Robot Vacume Won't Power Up

1. Check the power source: Ensure that the robot vacuum is properly connected to a power outlet or charging dock. Make sure the power source is functioning correctly by plugging in another device or appliance.
2. Charging dock connection: If your robot vacuum uses a charging dock, verify that the vacuum is properly docked and the charging pins are aligned correctly. Clean any dust or debris on the charging contacts.
3. Battery level: If the robot vacuum has a low battery, it may not power up. Place it on the charging dock for an extended period to allow it to charge fully. Refer to the user manual for the recommended charging time.
4. Reset the robot vacuum: Try resetting the robot vacuum to see if it resolves the issue. Look for a reset button on the device or refer to the user manual for specific instructions on how to reset your model.
5. Check for obstructions: Inspect the robot vacuum for any blockages or tangled debris that might be preventing it from functioning correctly. Clear any obstructions, such as hair or debris, from the brush roll or wheels.

- Make sure your robot vacuum charging base is fine.

- Clean the contacts of your robot vacuum.

- Wiggle the Roomba vacuum to turn it on.

- Reset your robot vacuum.

- Press the CLEAN button or ON/OFF on remote again, robot will beep three times and the indicator will flash blue quickly, if its function is normal, robot will start.

- Check if the hard power switch on the side is set to the on position.

- Allow the robot to charge undisturbed for 5-6 hours if the battery is depleted.

- Perform a system reset by pressing and holding the power button for 4-5 seconds.

- Check if the latch that keeps the dirt and debris container in place is properly closed.

- If the problem persists, contact Pyle customer support for further assistance.