Fender 3014 Support and Manuals
Get Help and Manuals for this Fender item
Fender 3014 Videos
Edge 3 ilevel by Quantum Rehab Review #3014 - Marc's Mobility
Duration: 13:17
Total Views: 1,358
Duration: 13:17
Total Views: 1,358
[GearTimes 3014?] ????? Ibanez ??? SRMD200
Duration: 13:29
Total Views: 1,689
Duration: 13:29
Total Views: 1,689
2015 Jeep Wrangler Northbrook, Arlington Heights, Deerfield, Schaumburg, Buffalo Grove, IL 3014
Duration: 1:58
Total Views: 6
Duration: 1:58
Total Views: 6
Farm band 3014
Duration: 3:49
Total Views: 45
Duration: 3:49
Total Views: 45
Popular Fender 3014 Manual Pages
Owners Manual - Page 3
... and 3018) 2-4-5. LIMIT LED (3016 and 3018)
3. INITIAL CONTROL SETTINGS 4-1-1. GRAPHIC EQUALIZERS 4-1-5. LEVEL CONTROLS 4-1-2. MONITOR REVERB CONTROL (3016 and 3018) 2-3-6. MONITOR LEVEL CONTROL 2-3-3. PATCHING
5. CHANNEL TONE CONTROLS 2-2-3. EFF SEND CONTROL 2-3-7. TABLE OF CONTENTS
1. SPECIFICATIONS
2. GRAPHIC EQUALIZER 2-4. POWER LED 2-5-2. OVERVIEW 1-1. MASTER SECTION...
Owners Manual - Page 4
... to be "on to provide reliable service in a standard configuration that senses amplifier error due to a very potent 350 watts. The power amplifier in 3014 is capable of microphones and speakers, the Fender powered mixer is provided with features and performance generally found only in various combinations, and for easy setup and simple but versatile operation. To...
Owners Manual - Page 7
.... All channel level controls set at 5, tone controls at 0, graphic controls centered, master volume at rated output level. SPECIFICATIONS.
MAIN OUT:
GRAPHIC OUT:
SIGNAL TO NOISE RATIO: 3014:
3016/3018:
DISTORTION:
THD...than .05%
less than 1%
36 dB
FREQUENCY RESPONSE: (Power Amplifier) +0/-0.25 db, 20 Hz to 20 kHz
SLEW RATE: 3014:
3016/3018:
MAXIMUM INPUT LEVELS:
Low Z input, level control ...
Owners Manual - Page 8
...VRMS. When used (see Section 4-4). FRONT PANEL CONTROLS, JACKS AND LEDs.
2-1. The three-pin audio connectors (often called "XLR" or "... boominess or sibilance ("s" sounds) by avoiding extreme tone control settings. See Section 4-1-1.
2-2-2. The LOW and HIGH controls on the... Main:
Monitor, Equalizer: Effects Out:
3014
3016/3018
3.6K ohms
3.6K ohms
33K ohms
33K ohms
27K ohms
4.7K...
Owners Manual - Page 9
...MAIN LEVEL control also determines the graphic equalizer and power amplifier input levels.
2-3-2. The equalizers consist of the AUX ...high pass shelving filter with the EFF SEND control.
2-3-7. The 3014 contains a five-band graphic equalizer, and the 3016 and ... in live sound reinforcement applications. The mix created by the settings of a channel's signal is patched into the AUX IN ...
Owners Manual - Page 10
...amplifier (see Section 4-5).
2-4-2. Care must be used to insure that the amplitude of the return signal is sent both to the reverb driver...patching more power amplifiers into the MAIN OUT jack does not interrupt the normal signal flow. In the 3014, this mix ...signal to other pieces of Graphic Equalizer is controlled by the settings of a preamp channel as a line level preamp channel,...
Owners Manual - Page 11
...amplifier just enough to the Fender powered mixer is turned on and off by the phone plug becomes the power amplifier's input. Do not remove the grounding prong of your Fender powered mixer. LEDs.
2-5-1. The red LIMIT LED...system is the front panel "power on for power amplifier. If the limiter is on " indicator.
2-5-2. The 3014 power amp is connected to the SPEAKER OUTPUT, as ...
Owners Manual - Page 12
..., do not restrict airflow to the heatsink.
4. SETUP AND OPERATION.
FIGURE 1 illustrates the simplest way to authorized service personnel.
3-4. Before attempting to replace a blown fuse, TURN THE POWER SWITCH OFF and check all input and output cables to be a problem with the load or with it to set up your PA system. HEATSINK. The fuse...
Owners Manual - Page 13
..., guitar amp mics and other fullrange signals are critical for the error. For starters, most pleasing sounds, but the settings listed above should then be adjusted to bring the volume of the... up CAUTIOUSLY until the stage monitor volume is amplified enough (in the monitors; some of gain from the speakers; CHANNEL EQUALIZATION. The LIMIT LED on the 3016 and 3018 should help in ...
Owners Manual - Page 14
...until you would normally use it will take some trial and error -the first ringing usually occurs between 1 kHz and 4 ... your speaker impedance, use Figure 3. If feedback occurs during setup, reduce the gain of the signal frequencies before feedback has...amplifier outputs to the rest of the mixer with balanced lines as such settings impair intelligibility.
6. MICROPHONE CORDS: On the 3014...
Owners Manual - Page 16
...PATCHING. doing so may be obtained by using a Switchcraft connector (part #S3FM) with MAIN signal patch
a. Make sure the EFF/...etc).
This
method allows the device return to use a second power amplifier for guitar, with a line level signal, such as possible.
...-device OUT to POWER AMP IN (3016, 3018) or GEQ IN (3014). Signal Processing device in such cases is possible. A 30 dB pad...
Owners Manual - Page 17
...overtighten.
• If you leave the mixer set up when you years of trouble-free service.
therefore, any problems should be overemphasized. 5. The Fender 30XX Series powered mixers have been designed to ...soft cover.
• DO NOT SET FOOD OR DRINKS ON THE SX POWERED MIXER -this point can help to give you are no user-serviceable parts in the Fender 3014, 3016 or 3018 powered mixers;...
Fender 3014 Reviews
We have not received any reviews for Fender yet.