Troy-Bilt TB625 Support Question
Troy-Bilt TB625 Support Question
Find answers below for this question about Troy-Bilt TB625.Need a Troy-Bilt TB625 manual? We have 1 online manual for this item!
Question posted by chowellwildcatmom on August 24th, 2014
What Kind Of Oil Do I Use
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Troy-Bilt TB625 Manual Pages
Operation Manual - Page 1
...ca (Canada). We reserve the right to obtain a list of printing. When servicing, use only identical replacement parts.
769-08457 / 02
All information, illustrations, and specifications in ...Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB625 EC
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 ...
Operation Manual - Page 2
... •
READ ALL INSTRUCTIONS BEFORE OPERATING
SAFETY WARNINGS FOR GAS UNITS
WARNING: When using the unit, all adjustments or repairs before filling the tank.
All U.S. Teens must...fuel tank cap or add fuel when the engine is factory equipped with the controls and proper use .
• Read the instructions carefully. Remove rocks, broken glass, nails, wire, string ...
Operation Manual - Page 3
... sleeve shirt. Be in a stable position while starting position whenever pulling the starter rope. Only use this tool for its intended purpose.
• Always hold the unit with a foreign object, ...both trimming lines extended and the proper line installed. Do not operate the unit before starting . Use of the shield.
• This unit has a clutch. SAVE THESE INSTRUCTIONS
3 Keep a ...
Operation Manual - Page 4
.... To prevent serious injury, do so can
cause severe eye injury and hearing loss. Read the operator's manual for the proper type of oil.
• DO NOT USE E85 FUEL IN THIS UNIT
WARNING: It has been proven that may get extremely hot from operation. When turned off they remain hot for...
Operation Manual - Page 5
...cu. We reserve the right to make changes at the time of printing.
Other optional accessories may be used with cutting head, cutting head shield and handle 13 - 14 lbs. (5.9 - 6.4 kg) Trimmer ...Diameter 17 in . (0.635 mm) Spark Plug Champion® RDZ4H or equivalent plug Lubrication SAE 30 Oil Crankcase Oil Capacity 2.03 oz. (60 ml) Fuel Tank Capacity 12 oz. (355 ml) Approximate Unit ...
Operation Manual - Page 6
...the bolt with a 3/8" socket, but do not tighten the bolt completely.
3.
Cutting Head Shield
Use the following instructions if the cutting head shield is firmly in the operating position (Fig. 14), move... the bolt with this unit.
1.
Push the handle down onto the shaft housing (Fig. 3). Use only the instructions that apply to the location that provides the best grip. Put the washer onto...
Operation Manual - Page 7
...holding the upper shaft housing, pull the attachment
straight out of various optional attachments.
Using the wrong hole could lead to personal injury or damage to assembling the attachment.... button with the attachment. Press and hold the release button (Fig. 5). 3. WARNING: Before using any attachment, read and
understand the manual that came with the guide recess will help installation (...
Operation Manual - Page 8
...: OVERFILLING THE CRANKCASE MAY
CAUSE SERIOUS PERSONAL INJURY. Reinstall the top of oil during future oil changes. Remove the cap from the oil bottle. This unit has a four- DO NOT use clean oil of the oil bottle. Change the oil according to use dirty oil. Unscrew the top of the correct type can cause premature engine wear and failure...
Operation Manual - Page 9
...USING THE RIGHT FUEL The use fresh unleaded gasoline • Use...unit
WARNING: DO NOT USE E85 FUEL IN THIS ...corrosion and minimize gum deposits. Using Fuel Additives Use a fuel additive, such ...additive per gallon of performance problems. Use only fresh, clean unleaded gasoline....Using Blended Fuels If using a blended fuel: • Always use... 30 days old).
ALWAYS use fresh fuel (less than ...
Operation Manual - Page 10
...
Continue to Position 1 (Fig. 11).
5. The unit may be used during this time.
The unit may be used during this time. Move the choke lever to Position 2, and run the...allow the engine to squeeze the throttle control. Check the oil level.
Fill the fuel tank. IF... perform steps 3 - 8 to Checking the Oil Level.
2. Refer to restart the engine. Continue to ...
Operation Manual - Page 11
.... 13
Electric Start Port
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to Fueling the Unit. USING THE ELECTRIC START ACCESSORY
This unit can be used during this time. Item No. Check the oil level. Insert the electric start accessory into the electric start accessory for 2-5 minutes, or as needed . Run...
Operation Manual - Page 13
...Spark Plug.
Refer to Maintaining the Air Filter.
• Change the oil. WARNING: Never use the correct line length when installing trimming line. These can break off and... injury, never perform
maintenance or repairs while the unit is complete. REPLACING THE TRIMMING LINE
Only use the trimming line described in the table. Refer to an MTD authorized service dealer. These procedures ...
Operation Manual - Page 14
... keep the engine level may have spilled. 5. NOTE: Failure to overfill. 3. Unscrew the oil fill plug. 3.
Removing Old Trimming Line and Obstructions If necessary, remove any old trimming line and/or obstructions from entering the oil fill hole. 2. Use a clean cloth to prevent debris
from the cutting head. 1. Push the spool cover onto...
Operation Manual - Page 15
... or can cause permanent damage to secure the air filter cover (Fig. 24). Cleaning the Air Filter
1. Remove the air filter from the initial use to pour the oil out of the bottle (Fig. 23). 6. Push the air filter cover back onto the air filter housing. Tighten the cover screw to the...
Operation Manual - Page 16
... control and let the engine idle. Grit in the cylinder head. Do not over tighten.
6. Refer to prevent serious personal injury. If the engine
stops, use a small Phillips screwdriver to turn the idle speed screw clockwise, 1/8 of a turn at 0.025 in. (0.635 mm) (Fig. 26).
5. Idle Speed Screw Fig. 25
0.025...
Operation Manual - Page 17
... the spark plug and put 5 drops of any loose or damaged parts. Thoroughly clean the unit and inspect it for Use after Long-term Storage
1. Refer to distribute the oil. Do not use or damage. • Store the unit in a horizontal position.
STORAGE
• Never store a fueled unit where fumes may reach an...
Operation Manual - Page 18
..., push the bump knob and pull the line until 4 inches (102 mm) is outside of the cutting head
THE CUTTING LINE ADVANCES UNCONTROLLABLY There is oil, cleaner or lubricant in the cutting head
Clean and thoroughly dry the cutting head
If further assistance is extended
Clean or replace the air filter...
Operation Manual - Page 20
... you specific legal rights, and you .) In no event shall recovery of any kind be liable for a particular purpose, applies after the applicable period of express written ... to use , neglect, accident, improper maintenance, alteration, vandalism, theft, fire, water or damage because of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services...
Similar Questions
How Do I Replace The Primer Bulb On Tb625 Ec
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
(Posted by Myers8708 2 years ago)
What Oil Should I Use?
What kind of oil and viscosity should I use for Troy-Bilt Squall 2100 snow blower?
What kind of oil and viscosity should I use for Troy-Bilt Squall 2100 snow blower?
(Posted by connectedtouch 6 years ago)
What Type Of Gas Do I Use, It Says No Mixing Oil And Gas. Same With Oil? What Ty
it says no mixing. It's a troy bilt TB625 EC WHAT GAS N WHAT OIL
it says no mixing. It's a troy bilt TB625 EC WHAT GAS N WHAT OIL
(Posted by cruzontiveros15 7 years ago)