Everything Tested Fine But When I Give A Command It Moves Very Little Before It
The person who posted this question about this LiftMaster product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related LiftMaster Miracle-One Manual Pages
MIRACLE ONE Manual - Page 2
... Option (Master / Second Only) Emergency Key Release Troubleshooting Optional Solar Power Miracle 1 Accessories Miracle 1 Parts Illustration Miracle 1 Parts List / Maintenance Features and Specifications Quick Reference Surge Suppressor Wiring ...Burglar Alarm and Proximity Switch "Gate Opening Inside" Installation of Maglock / Solenoid Relay "Gate Opening Outside" Installation of the publisher. UL...
MIRACLE ONE Manual - Page 3
... All warning signs and placards must be installed where visible in contact with a separate access opening and closing to the installation of entrapment. All exposed pinch points are eliminated or guarded, ...be visible to person located on the side of the gate outdoor. Swinging gates shall not open into public access areas.
E) Controls must be far enough from the gate so that ...
MIRACLE ONE Manual - Page 4
...for entrapment protection functions shall be located where the risk of the signals are not obstructed or impeded by a moving . 3. A hard wired contact sensor shall be located and its arc of travel, one that the communication between...non-contact sensor such as when a vehicle trips the sensor while the gate is still moving gate or barrier. Care shall be located on the bottom edge.
3
MIRACLE ONE Manual - Page 5
...ONE SHOULD CROSS THE PATH OF A MOVING GATE!
4. After adjusting the force or the limit of injury or death: 1. KEEP GATES PROPERLY MAINTAINED. SAVE THESE INSTRUCTIONS.
4 To reduce the risk of travel, retest the gate operator. Test the gate operator monthly. Make sure... Safety Instructions Warning - Read the manual. The entrance is for the gate operator is not moving.
MIRACLE ONE Manual - Page 6
...-family housing unit (five or more single family units) hotel, garages, retail store or other locations not intended to four single family dwelling, or a garage or parking area associated therewith.
Commercial/General access vehicular gate operator -
Residential vehicular gate operator -
Class III - A moving barrier such as an airport security area or other restricted...
MIRACLE ONE Manual - Page 7
... any location, including the area of the adjacent fence covered when the gate is in the open position. • Install the gate operator according to the manufacturer's installation instructions. • ...or the elderly. • Conspicuously display all features for the owners to insure that this testing is performed routinely. • Offer the owner/end user a maintenance contract, or contact ...
MIRACLE ONE Manual - Page 8
... the gate. • Never allow anyone to install a horizontal slide gate with exposed rollers or openings large enough to allow a sphere of 2 1/4 inches to pass through any other place where danger...pedestrian use if safety systems operate improperly, the gate is damaged, or the gate is difficult to move. • Never overtighten the operator clutch of the gate and any portion of the gate below...
MIRACLE ONE Manual - Page 9
...they will cause the wires to persons,
The Miracle-1 is not responsible for Vehicular Gate use ONLY! NO ONE SHOULD CROSS THE PATH OF THE MOVING GATE. 4.
DO NOT install next to sprinklers... to eventually break. WARNINGS AND PRECAUTIONS
Warning -
READ AND FOLLOW ALL INSTRUCTIONS. 2. Always keep the moving gate in the "ON" position, then add a safety loop and center loop. KEEP GATES PROPERLY...
MIRACLE ONE Manual - Page 10
...FOR INSTALLATION
Important:
Weld Re-Bar Behind Gate Hinges for Maximum Strength
Open To The Inside
Gate Hinge
Gate Hinge
Steel Re-Bar
Back Steel Bracket...
8.5"
25.75"
Post Setup
Out
Gate in Closed Position
7.75"
6"
In
Miracle 1 in Closed Position
90° / 105°
Gate in Open Position Miracle 1 in Open Position
Indexing on central hole in the back steel bracket.
10.25"
9
6"...
MIRACLE ONE Manual - Page 14
... hear the key release click into place.
Step 10: The following pages show the correct electrical procedures needed for the operator. The gate should not move after the operator has been locked.
MIRACLE ONE Manual - Page 16
...UL SENSOR CENTER LOOP SAFETY LOOP EXIT LOOP GROUND RADIO +24 VOLT +24 VAC INPUT
MIRACLE SURGE PROTECTION MIRACLE SURGE PROTECTION
1
3
REV A
2
®
LAKE FOREST, CALIFORNIA www.eliteaccess.com...
ALARM SENSOR
STOP BY POSITIVE
STOP
OPEN INSIDE
NO OFF
60
OPEN OUTSIDE
YES
ON 3
TIMER CENTRAL
POWER CHARGE OK BATTERY LOW CONTROL
STRIKE OPEN
SAFETY LOOP
RADIO REC
CENTER LOOP
...
MIRACLE ONE Manual - Page 19
Adjusted by Positive -
The controller will look for the limit close first and then it will reverse. CHOOSING GATE MOVEMENT DIRECTION
Switch the "Open Inside / Open Outside" switch on the control board to still adjust your limit switch at the close position.
Option -
Stop by Qualified Service Personnel
Minimum Sensitivity
Maximum ...
MIRACLE ONE Manual - Page 22
...DO NOT let wire insulation interfere with connection. MIRACLE SURGE PROTECTION
Important:
Wiring at #21 and #22 will be recognized as a Three Push Button command. BLACK WHITE RED BROWN BLUE GREEN BURGLAR ALARM ... makes good contact inside the control board box as shown using velcro. The Third command will open cycle, the control board timer must be turned ON.
21 22 23 24
®
LAKE ...
MIRACLE ONE Manual - Page 28
... Motor Fuse 4 J1-Batteries and Motor Connector 5 Strike Open LED 6 Safety Loop LED 7 Radio Receiver LED 8 Center Loop LED 9 J3 Transformer & Input Commands Connector 10 Central Control LED 11 Batteries Low LED 12 ...Switch-Timer, Off / On 21 Stop by Positive Stop Option Switch, No / Yes 22 Switch-Open Inside / Outside 23 Reverse Sensor Adjustment 24 Alarm Sensor LED 25 System On LED 26 Reverse Sensor...
MIRACLE ONE Manual - Page 29
... Motor Fuse 4 J1-Batteries and Motor Connector 5 Strike Open LED 6 Safety Loop LED 7 Radio Receiver LED 8 Center Loop LED 9 J3 Transformer & Input Commands Connector 10 Central Control LED 11 Charging Power Fuse 12... Off / On 22 Stop by Positive Stop Option Switch, No / Yes
Close Delay 23 Switch-Open Inside / Outside 24 Alarm Sensor LED 25 Reverse Sensor Adjustment 26 Reverse Sensor LED 27 System On...
MIRACLE ONE Manual - Page 32
... with the unit to make your connections to interface with a normally open without a
valid command, the proximity switch
will go off after 2 consecutive events on reverse...& #24
MIRACLE SURGE PROTECTION
BURGLAR ALARM
®
The control board provides a relay with a house alarm. The UL alarm will sound for a period of 5 minutes or until a new command is forced open contact to...
MIRACLE ONE Manual - Page 37
... gate manually to Unlock the Miracle 1 from the gate. The operator can resume normal operation as soon as power is restored.
EMERGENCY KEY RELEASE
Step 1: To move the gate during an emergency or
power failure, insert key and turn counterclockwise to the full open position 90°.
Full Open Position 90 Degrees
Push or...
MIRACLE ONE Manual - Page 38
... Fuse
15 Amps
3 Amps 1.5 Amps
Caution: If left side of the board and replace if necessary. TROUBLESHOOTING
Check the Fuses
If the gate is not moving in any direction be sure to check all LED's on the board are on, change the corresponding fuse on the left side board fuse is...
MIRACLE ONE Manual - Page 40
... or the operator or gate is installed incorrectly.
2 A foreign object is on the gate frame while the gate is moving.
3 Gate hinges are too tight or broken and the gate is not moving freely.
4 The gate hits the driveway, curb or other, and gets stuck in an awkward position.
39 TROUBLESHOOTING
You...
MIRACLE ONE Manual - Page 48
...
24
Relay
®
23
24V
Ground Ground Ground Ground Ground
Refer to Page 21
24 N.O. 23 Com
Works as "Open Only" Command
21
Com
25 +24V
23
Gnd
22 N.O.
21
Com
Refer to Page 25
24 VDC Exit Loop
Elite Part # ... 24 25 26 27
15 16
17
23
27
18
24 26
19
25
20
21
22
Green Ground Wire
The Miracle-One MUST be in the
"Light On" position.
15 16
23 25
13
24V to
(C1) 2 (NC1)...
Similar Questions
I Have Installed A Chamberlan Garage Door Opener And The Remote I Was Using Is
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
I have been using a Chamberlan garage door opener and its remote has been defective since of late.Pl...
(Posted by donweera42 9 months ago)
If The Reverse Sensor Adjustment Is Broken Is It Replaceable?
I have an Elite Miracle One gate opener from 2001 with upgraded board from 2013. The gate will move ...
I have an Elite Miracle One gate opener from 2001 with upgraded board from 2013. The gate will move ...
(Posted by wwcody1 10 months ago)
Garage Door Opens After Shutting.
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
My Lift master 8550 inside keypad is Inside wall pad is model #880LM. outside keypad Model # is 877M...
(Posted by BONNIECA92 2 years ago)
Gate Will Open But Not Close
Gate will open with remote but only close manually. Radio rec is working(red light and audible click...
Gate will open with remote but only close manually. Radio rec is working(red light and audible click...
(Posted by brettkyle 10 years ago)
My Opener Will Only Open And Not Close.
Gate will open with remote but only close manually. Radio rec is working(red light and audible click...
Gate will open with remote but only close manually. Radio rec is working(red light and audible click...
(Posted by brettkyle 10 years ago)