Whirlpool WRS526SIAE Support Question
Whirlpool WRS526SIAE Support Question
Find answers below for this question about Whirlpool WRS526SIAE.Need a Whirlpool WRS526SIAE manual? We have 3 online manuals for this item!
Question posted by rrcharolais on November 20th, 2017
Refridgerator Temperture Is Too Cold.
I have the fridge temp set at 45 degrees F..but it is freezing everything
Current Answers
Answer #1: Posted by Odin on November 20th, 2017 10:27 AM
Odin
Member since:
April 10th, 2010 Points: 41,236,630
Member since:
April 10th, 2010 Points: 41,236,630
Hope this is useful. Please don't forget to click the Accept This Answer button if you do accept it. My aim is to provide reliable helpful answers, not just a lot of them. See https://www.helpowl.com/profile/Odin.
Related Whirlpool WRS526SIAE Manual Pages
Use & Care Guide - Page 1
...;PANNAGE 59 ACCESSOIRES 62 FEUILLE DE DONNÉES SUR LA PERFORMANCE 63 GARANTIE 64
REFRIGERATOR SAFETY
Your safety and the safety of injury, and tell you what the potential hazard...These words mean:
DANGER
You can kill or hurt you still need your appliance.
REFRIGERATOR USER INSTRUCTIONS
THANK YOU for additional information. You will tell you how to potential hazards...
Use & Care Guide - Page 2
...if exposed to avoid dropping.
2
even if they are cold.
Failure to move it . Always pull the refrigerator straight out when moving the refrigerator for "just a few days." Do not use an ...they will sit for cleaning or service, be evacuated by a licensed, EPA certified refrigerant technician in back or other injury. Use both hands when removing them to sudden temperature...
Use & Care Guide - Page 3
...future reference. NOTE: Before moving your product into your home, measure the doorway of Fitting
8 Leveling
A B
1 Base Grille
Raise
Lower C
A. P-clamp B. Grommets F. Leveler Bracket
C. Unplug refrigerator or disconnect power. Failure to 90˚
A
Raise
Lower
A. IMPORTANT: Before you need to see the instructions below. Wiring Clip E. Door Removal, Leveling and...
Use & Care Guide - Page 4
... other injury.
2. IMPORTANT: Do not remove either screw A.
10.
Failure to move
the refrigerator through the hinge.
Finally, gently pull the wiring bundle (including the grommet and wiring plugs)...routing plate. 6. Remove food, the ice storage bin, and any gaps between the refrigerator, leveler bracket and hinge. The dispenser tubing runs through the bottom left hinge screws as...
Use & Care Guide - Page 5
...want the doors to the electrical housing, then push the housing back under the refrigerator.
Door Alignment
A refrigerator that the wiring runs behind the right side of the routing plate. If the...bundle.
■ Reconnect the wiring plugs to close as easily as shown. To raise the refrigerator door, turn the screw to the screw hole). Handle Installation and Removal
Style 1 -
...
Use & Care Guide - Page 6
...firm pressure on a towel or other handle onto the freezer door with the setscrews facing the refrigerator.
9. Apply only downward pressure.
3. Lift the handle directly upward, and pull it is... the other soft surface.
2. Style 2 - Remove the handles, which are packed inside the refrigerator.
Place the handle on the shoulder screws, which are mounted on
PARTS INCLUDED: Door handles (2)...
Use & Care Guide - Page 7
... about your cold water supply, the water pressure to the ...in areas where the household temperatures will remain above freezing. Recommended Grounding Method A 115 volt, 60 Hz...provides superior cooling, is important to the desired setting.
Reverse Osmosis Water Supply IMPORTANT: The pressure... of the refrigerator needs to remove the crisper pans is desired, an additional 18" (45.72 cm)...
Use & Care Guide - Page 8
... or disconnect power.
2. Tighten the compression nut. This will remain above freezing.
5.
Compression nut
C
C. Copper tubing
D E
D. Valve inlet NOTE: Always drain the water line before starting installation. Connect to refrigerator) D. Turn ON nearest faucet long enough to refrigerator B. Line to clear line of the water valve, to avoid possible water valve malfunction...
Use & Care Guide - Page 9
...result in order to connect the water tubing to maintain a cleaner environment inside the refrigerator. Installing the Filter Status Indicator (on some models, there are
notches behind the ...the back of the indicator, until
the bubble pops to produce the first batch of the refrigerator.
3. Then tighten it in water strainer. Do not overtighten.
Coupling (purchased)
E. Household ...
Use & Care Guide - Page 10
...filter door, and check that the indicator is installed.
Place both pouches inside the refrigerator, or elsewhere in order to remove it from white to red. DANGEROUS FUMES FORM ...WHEN MIXED WITH OTHER PRODUCTS. Replacing the Produce Preserver (on the housing in your refrigerator's accessory packet includes a Produce Preserver, which should be replaced every 6 months, when...
Use & Care Guide - Page 11
...; Press and hold the TEMP button for the refrigerator is too warm or too cold in adjust mode, or allow about 60 seconds of a control button will re-enter "sleep" mode. ■ Touch any settings.
When adjusting temperature set points, use the following chart as shown. REFRIGERATOR USE
Using the Controls
The refrigerator and freezer controls are...
Use & Care Guide - Page 12
... to the right (less cold), toward the VEG setting. When the
feature is cooled to avoid "spot" freezing and can be displayed on some foods, such as ice cream, harder. 6th Sense™ Temperature Management The 6th Sense™ feature assists with regulating the temperature inside of the refrigerator, press any setting between adjustments. Dual...
Use & Care Guide - Page 13
...will only reactivate the display screen, without changing any settings can produce both crushed and cubed ice. This may continue to the refrigerator is lower than 8 seconds to produce the first ... result in greater quantities.
3.
While in 8 seconds or less, the water pressure to the refrigerator meets the minimum requirement.
■ If it could be caused by small children and pets....
Use & Care Guide - Page 15
... models, the interior lights are removed.
5. You may occur. Flush the water system. REFRIGERATOR CARE
Cleaning
WARNING
3. Wash stainless steel and painted metal exteriors with a clean sponge or soft...the O-rings are LEDs that cannot be replaced at least every 6 months, depending on your refrigerator.
■ Use a vacuum cleaner with warm water and liquid detergent.
Hand wash, rinse...
Use & Care Guide - Page 16
...sticky? Failure to coldest setting will not cool either in the User Instructions or the separate instruction sheet provided with an explanation. ■ Buzzing - The refrigerator rocks and is added,...defrost cycle ■ Popping - Do not use an adapter. contraction/expansion of the refrigerator ■ Sizzling/Gurgling - may hear intermittent noises from your old model.
The ...
Use & Care Guide - Page 17
... for the surrounding conditions? Check temperature in the ON position.
■ New installation? Allows humid air to enter refrigerator. Make sure wire shutoff arm or switch (depending on continuously, set the dispenser light to
your cold water supply? See "Water Supply Requirements." Straighten the water source line. ■ Reverse osmosis water filtration system...
Use & Care Guide - Page 18
... the dispenser arm been held in the home water source line?
If it does not close completely, see "The doors will not close completely."
■ Refrigerator connected to a cold water pipe? The water pressure to the home determines the flow from the dispenser
NOTE: One or two drops of water.
■...
Use & Care Guide - Page 19
Substance Reduction Aesthetic Effects
Chlorine Taste/Odor
Particulate Class I *; Style 3 -
D. Temp. = 68°F to 71.6°F (20°C to 108 fibers/L††
0.15 mg/L ... filter indicator changes from "GOOD" to When the indicator changes from yellow to red, it is for cold water use with water that may be carried out for the product to yellow, order a new filter....
Use & Care Guide - Page 20
...or workmanship that vary from state to state or province to province. Service calls to refrigerator or freezer product failures.
7. Cosmetic damage, including scratches, dents, chips or other than... of your correspondence. Replacement parts or repair labor on the inside wall of the refrigerator compartment. Some states and provinces do not have other rights that is inconsistent to ...
Warranty Information - Page 1
... Home Appliances Customer eXperience Centre 200 - 6750 Century Ave. Proof of the refrigerator compartment. Replacement parts or repair labor on the inside wall of original purchase ...provided by an authorized Whirlpool servicer is inconsistent to you . Service calls to refrigerator or freezer product failures.
7. Consumable parts are excluded from unauthorized modifications made to...
Whirlpool Knowledge Base Results
We have determined that the information below may contain an answer to this question. If you find an answer, please remember to return to this page and add it here using the "I KNOW THE ANSWER!" button above. It's that easy to earn points!-
Refrigerator or freezer not cold enough
... vents are blocked by food items, airflow will decrease, which should not be less cold than interior-shelf items. Make sure the air vents between the freezer and refrigerator compartments are preset at the factory to "mid-settings," which will exceed 110°F or drop below 55°F. Temperatures of freezer temperatures... -
Temperature Control, French Door with Ice Bin in the Door
... up arrow to -15°C). Bottom freezer/French door refrigerator Too cold in the Door How do I adjust the temperature control? To view set point range for the refrigerator. The factory recommended set points are not blocked before other adjustments are set point. The set points, press the TEMP button on the dispenser control panel has a backlight, which... -
Using the LCD refrigeration controls - Side by Side with Ice Bin in Door, Flush Mounted Dispenser with LCD Display
.... Wait at the factory. The set point range for the freezer. Touch any settings can then be correct for 3 seconds. The factory recommended set point and "FRIDGE" appears. When adjust mode is activated, the display screen shows the refrigerator set points are still set point. lower FREEZER too cold FREEZER Setting 1° Temperature Control, French Door...
Similar Questions
Ed2dhexw Oo Two Door Refrigerator: Freezer Frosting; Fridge Not Working.
My ED2DHEXW OO side by side two door refrigerator is faulty: freezer frosting; fridge not working. C...
My ED2DHEXW OO side by side two door refrigerator is faulty: freezer frosting; fridge not working. C...
(Posted by joedep 7 years ago)
Fridge Temp Not Good
Fridge Will not get below 50 degrees. Freezer works fine.
Fridge Will not get below 50 degrees. Freezer works fine.
(Posted by terryosborne16 9 years ago)
Whirlpool Sidebyside Mod.gssx26 Is Freezing In The Fridge Side. Temp Set 45max
Fridge is 18 month old and will not stop freezing everything. Have set temps to the max on both side...
Fridge is 18 month old and will not stop freezing everything. Have set temps to the max on both side...
(Posted by grladue 11 years ago)
Water Dispensed By My Whirlpool Side By Side Fridge (gss30c6eyy) Is Not Cold.
Replacement for old fridge with ice and water 1 week ago. Ice and water dispense fine but water is 6...
Replacement for old fridge with ice and water 1 week ago. Ice and water dispense fine but water is 6...
(Posted by yeazel 12 years ago)
Fridge Temp
When I try to turn up the temp for the fridge all lights light up and the temp will not rise. The te...
When I try to turn up the temp for the fridge all lights light up and the temp will not rise. The te...
(Posted by kfritchm 13 years ago)