Singer 7467S Confidence Stylist Support Question
Singer 7467S Confidence Stylist Support Question
Find answers below for this question about Singer 7467S Confidence Stylist.Need a Singer 7467S Confidence Stylist manual? We have 1 online manual for this item!
Question posted by colleenlink on December 24th, 2012
Stitches Not Catching
I was sewing and then the stitches stopped catching. the fabric moves under foot but no stiches. what happened ??
Current Answers
Related Singer 7467S Confidence Stylist Manual Pages
Instruction Manual - Page 2
..., threading bobbin, or changing presser foot, etc." 18. "Always unplug sewing machine from the accumulation of lint, dust...sew with this sewing machine if it has a damaged cord or plug, if it has been dropped or damaged, or dropped into water.
Moving parts-To machine." To reduce the risk of electric shock:"
1. "Do not pull or push fabric while stitching.
"This sewing machine...
Instruction Manual - Page 5
... stitch, Crossed stitch, Slant overedge stitch, Slant pin stitch, Greek key stitch, Fishbone stitch, Thorn stitch, Reinforced overedge stitch Decorative designs 60 - 61 Ideas on design stitching Continuous patterns 62 - 63 Novelty patterns 64 - 65 Sewing on a button 64 - 65 Sewing a buttonhole 66 - 71
Using buttonhole foot, Procedure, Corded buttonholes
3. KNOWING YOUR SEWING MACHINE Machine...
Instruction Manual - Page 8
...SEWING MACHINE
MACHINE IDENTIFICATION
1. Face cover 5. Extension table (Accessory box) 7. Horizontal spool pin 12. Handle 13. Power/light switch 15. Presser foot lifter 18. Thread guide 23. Needle bar 27. Needle clamp screw 30. Thread cutter 6. Hand wheel 14. Automatic needle threader 21. Presser foot screw 24. Alternate Thread Cutter 28. Presser foot...stitch switch 10. Foot...
Instruction Manual - Page 10
.... Soft-sided dust cover
The Foot that comes on your Sewing machine is another very useful foot and should be used for most of your decorative sewing. Spool pin felt discs (2) 5. Spool pin cap (medium) 7. Zipper foot 11. Blind hem foot 13. Darning & embroidery foot (stippling foot) 16. Even feed / Walking foot 18.
The Satin Foot (11) is called the General...
Instruction Manual - Page 14
... feed dogs above the line).
3) Turn the machine so that the needle is being used. They should be placed to sew.
2.
Spool pin cap Couvre-fil Tapa del pasador carrete
Spool Bobine Carrete
Spool pin Porte-bobine Pasador carrete
PRESSER FOOT LIFTER
There are guiding the fabric. Lift it should be larger than that...
Instruction Manual - Page 28
... threads 'lock' in the up position. Raise presser foot lifter. 1. Lower the presser foot lifter so that the stitching is usually only desireable for straight stitch sewing. Helpful Hint: A slight adjustment to remove the foot. 2. If, when you find that the foot holder snaps
on top of the machine.
Push presser foot release button to a higher number or a lower...
Instruction Manual - Page 32
... adjustments. Patterns in dark blue - stitch length and width can manually change the length, width or straight stitch needle postition according to your stitching requirements at the Auto position, slide the control knob left or right to the pattern reference guide. Stitch length and width/needle position controls
*Auto/Default settings Your sewing machine will sound.
Instruction Manual - Page 34
... Interruptor de modo de aguja doble
32
While the switch is lit red.
Turning off the machine returns the machine to selecting a pattern.
A l w a y s s e l e c t t h e Tw i n N e e d l e M o d e p r i o r
to normal sewing mode. This will preclude any possibility of the stitch you selected. Twin needle mode switch ( )
When using twin needles, push the twin needle mode switch...
Instruction Manual - Page 36
... as the reverse switch button is pressed.
* Tacking stitch function for straight and zigzag stitches ( ) Reverse sewing is carried out while the reverse stitch switch is pushed. The machine will be at the start and end of other stitches ( ) The sewing machine makes 4 tiny tacking stitches to tie off the sewing pattern to sew in the pattern where the reverse/tacking...
Instruction Manual - Page 42
...gently with the thread cutter
located on the needle plate. SETTINGS
B
Presser foot -
Reverse stitch switch C. Presser foot lifter D. AUTO
NOTE: Based upon the weight of the fabric, slight "fine tuning" of the material, stop the sewing machine. A
E F
C
D
A. STRAIGHT STITCHING
Straight stitch is most frequently used to change the needle position.
3
2. When reaching the...
Instruction Manual - Page 44
... derecha del prensatelas
INSERTING ZIPPERS To sew down the left side of zipper foot to the top. 2. When
sewing the machine will pull this thread to presser foot holder so that
matches your fabric. To sew down the right side, attach left side, attach right side of the foot.
NOTE: For a dramatic appearance, experiment with the Stitch Width Control.
Instruction Manual - Page 46
... on the bottom depending on the thread, fabric, type of stitch and sewing speed, but the bobbin thread must never appear on the sewing machine. The light grey boxes indicate all the possible personal preference options available to avoid puckering. SATIN STITCH
This is selected. Use a backing of the fabric. Under side Côté de dessous Reverso...
Instruction Manual - Page 48
... the handwheel towards you by hand until the needle swings fully to sew blind hems. Always make a sewing test first.
4
Top side Cara Endroit
46 When completed, the stitching is primarily used for normal firm fabrics
1
2
Medium to heavyweight fabrics overcast the fabric's raw edge.
2. Settings : Presser foot - Under side Reverso Envers
1
Under side Reverso Envers
2
Fine...
Instruction Manual - Page 56
... thread work, choose a coarse linen type fabric and after sewing draw the thread out within the ladder for the ladder stitch is couching over thin tape in one operation. CRISS-CROSS STITCH
Used to sew and finish stretch fabrics or for decoration of borders. CROSSED STITCH
Use to sew and finish elastic fabrics or for decoration especially of borders...
Instruction Manual - Page 66
... foot :Feed dog control - Sew 10 stitches.
If a button shank is required, place a darning needle on top of the button and sew over top of the fabric and tie together.
64 Helpful Hint: To secure thread, pull both threads to make sure needle clears both left and right openings of button. Satin foot :Thread tension control -
SEWING...
Instruction Manual - Page 70
... of the stitching.
68
Buttonhole foot alignment position Position d'alignement du pied boutonnière Posición de alineación del pie de ojaladora Be careful not to the rear.
7. Align the buttonhole mark on the fabric with the mark on your garment.
6. While holding the top thread, start the machine. When sewing is finished...
Instruction Manual - Page 76
... controlled by the movement of your
fabric.
2. This is most useful for Zigzag Stitch in the width you sew, hold the upper fabric with your presser foot.
74
Extension arm Bras de rallonge Brazo extensor
Machine Preparation • For free motion embroidery and monograms: Set machine
for sewing satin stitches and as stippling. The stitch length will control the quality...
Instruction Manual - Page 78
... off power switch and unplug machine. 2. a. Machine setup 5. Set stitch length at left side (M) of machine
with
scissors. Raise needle and presser foot. 11.
b. Lower presser foot and turn hand wheel by hand to needle plate. Start to sew 10. Note: 1. Always check that needle clamp screw (E) is
being trimmed. 4. When sewing thin fabric, stretch fabric slightly when it through...
Instruction Manual - Page 80
... foot screw Barre pied-presseur Tornillo del pie prensatelas
TWIN NEEDLE (Option)
A twin-needle produces two rows of the twin needle breaking. 2.
Always move the stitch width to the Twin Needle
Mark prior to thread the twin needle.
It is not recommended for sewing leather, ultra suede, shiny fabrics (vinyls, patents and satins), bonded fabrics, pile fabrics...
Instruction Manual - Page 84
...
GENERAL PROBLEMS Machine does not sew. * Power switch is not correct for thread and fabric. - Lower buttonhole lever. * Bobbin winder is not threaded correctly. - Disengage bobbin winder (see page 26 - 27). * Stitch length is not all the way up into the needle clamp. - Machine jams/knocks. * Thread is not lowered - Fabric does not move. * Presser foot is caught...
Similar Questions
My Sewing Machine Beeps When I Push The Presser Foot But It Doesn't Seem To Wo
(Posted by elizheva 1 year ago)
Error 88 Singer Brilliance 7467
Shows on display 88, what can I fix it, Help!!!
Shows on display 88, what can I fix it, Help!!!
(Posted by jorgeivpalomino 4 years ago)
I Need An Extnesion Table For My Sewing Machine Singer 7258 Stylist
(Posted by loucksd 10 years ago)
Everything Seems Ok, But Not Sewing Once I Insert Fabric
I have sheen troubleshooting everything and my machine appears to be working but then the threads ar...
I have sheen troubleshooting everything and my machine appears to be working but then the threads ar...
(Posted by shanna 10 years ago)
Buttonhole Stitch Is Not Working
I am trying to make a buttonhole on my singer 7467. I have read the manual and followed the directio...
I am trying to make a buttonhole on my singer 7467. I have read the manual and followed the directio...
(Posted by dkmartinez67 10 years ago)