Troy-Bilt Mustang 42 Support Question
Troy-Bilt Mustang 42 Support Question
Find answers below for this question about Troy-Bilt Mustang 42.Need a Troy-Bilt Mustang 42 manual? We have 1 online manual for this item!
Question posted by Olearyjennifer50 on September 6th, 2022
Mustang 42 Inch Zero Turn
Try to start my 0 turn and it made it horrible or constant loud noise and I had to disconnect the battery and it would not turn over it would just continue to try to crank What could that be I had just used it 30 minutes before to cut a yard
Current Answers
Answer #1: Posted by Odin on September 6th, 2022 9:26 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,640
Member since:
April 10th, 2010 Points: 41,236,640
See https://www.repairclinic.com/RepairHelp/Lawn-Mower-Repair/21-323--/Troy-Bilt-Lawn-Mower-Troubleshooting. Of these Most Common Problems, consider first the ones listed on the top row.
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Troy-Bilt Mustang 42 Manual Pages
Operation Manual - Page 1
... INJURY. Printed In USA
TROY-BILT LLC, P.O.
Safe Operation Practices • Set-Up • Operation • Maintenance • Service • Troubleshooting • Warranty
Operator's Manual
Mustang Series RZT
WARNING
READ AND FOLLOW ALL SAFETY RULES AND INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO OPERATE THIS MACHINE.
Operation Manual - Page 2
...Information
Before setting up , operate and maintain your machine, for purchasing a Troy-Bilt Zero-Turn Tractor. This information will operate the machine, carefully follow the recommended safety practices at ... the information in personal injury or property damage. If applicable, the power testing information used to operating the equipment. To The Owner
1
Thank You
Thank you , and any...
Operation Manual - Page 4
... which could suddenly turn slowly uphill and use extra care while turning.
25. Contact your foot on it, do not operate this machine on that operators, age 60 years and above, are not covered in this
dump cart, lawn roller, etc.) on any adjustments.
21. Watch for assistance.
For your safety, use
contact or thrown...
Operation Manual - Page 5
...starting the engine.
l. m. Never run into the path of the machine. Disconnect...loss of Gasoline:
1.
Be alert and turn machine off and be serviced professionally by an... any fuel soaked debris. loaded dump cart, lawn roller, etc.) on the ground away from ...to cool at the hitch point.
2. General Service
1.
Use extreme care when approaching blind corners, doorways, shrubs, ...
Operation Manual - Page 13
...the tractor, just inside each ...starting and/or battery discharge, remove the key from the tractor. Pull the switch knob upward to engage the PTO clutch, or push the knob downward to increase the engine speed. Towing the tractor with the throttle/choke control in the gas tank. Turn the fill cap approximately 1⁄4 turn... for instructions on using the bypass feature.... and the mower deck is ...
Operation Manual - Page 14
... brake is in the digital display (tenths of the throttle or throttle/choke control. The Indicator Monitor will not crank with the ignition switch in the ON position, but should turn off when the engine is started during operation, check the battery and charging system for five minutes every time the tractor's engine is...
Operation Manual - Page 15
...cranking or starting... mower deck removed.
Do not use ...starting and stopping. The operator should ever malfunction, do not operate the tractor. Entirely read this manual carefully to a tractor rollover.
• Avoid operation on the control levers.
• Be careful when operating near roadways. Look behind and down before turning and come to a complete stop before any zero turn...
Operation Manual - Page 16
... load.
7. If the engine does not start , do not crank the engine continuously for Starting the Engine. If the battery charge is malfunctioning.
NOTE: Always remove the key from the ignition switch. Start the engine as the engine starts; Be sure the battery is in good condition. A warm battery has much more than a cold battery.
2. Periodically check the functions of...
Operation Manual - Page 17
...the control levers takes some practice. Always maintain your right and left hands and continue with Driving the Tractor Forward on uneven terrain or a hill may result in ... Use)
Operating a zero-turn tractor is more maneuverable, getting used to stop the tractor; Adjust the operator's seat to the most comfortable position that you can affect the stability of the tractor will start to...
Operation Manual - Page 18
... the possibility of turf defacement, and could affect control of travel, we recommend performing gradual 'U' turns where possible.
To turn to move both sides of the right lever.
The tractor will start to the right, move the right drive control lever
rearward of the left drive control lever rearward of the tractor before...
Operation Manual - Page 19
... tractor while driving rearward, move the control levers as necessary so that one lever is moving the other . See Figure 5-7. Executing a Zero Turn
WARNING! When executing a zero turn .
4.
To turn counterclockwise, move the turn ," move the right control lever
forward while simultaneously moving the left drive control lever forward of the right lever. To execute a "pivot...
Operation Manual - Page 20
...mower with a slope in the Safe Operation Section to move the throttle/choke control to the operating speed (full engine speed).
4.
Be careful when crossing gravel paths or driveways.
Use extra care and go slowly when turning...previously cut quality. Avoid turning downhill if possible. The operator must be mowed is recommended unless a pivot or zero turn the ignition key off ...
Operation Manual - Page 21
...safety circuit is not working properly. Pull the PTO switch upward to the start position; Lift upward from the operator's seat. Engage the PTO and move ... the tractor inspected. Momentarily turn the ignition switch to the engaged position. Section 5 - the engine should stop.
the PTO should disengage and the mower deck should not crank.
2. Start the tractor and move both...
Operation Manual - Page 22
... adapter to lock the adapter on the water supply.
Using the Deck Wash System
WARNING!
Release the lock collar to disconnect the adapter from around the spindle pulleys 4.
Pull back... tractor operator's seat, start the engine and engage the PTO. Allow to a water supply.
2. Repeat the previous steps to remove any position other end of the mower deck.
Cleaning the Spindle...
Operation Manual - Page 23
... soda/water.
• NEVER connect (or disconnect) battery charger clips to the battery while the charger is not necessary to move the tractor, the two hydrostatic transmissions are located on each one on the rear of the tractor, just inside each rear wheel. Although the tractor may start, the engine charging system may emit explosive...
Operation Manual - Page 25
...can be between 1⁄4-3⁄8" lower than the second measurement. 4. Protect your hands by turning lock nut on a firm, level surface, place the deck lift handle in the neutral position... taken should not ride on the mower deck are even with the tractor.
2. Measure the distance from the discharge opening of the deck by turning the adjustment gear. Using a wrench, raise or lower the...
Operation Manual - Page 26
... and blades. (Be careful not to pump the excess oil out of the just adjusted wheel, and adjust the other front gauge wheel into anapproved container outdoors, away from Storage
1. Recharge the battery periodically when in the Engine Manual. Using the starter, crank the engine to get any oil on the drive belts.)
7. The...
Operation Manual - Page 28
...downward, continue turning the
PTO pulley until the belt rides out onto the edge of the lower sheave of the 'V" belt just far enough...pulley. See Figure 7-4.
46/50/54" Decks
Moveable Idler Pulley
42" Decks Moveable Idler Pulley
PTO Pulley PTO Belt
Transmission Tube
Fixed Idler...the engine. Lower the deck into the lowest position using the deck lift handle. Service Sitting behind the tractor...
Operation Manual - Page 30
... covers to the deck. Do not lose any of the belt guards to Deck Installation on page 27).
2. See Figure 7-8.
30
Section 7- Replacing the Belt
42" Deck
1. Belt Cover Hex Washer
Screws
Spindle Pulley
Spindle Pulley Idler Pulley Idler Arm
PTO Pulley
Belt Guards Idler Pulley
Figure 7-8
3. See Figure 7-10. Install...
Operation Manual - Page 32
...the top of the mower when the throttle is the slight forward or backward movement of the deck. 4. See your mower creeps, see an authorized service dealer. When servicing the mower deck, be removed... your authorized dealer. The blades may be removed and special tools used in the "OFF" position, engage the parking brake lever, turn the ignition key to the "OFF" position and remove the key...
Similar Questions
My Blades Will Not Engage.
When started it and engaged blades ran about 2 feet then blades quit. It's a 42 mustang zero turn. R...
When started it and engaged blades ran about 2 feet then blades quit. It's a 42 mustang zero turn. R...
(Posted by debocat53 10 months ago)
Used Mower After A Rest Wouldn't Start Replaced Battery & Soilnoid Still Wont St
(Posted by leafa280 2 years ago)
Not Turning Correctly
When driving straight or turning left or right the left rear wheel rotates at slower rate than the r...
When driving straight or turning left or right the left rear wheel rotates at slower rate than the r...
(Posted by wpwwe 8 years ago)
What Oil Filter Should I Use On Mustang 50 Zero Turn Mower
(Posted by Clcneale 9 years ago)
My Zero Turn Radius Is Killing Brand New Batteries. ..what's Wrong?
(Posted by rescuediver88 9 years ago)