NordicTrack E 7.2 Elliptical Support Question
NordicTrack E 7.2 Elliptical Support Question
Find answers below for this question about NordicTrack E 7.2 Elliptical.Need a NordicTrack E 7.2 Elliptical manual? We have 16 online manuals for this item!
Question posted by cjtrujillo on April 16th, 2015
Console Does Not Increase Or Decrease The Resistance Levels
My Eliptical Trainer is not changing the levels of resistance when I am using it. The resistance is constant at level 1 and level 20.Does it has to do with the console? or the motor?
Current Answers
Answer #1: Posted by BusterDoogen on April 16th, 2015 6:43 AM
BusterDoogen
Member since:
October 30th, 2011 Points: 28,565,397
Member since:
October 30th, 2011 Points: 28,565,397
Electronics Problem
You control the tension of the pedals using the buttons on the console. When you assemble the A.C.T. elliptical, you have to thread a group of wires from the console through the upright down to the electronics board. These wires communicate the resistance settings to the electronics board. If the wires twist, disconnect or break, the resistance will not work. You will need to reconnect or replace the wires.
I hope this is helpful to you!
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful. Please feel free to submit further info for your question, if a solution was not provided. I appreciate the opportunity to serve you!
Related NordicTrack E 7.2 Elliptical Manual Pages
Uk Manual - Page 2
TABLE OF CONTENTS
WARNING DECAL PLACEMENT 2 IMPORTANT PRECAUTIONS 3 BEFORE YOU BEGIN 4 PART IDENTIFICATION CHART 5 ASSEMBLY 6 HOW TO USE THE ELLIPTICAL 17 MAINTENANCE AND TROUBLESHOOTING 26 EXERCISE GUIDELINES 28 PART LIST 31 EXPLODED DRAWING 33 ORDERING REPLACEMENT PARTS Back Cover RECYCLING INFORMATION Back Cover
WARNING DECAL PLACEMENT
This drawing shows the location(s) ...
Uk Manual - Page 3
.... Keep your back.
7. Inspect and properly tighten all warnings on the elliptical. The elliptical should not be used by or through the use of this manual.
9. To protect the floor or carpet from moisture and dust. Over exercising may affect the accuracy of the elliptical and 2 ft. (0.6 m) on a level surface, with pre-existing health problems.
2. Do not...
Uk Manual - Page 4
...) Weight: 170 lbs. (77 kg)
Upper Body Arm
Accessory Tray
Console
Speaker Heart Rate Monitor
Handlebar
Pedal Roller
Handle Leveling Foot
Wheel
Ramp Handle Ramp
4
BEFORE YOU BEGIN
Thank you , note the product model number and serial number before you use the elliptical. The model number and the location of features designed to make...
Uk Manual - Page 10
...Arm (61) onto the Right Upper Body Leg (60).
Untie and discard the wire tie on the Console to the Upper Wire (110), to the Pulse Sensor Wires (63), and to the Extension Wire (...120).
9 7
Insert the excess wire into the Upright (4) or into the Console (7).
63 120 110
4
10 While a second person holds the Console (7) near the Upright (4), connect the wires on the Upper Wire (110). Hexagonal...
Uk Manual - Page 11
10.
Attach the Console (7) to the Right Pedal Arm (58) with four M4 x
10
16mm Screws (101).
7 Avoid pinching the wires
101 4
101
11. Identify the Right Pedal Arm (...
Uk Manual - Page 15
...) around the Upright (4) by pressing the hooks on the Rear Console Cover (80) onto the tabs on page 17. Note: To plug the Power Adapter (119) into the Plug Adapter (B).
Make sure that all parts are properly tightened before you use the elliptical.
Plug the Power Adapter (119) into the receptacle on the...
Uk Manual - Page 16
...that the
antenna on the Receiver (A) is oriented so that are installing the receiver as part of the elliptical assembly, go to the floor.
101 120
A
4
Connect the wire on the inside of the Receiver... (37). If you are included with four M4 x 16mm Screws (101). Remove the Front and Rear Console Covers (79, 80) if necessary.
21
Then, remove the Front and Rear Upright
Covers (117, 81...
Uk Manual - Page 17
... room temperature before you may damage the console displays or other electronic components.
Power Adapter
Plug Adapter
HOW TO LEVEL THE ELLIPTICAL
If the elliptical rocks slightly on your foot
here
Lift here
17 Leveling Feet
HOW TO MOVE THE ELLIPTICAL Due to the size and weight of the elliptical. Then, plug the plug adapter into the...
Uk Manual - Page 18
...INCLINE OF THE RAMP
To vary the motion of the pedals, you can change the incline of the adjustment holes in the frame. Upper Body Arms ...level. Then, step off the higher pedal first. To raise the ramp, simply pull the ramp handle upward to move until the flywheel stops. Make sure that the latch pin is in the opposite direction. HOW TO EXERCISE ON THE ELLIPTICAL
To mount the elliptical...
Uk Manual - Page 19
... twenty onboard workouts-ten calorie workouts and ten performance workouts. Each workout automatically changes the resistance of the console, you exercise. iFit.com or call the telephone number on the display, remove the plastic. To use an iFit workout, see page 23. To use an onboard workout, see page 25. Note: If there is a sheet of...
Uk Manual - Page 20
...USE THE MANUAL MODE
1. Begin pedaling or press any button on the console to turn on. You can also press the increase and decrease buttons next to reach the selected resistance level.
4. As you turn on the console, the display will turn on the console.
When you exercise... each time the resistance level changes.
If a ...
As you pedal, change the resistance of calories you press...
Uk Manual - Page 21
... using a soft cloth; If necessary, press the Home button again.
Change the volume level of the console by pressing the volume increase and decrease buttons.
5. For optimal performance, clean the contacts using ... rate will be reset.
21 As you exercise, the workout intensity level bar will indicate the approximate intensity level of your exercise.
Press the Home button to return to ...
Uk Manual - Page 22
... time will turn off automatically.
Make sure to pedal at any button on the console to turn on the console.
When you are finished exercising, the console will appear in the display.
3. See step 4 on page 21.
22 Note: The same resistance level and/or target speed may be programmed for consecutive segments.
During the
workout...
Uk Manual - Page 23
...increase and decrease buttons next to the Enter button to download the next workout of the race you through your personal trainer (see www.iFit.com.
You will flash in your heart rate if desired. See step 3 on the console....
7. See step 5 on page 20.
The My Trail tab will show a map of the trail you are finished exercising, the console will burn. Press the Compete
See ...
Uk Manual - Page 24
... show the total number of the personal trainer if desired.
Press the decrease button to view the contrast level. If no module is connected to the console, you to turn on the elliptical.
3. The currently selected audio setting for a few seconds.
9. Press the Resistance increase and decrease buttons to adjust the contrast level.
5. Determine if an iFit module is...
Uk Manual - Page 25
...this manual.
25 Adjust the volume level using the volume increase and decrease buttons on the console or the volume control on your MP3 player or CD player; HOW TO USE THE SOUND SYSTEM
To play button ... rate while you exercise, helping you exercise, plug your audio cable into the jack on the console and into a jack on your MP3 player or CD player. make sure that your personal fitness goals.
Uk Manual - Page 26
... (38).
then, wipe off any worn parts immediately. Using a flat screwdriver, remove the left disc.
26 IMPORTANT: To avoid damage to or away from the console and keep liquids away from the Magnet (43), and then retighten the Screw. HOW TO LEVEL THE ELLIPTICAL
If the elliptical rocks slightly on the Tracks (16), apply a small...
Uk Manual - Page 27
... from the elliptical. Remove the M4 x 19mm Screws (5) and the M4 x 48mm Screw (107) from the right Crank Arm (20).
Next, ...locate and loosen the Idler Screw (89). Next, tighten the Belt Adjustment Screw (91) until the Drive Belt (113) is adjusted to the highest level...slip while you are pedaling, even while the resistance is tight. Use a flat screwdriver to be adjusted. Then, see...
Uk Manual - Page 28
... may complete up increases your exercise program. For detailed exercise information, obtain a reputable book or consult your age at the bottom of the chart (ages are essential for energy. To find the proper intensity level, find the proper intensity level.
If your goal is to burn fat, adjust the intensity of your exercise until your heart...
Uk Manual - Page 31
...1
9
1
10
1
11
1
12
1
13
1
14
1
15
1
16
2
17
1
18
1
19
1
20
2
21
4
22
1
23
3
24
1
25
1
26
4
27
2
28
1
29
1
30
4
31
...Console Left Handlebar Right Handlebar Ramp Cover Left Latch Handle Right Latch Handle Latch Button Latch Bracket Rear Stabilizer Cover Track Latch Pin Crank Pulley Crank Arm M4 x 10mm Screw Idler Bumper Small Leveling Foot Resistance Motor...
Similar Questions
Resistance Level Will Not Change On My Nordic Track Sl720
Resistance level will not change when using my Nordic track sl720, console power ups.
Resistance level will not change when using my Nordic track sl720, console power ups.
(Posted by timjones500 7 years ago)
I Would Like To Increase The Overall Pedaling Resistance Of My Nordictrack C3si.
I have a NordicTrack C3si and the resistance changes with the electronics, but I would like to incre...
I have a NordicTrack C3si and the resistance changes with the electronics, but I would like to incre...
(Posted by i82jellybeans 9 years ago)
Resistance Level Won't Change On My Nordictrack Audiostrider 990
The resistance level won't change on my Nordictrack audiostrider 990, either automatically or manual...
The resistance level won't change on my Nordictrack audiostrider 990, either automatically or manual...
(Posted by rmoore080 10 years ago)
Backlit Console
The light on the console is not working, it was on earlier today but is now not. The console works ...
The light on the console is not working, it was on earlier today but is now not. The console works ...
(Posted by Anonymous-122623 10 years ago)
Resistance Level Issue On Nordictrack Gxr4.1
My resistance level isnt changing on my bike. It changes on teh screen but seems to make no differen...
My resistance level isnt changing on my bike. It changes on teh screen but seems to make no differen...
(Posted by vizard72 11 years ago)