Whirlpool WFW95HEXW Support Question
Whirlpool WFW95HEXW Support Question
Find answers below for this question about Whirlpool WFW95HEXW.Need a Whirlpool WFW95HEXW manual? We have 5 online manuals for this item!
Question posted by mmb9000 on December 3rd, 2011
The Door Is Locked And Will Not Unlock And The Washer Will Not Start
How do I unlock the front door. There is no water, as I just put the clothes in. The washer won't start and buzzes three times likes its trying to lock the door
Current Answers
Related Whirlpool WFW95HEXW Manual Pages
Dimension Guide - Page 1
... diameter for planning purposes only. Minimum siphon break: 28" (711 mm) from bottom of laundry tub must be needed.)
Laundry tub drain system
41/2" (113 mm)
min.
30" (762 mm)
Minimum capacity: 20 gal. (76 L). Top of washer. Because Whirlpool Corporation policy includes a continuous commitment to improve our products, we reserve the right...
Installation Instructions - Page 2
... mm)
Parts supplied:
NOTE: All parts supplied for some installations, not supplied with washer) Your installation may be shipped unassembled)
Transport bolt hole plugs (4)
Flashlight
Bucket
Available ... Care Guide. INSTALLATION REQUIREMENTS
Tools and Parts Gather required tools and parts before starting installation. Tools needed:
Optional tools:
Adjustable or open end wrenches 1⁄2" ...
Installation Instructions - Page 3
... of 315 lbs (143 kgs). Installing on all sides of installation and servicing, and spacing for companion appliances and clearances for closet door ventilation openings which are required. Water remaining in washer after use may cause damage in .2 (155 cm2)
1" (25 mm)
1" (25 mm)
Custom cabinet installation:
7" (178 mm)
14" (356 mm)
1" (25...
Installation Instructions - Page 4
... 1" (25 mm) diameter Standpipe Adapter Kit is available (Part Number 3363920). Minimum siphon break height: 28" (710 mm) from bottom of washer. (Additional hoses may be inside standpipe. Top of laundry tub must be at least 30" (762 mm) high; Top of standpipe must be at least 30" (762 mm) above floor...
Installation Instructions - Page 6
... the cord. Squeeze clamp with clamp. For a laundry tub or standpipe drain, go to avoid suspension and structural damage, a certified technician must properly set up washer for relocation.
6 Pull bolts and plastic spacers from
washer
6. C over top of washer to allow free access to center of washer. Gently place power cord over bolt holes with...
Installation Instructions - Page 7
... a few seconds through hoses into standpipe (shown in attaching hoses to remove the drain hose form from the end of laundry tub. Use pliers to hot water faucet. You may need to washer correctly.
HELPFUL TIP: Make note of which hose is seated on bottom of drain hose should run until it is...
Use & Care Guide - Page 4
...
A
C Chlorine bleach
1 POWER BUTTON Press to turn the washer on your washer. See "Cycle Guide" for your Wash Cycle Knob to 16...time.
2 WASH CYCLE KNOB Use your laundry load.
CONTROL PANEL AND FEATURES
Not all features and cycles are available on non-Steam models.
4 Turn the knob to select a cycle for detailed descriptions of cycles.
3 START/PAUSE BUTTON Press and hold to start...
Use & Care Guide - Page 5
...locked or if you can be added to the HE detergent compartment along the bottom of the display to adjust settings. Press the POWER/CANCEL button to stop the cycle and unlock the door...cycle. Spin Speed This washer automatically selects the spin speed...water usage and maintains cleaning performance by pressing and holding for 3 seconds, then pressing START/PAUSE.
Soil Level Soil level (wash time...
Use & Care Guide - Page 8
... the washer door by recommended cycle, water temperature, and colorfastness. Washer door should close easily. Follow the manufacturer's instructions to determine the amount of detergent to produce the right amount of sorted clothes loosely in component failure and, over time, build-up lint from lightly soiled. n Mend rips and tears to avoid further damage to your laundry
Sort...
Use & Care Guide - Page 11
... garments, you will change the Estimated Time Remaining.
Press START/PAUSE once; This will show the default settings for the selected cycle.
If desired, press the button beneath each setting to set the desired delay time.
2.
8. Select CYCLE
11. Adjusting the Soil Level will hear the door lock, unlock, and lock again. Overloading, unbalanced loads, or excessive...
Use & Care Guide - Page 12
... models) This will count down in the last rinse. Once the door has locked the second time, the washer will unlock briefly before locking again. You may also hear water flowing through the washer. The displayed time may pause the washer, open the door, and add items.
Sensing When the START/PAUSE button is set, the Delay Set indicator will light and...
Use & Care Guide - Page 13
... using liquid chlorine bleach, add 1 cup (250 mL) to avoid water leaks. NOTE: The basket will rotate, then the door will unlock, lock again, and then the cycle will light. If any wash cycle is selected, the washer will proceed to avoid damaging product over time.
3.
To clean exterior:
1. R emove garments promptly
after cycle has completed...
Use & Care Guide - Page 14
...water. If stained areas are found, wipe down on dispenser. 7.
WASHER MAINTENANCE
CLEANING THE DISPENSER
You may find laundry product residue leftover in warm, soapy water, using a damp cloth...dispenser with warm water. 6. Open the washer door and remove any clothing or items from the washer.
2. Seal
3.
d) W ipe down area thoroughly with a dry cloth and let the
washer interior air ...
Use & Care Guide - Page 15
... to mix antifreeze and remaining water. 3. TRANSPORTING YOUR WASHER
1. Reconnect water inlet
hoses. Shut off both water faucets.
2. REINSTALLING/USING WASHER AGAIN
To reinstall washer after non-use washer again: 1. WINTER STORAGE CARE
IMPORTANT: To avoid damage, install and store washer where it must be properly set up for a period of time, follow WINTER STORAGE CARE directions...
Use & Care Guide - Page 16
...keeping the door from closing completely.
Press POWER once to restart washer. TROUBLESHOOTING
First try the solutions suggested here or visit our website at least 3 cycles.
F8E1 (water supply
... described above the floor. F5E2 (door will not lock) Washer door not locking.
Use only HE detergent. Press POWER/CANCEL to drainpipe or tub.
Door has not been opened and closed ...
Use & Care Guide - Page 17
... to drainpipe or laundry tub. Noises
Clicking or metallic noises
The shipping bolts are removed during "Add A Garment."
Door locking or unlocking. Avoid washing single items. Balance a single item such as coins could be draining water. See "Cycle Guide" and "Using Your Washer" in washer drain system. The door will hear three clicks after the start .
Check household plumbing...
Use & Care Guide - Page 18
... items after cycle has started to possibly avoid a service call an electrician to run or fill, Check for proper water supply. Washer will pause during certain cycles. Washer may be attached and have not become clogged. Washer not loaded as expected (cont.)
Washer won't run .
Some cycles feature periods of cycle. TROUBLESHOOTING
First try the solutions suggested...
Use & Care Guide - Page 19
...START/PAUSE once. For best performance, not all cycles.
Check drain hose for each cycle.
19
See "Installation Requirements." Using cycles with tape. The load may not allow the washer to drainpipe or tub.
Door will not unlock Incorrect or wrong wash or rinse temperatures
Warm* selection not available
Water remaining in the washer... above the floor.
Door locked at the end of...
Use & Care Guide - Page 21
... experience
Possible Causes
Washer not performing as recommended. Avoid overfilling. Not washing like colors together and remove promptly after use more than recommended by manufacturer.
To avoid odors, leave the door open after the cycle is adequate to provide a hot water wash. Empty pockets, zip zippers, and snap or hook fasteners before starting a cycle.
Use...
Use & Care Guide - Page 22
... suds routine automatically starts to redistribute the load with low water pressure may be out of balance. First try the solutions suggested here or visit our website at the end of the cycle.
Homes with additional tumbling. Load may use powdered or liquid laundry boosters in washer. This extends the cycle time. When using correct cycle...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
The cycle time is not correct - Cabrio® washer with agitator
... is not able to remove the excess suds. Top-load washer Display shows Sud or Sd - Does the time displayed show one value for a long time? Consider using cold water. Press Start. Do not add detergent. Product Recall Information washer with agitator The cycle time on : detergent type, size and type of excessive suds or... -
Cycle time is not correct - Duet® Steam washer
...light will not start - Is "Sud" displayed? When "Sud" is not able to redistribute the laundry load in the washer may be turned on. The heating time depends on :... detergent type, size and type of load, cycle selection, and household water temperature and pressure... -
How to get the best performance from my washer - Cabrio® HE washer with Dispensers in Corners
...for the best cleaning and shortened dry times. Quick Wash Use this cycle. ...160;This cycle starts with Dispensers in Corners Loads are needed in Corners Washer will increase ... business clothes, permanent press and blends. Warm water also helps reduce wrinkling. Cabrio® Try mixing ...Use this cycle is not cleaning laundry - This cycle uses medium-speed wash action...
Similar Questions
My Washer Just Under 30 Days , Maybe Used 5 Times. Started A Wash Last Night, O
opened lid to stop from filling to gather my clothes. All the water had drained out and just made no...
opened lid to stop from filling to gather my clothes. All the water had drained out and just made no...
(Posted by rwtaylor7678 6 years ago)
Washer Is Frozen With Door Lock Light Flashing.
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
I only had this washer delivered on Tuesday. In the middle of a cycle, it froze and the door lock li...
(Posted by wendyfinn892 9 years ago)
Door Wii Not Lock Unless You Shove On The Washer Twice Hard.
I have already changed the switch with no results
I have already changed the switch with no results
(Posted by garrywcastle 11 years ago)
Quiet Partner Ll Locked Button Blinks 3times But Washer Will Not Turn On
(Posted by Dmorganpca12 11 years ago)