RCA 25215 Support Question
RCA 25215 Support Question
Find answers below for this question about RCA 25215.Need a RCA 25215 manual? We have 1 online manual for this item!
Question posted by alopez6229 on October 2nd, 2014
How Do You Transfer A Call?
I need to know how to transfer a call to a number set in the phone i.e. line 1, 2, 3, etc? Thank you
Current Answers
Answer #1: Posted by TechSupport101 on October 2nd, 2014 4:18 PM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,255
Member since:
May 24th, 2013 Points: 12,171,255
Hi. The manual seem to be silent about this (availability of the tranfer button). Do double check as well though.
Related RCA 25215 Manual Pages
User Guide - Page 3
...to your line as determined by the ACTA. To be certain of the number of these devices ring when your telephone number is called...right to bring a complaint to the Commission pursuant to procedures set forth in Subpart E of such temporary discontinuance; (2) afford you...lines are subject to state tariffs, and therefore, you may not be able to use your own tele phone equipment if you are on your line...
User Guide - Page 4
..., Washington, D.C., 20402. Hearing Aid Compatibility
This telephone system meets FCC standards for compliance could void the user's authority to maintain uninterrupted service.
Please specify stock number 004-000-00345-4 when ordering copies. and (2) This device must give you adequate notice, in writing, to allow you to operate the equipment. This booklet...
User Guide - Page 5
...17
- 2nd Call Alert
17
- Restore Setting
17
- Making Calls in Directory 21
- Reviewing the Redial Numbers
21
- Speakerphone, Handset and
Headset Volume
...Phone Layout
7
Installing the Phone
8
Programming the Phone
11
- Programming Functions
11
- Answering System
11
- Answer Mode
11
- Settings
12
- Ring Delay
12
- Set Office Time
12
- Set Work Hours
13
- Set...
User Guide - Page 7
... modular phone jack, which might look like the one installed. Wall plate Modular
telephone line jack
7
Important Installation Guidelines
• Avoid sources of noise and heat, such as motors, fluorescent lighting, microwave ovens, heating appliances and direct sunlight. • Avoid areas of fice.
If you will need a RJ11C (for a single line) or a RJ14C...
User Guide - Page 9
... telephone products retailer.
8 As a precaution, you may be connected by a single two-line cable or two single line cables. 1. It is intended to be purchased from the base. • Insert the ...in the display, you need to replace the batteries. NOTE: If the low battery icon appears in a vertical or floor mount position.
4. Installing the Phone
The phone may want to write...
User Guide - Page 12
.... 5. NOTE: The Soft keys will need to set the year by going to give you ...to menu "Phone Setting- Press the VOL (- Programming the Phone
Standby Screen
The phone displays the... current date, time and the Soft keys.
Press the MENU Soft key to go to all of the unit. Press OK Soft key. 3. or +) button to scroll to select Line1 or Line...
User Guide - Page 13
.... or +) button to select between Line1 and Line 2 and press the OK Soft key to record...phone to ring before the answering system answers a call after 2 rings if there are new messages, or after the tone". or +) button to scroll to stop recording. 2. Set Office Time
From the Settings Menu: 1. 2. Use the VOL (- NOTE: The default Answer & Rec OGM is completed, the unit will need...
User Guide - Page 15
... (- Press the OK Soft key to Settings. 2. NOTE: You must subscribe to conveniently access the voicemail feature offered by your voicemail access number. Press the OK Soft key. Default is used to telephone service provider-offered voicemail on at least one phone line in Talk mode) 2. The phone will need to add "#" before entering your code...
User Guide - Page 16
... 2011, etc. NOTE: Enter the Year as a 2-digit number.
or +) button to scroll to Date/Time . 2. or +) button to scroll to Phone Settings. 4.
NOTE: If you may program the following items:
Date/Time Sound Settings Dial Mode Area Code 2nd Call Alert Restore Setting
Date/Time
From the Phone Setting Menu: 1. However the year must still be...
User Guide - Page 20
... an error tone.
19 NOTE: Headset performance may vary widely depending on the phone. 4. NOTE: The maximum pre-dialing number length is 32 digits, if the number is over 32 digits, the phone will be dialed out. If both lines are available, Line 1 will be used first. 5. Press the headset button on the quality of the...
User Guide - Page 22
.... (not in Directory
1. Redial
1. If both lines are available, Line 1 will be dialed accordingly. Reviewing the Redial Numbers
Your phone records up the corded handset from your phone. When the phone is displayed, press the Speaker, Headset, a Line button, or pick up the corded handset to dial the phone number. While the preferred number is idle, press the redial button...
User Guide - Page 23
... (- Speakerphone, Handset and Headset Volume
While the phone is in an ascending series of the number keys so it requires more than one letter is...LINE 1 or LINE 2 Soft key to activate the ringer volume setting. 3. The line icon will flash red. Press the Line 2 button to save your entry. Dial the other number and wait for the letter "B" press the number 2 key twice. The desired redial number...
User Guide - Page 25
... for you hear the tone. Select either the Line 1 or Line 2 Soft key. 4. Enter the # key... review the previous message Press three (3) to erase. 2. Make sure the phone is full, the system answers after the 10th ring if it is erased... unit also answers after 10 rings. Dial the telephone number to which the answering system is set to confirm. Enter the remote commands. 5. The current...
User Guide - Page 26
...you must subscribe to the Phone Directory
1. NOTE: The name field cannot be displayed on formatting a number
25 Caller ID (CID)
IMPORTANT: In order to use the VOL (- To know who is answered or ...or the name, phone number, date and time. When the memory is also shown to the right of the CID number to 7, 10 or 11 digits and save it . The line number for calls received that...
User Guide - Page 27
..., this does not guarantee the call is a local call was not from within your area code. 3. To adjust the phone number format, use the FORMAT Soft key. To dial the displayed number, select a Line or press the Speaker or Headset button or pick up the corded handset.
Use the Caller ID button to dial...
User Guide - Page 28
... a pause in each One-Touch/Memory Log stores up to dial the displayed number . The caller identification information appears in the Directory (up the handset from your phone is calling while you are currently on the same line, you hear the tone.
NOTE: Press the Delete button key will only see...
User Guide - Page 29
... displays Enter Name. 5. NOTE: The name field cannot be used to delete character or number to the left and right navigational buttons allow the cursor to insert a pause in Talk ...number, if necessary.
8.
Press the VOL (- Press the OK Soft key to confirm overwrite or press the BACK Soft key, then select a new location. 4. Storing a Record in that memory location.
Make sure your phone...
User Guide - Page 30
... the DIAL Soft key to number change the name, if desired. 3. Make sure your phone is in idle mode. (Not in Talk mode) 2. Deleting a Directory Record
1. When reviewing the directory records list, use the VOL (- Press and hold the Delete button on the phone to keep the previous setting (making no changes). Press One...
User Guide - Page 32
... mode, the base is available, the unit enters Battery Operation Mode. Make sure the telephone line cord is connected to the same jack.
Caller ID Solutions No Display • Make sure ...setting is ok, but can't dial out • Make sure the type of phone service you need to clean the unit. Dial tone is restored to default setting • May be subscribed to the standard Name/Number...
User Guide - Page 35
... 0. Accessory Information
DESCRIPTION AC Power Adapter
MODEL NO.
A shipping and handling fee will be charged upon ordering.
All rights reserved.
Model 25215 T0009063 (Rev00) 09-50 Printed in China
25215 Spanish Instruction Book available at www.rca4business.com
34 Prices are subject to which the me rchandise is a trademark of incidental or...
RCA Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Bluetooth Operation on Phase Linear BT1611i Head Unit
... unit. Before accepting or making an outgoing call, it's not possible to transfer the call , until it takes to the number you set the default ringing volume for successful operation: Before using Bluetooth functions, you must pair your phone conversation. A higher volume setting may have difficulty pairing or the Bluetooth operation is turned off ), the... -
Troubleshooting the TH1401, TC1401 MP3 Player
... M again to any files you have transferred to the player, you have changed after the computer has detected the player. Plug the player into a number of my TH1401, TC1401 MP3 Player Connecting...TC1401 MP3 Player You will need to refine your player will power off will display and your settings in the Settings menu. You may delete them while you may need to confirm. You have ... -
Setup and Connection of the RCA Lyra X3030 Digital Media Recorder
...setting to your computer, connect the Lyra Recorder to transfer content onto. Multiple level sub folders under the PHOTOS system folder for the new files to Your Components The docking station is in MTP mode the Lyra Recorder will need...the software will create playlists (the number of playlists created will only work ... included audio/video cable to the LINE OUT jack on your device, you...
Similar Questions
Bad Speaker In Rca 25215 Desk Phone
Can I replace the speakerphone in my RCA 25215 desk phone and if/so, where can I buy the parts?
Can I replace the speakerphone in my RCA 25215 desk phone and if/so, where can I buy the parts?
(Posted by trudywilliams 10 years ago)
Ans Sys Light Started Blinking Recently.
The Ans Sys light started blinking recently, even though I am not using the built-in answering syste...
The Ans Sys light started blinking recently, even though I am not using the built-in answering syste...
(Posted by d99piecuch 11 years ago)
Does The Battery Need Replacing After A Certain Period Of Time?
My handset often goes dead after brief (5 min.) usage. Should the battery be replaced?
My handset often goes dead after brief (5 min.) usage. Should the battery be replaced?
(Posted by kellclan 11 years ago)
Setup Voicemail On Rca 25212 Phone
How do I setup the voicemail from the RCA 25212 phone read the manual snd still don't know how to se...
How do I setup the voicemail from the RCA 25212 phone read the manual snd still don't know how to se...
(Posted by Jack83343 11 years ago)