Dewalt D55167 Support and Manuals
Get Help and Manuals for this Dewalt item
View All Support Options Below
Free Dewalt D55167 manuals!
Problems with Dewalt D55167?
Ask a Question
Free Dewalt D55167 manuals!
Problems with Dewalt D55167?
Ask a Question
Most Recent Dewalt D55167 Questions
Is There A Compressor Motor Reset Button On This Model D55167
Where is it located on the unit? Thank you
Where is it located on the unit? Thank you
(Posted by Davidhokanson 3 years ago)
Reset Button For Dewalt D55167 Compressor
My desalt compressor, d55167, after unplugging and re plugging the compressor. Is there a reset butt...
My desalt compressor, d55167, after unplugging and re plugging the compressor. Is there a reset butt...
(Posted by sowhing 7 years ago)
Popular Dewalt D55167 Manual Pages
Instruction Manual - Page 2
... Drain Valve
(not shown) I )/Off(O) Switch B. English
D55167 Air Compressor
A. Safety Valve H. Regulated Pressure Gauge D. Air Intake Filter
Pump/Motor Specifications
Voltage: Single Phase 120V Minimum branch circuit requirement: 15 A Fuse Type: Time delay
Specifications
MODEL WEIGHT HEIGHT WIDTH Length Air Tank Capacity APPROX CUT-IN PRESSUre Approx. CUT-OUT pressure scfm @ 90 psi Noise...
Instruction Manual - Page 3
... TOLL FREE AT: 1-800-4-DeWALT (1-800-433-9258)
Important Safety Instructions
WARNING: Do not operate this unit until you read the manual and pay attention to these instruction
DANGER: Risk of hose may ignite, causing fire or explosion.
• If spraying flammable materials, locate compressor at least 20 feet (6.1 m) away from compressor.
3
An additional length of...
Instruction Manual - Page 5
... to withstand specific operating pressures. Attachments & accessories: • Exceeding the pressure
rating of air tools, spray guns, air operated accessories, tires, and other components which include operating conditions, ambient conditions, proper installations, field modifications, and the level of the steel air tank.
• Drain air tank daily or after each use compressor to repair...
Instruction Manual - Page 7
...result in moving parts.
• Air vents may cover moving parts. English
• Always turn the compressor off and bleed pressure from moving parts and should be performed by a DeWALT factory service center or a DeWALT authorized service center.
7
Loose clothes, jewelry, or long hair can result in serious injury.
• Any repairs required on compressor during or immediately...
Instruction Manual - Page 8
...;eration of your air • Review and understand all
compressor could result in serious injury or death to the operator.
• Always operate compressor in
serious injury or death to you this manual.
How to prevent it
• The compressor is too heavy to reach high...
Instruction Manual - Page 9
... motor when the
air tank pressure drops below the factory set cut -out
setting).
It is controlled by popping out at the end of each
use .
Cooling System
H
This compressor ...regulated Pressure Gauge
The outlet pressure gauge (C) indicates the air pressure available at the air outlet.
9
English
SAVE THESE INSTRUCTIONS FOR FUTURE USE
Features (Fig. 1)
Auto/Off Switch...
Instruction Manual - Page 10
....
The portable air compressor is seated. K
IMPORTANT: The outlet being used has the same configuration as to whether the compressor is designed to clean air entering the pump.
Motor Overload Protector The motor has a thermal overload protector. The motor must
be properly
grounded. Plug the power cord into the quick connect body (E). INSTALLATION
Assembly
Installing Hoses...
Instruction Manual - Page 11
...fuses. Observe extension cord safety instructions if necessary. CAUTION: Certain air compressors can occur to change the cord set. Time delay fuses should be met, or if operation of the compressor repeatedly causes interruption of hose... comply with the National Electrical Code.
• Circuit is not used to the Voltage and Minimum Branch Circuit Requirements under Pump/Motor Specifications.
Instruction Manual - Page 12
... (A) is drained, see Checking Safety Valve under Installation.
3. Warning: Risk of property damage. Operating Procedures
Start-up a ramp.
1. NOTICE: Risk of unsafe operation. See Regulator under Features. Preparation For Use
WARNING: Do not operate this instruction manual for Use.
2. NOTE: Always use caution when rolling compressor so that could be lifted or pushed up...
Instruction Manual - Page 13
...)
Checking Safety Valve
Warning: Risk of bursting.
Wipe air compressor clean and store in place.
3. Maintenance
The following procedures must be performed by a DeWALT factory service center or a DeWALT authorized service center. Push knob in to make reassembly easier. Firmly grasp air hose in this section should be disposed of parts during disassembly to lock in a safe, non...
Instruction Manual - Page 14
...be disposed of Purchase
Repairs
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment should be hazardous. Purchase replacement parts
from noise. Close drain valve when finished. NOTICE: Risk of air tank rupture. NOTE: All compressed air systems generate condensate that accumulates in any accessory for all service calls: Model Number Serial Number Date...
Instruction Manual - Page 15
... ADJUST FACTORY SETTINGS. SEE MANUAL FOR INSPECTION PROCEDURES. LA ACUMULACIÓN DE CONDENSACIÓN PUEDE OCASIONAR CORROSIÓN DENTRO DEL TANQUE Y PROVOCAR FALLA DEL TANQUE. Cut-In Pressure: While the motor is off is turned on and begins to accessories or damage caused where repairs have been evaluated by others. Duty Cycle: This air compressor pump...
Instruction Manual - Page 16
... off air outlet 13
Motor will not run...6, 14, 15, 16, 17, 18, 19, 20
Squealing Sound...21
Troubleshooting Codes
Code possible cause
POSSIBLE SOLUTION
1
Pressure switch does not shut off motor when
compressor reaches cut-out pressure
Set the Auto/Off switch to OFF, if the unit does not shut off contact a DeWALT factory service center or a DeWALT authorized service center...
Instruction Manual - Page 17
...Check the accessory air requirement. Replace air hose.
Operate safety valve manually by your air compressor, a larger compressor is used .
Contact a DeWALT factory service center or a DeWALT authorized service center.
Remove, clean or replace. Replace. If motor overload protection trips frequently, contact a DeWALT factory service center or a DeWALT authorized service center.
17...
Instruction Manual - Page 18
... from circuit or operate
the compressor on internal motor parts
20
Fuse blown, circuit breaker tripped
21
Worn Belt
22
Restricted air intake filter
POSSIBLE SOLUTION
Motor will start automatically when tank pressure drops below cutin pressure of Explosion or Fire warning under Installation. Contact a DeWALT factory service center or a DeWALT authorized service center. Refer to the...
Dewalt D55167 Reviews
We have not received any reviews for Dewalt yet.