Why Is Controller On Off Button Red? I Replaced The Batterys. Thanks

The red color on the on/off button of your Vivitar Aero View Drone's controller usually indicates that the controller is not properly connected or synced with the drone. It is important to ensure that the controller and drone are paired correctly for the drone to function properly. Here are a few steps you can try to troubleshoot the issue:

1. Turn off both the controller and the drone.

2. Turn on the drone first and wait for its indicator lights to stabilize.

3. Turn on the controller and look for any prompt or indicator lights that indicate it is attempting to connect to the drone.

4. Make sure that the controller and drone are within close range of each other to establish a good connection.

5. Try pressing and holding the pairing button on the drone (usually located on the body of the drone or near the battery compartment) and then press the corresponding pairing button on the controller if applicable.

6. Wait for the controller and drone to establish a connection, and the red color on the on/off button should change or turn off if the pairing is successful.

7. Once the connection is established, test the controls and see if the drone responds correctly to your commands.

If these steps don't resolve the issue, it's possible that there may be a deeper issue with either the controller or the drone. In that case, I would recommend contacting Vivitar's customer support for further assistance. They will be able to provide you with specific instructions or guide you through troubleshooting steps to resolve the issue.

---

"Hi there,

I hope my response was helpful in addressing your question or concern. If you found it valuable, I kindly ask you to consider accepting my answer by clicking the designated button. Your support will not only acknowledge my efforts but also guide others in finding useful solutions. Thank you for your trust and I'm ready to assist you further if needed.

Best regards,
Technicalproblemsolver"