Fluke A3000FC Support and Manuals
Get Help and Manuals for this Fluke item
View All Support Options Below
Free Fluke A3000FC manuals!
Problems with Fluke A3000FC?
Ask a Question
Free Fluke A3000FC manuals!
Problems with Fluke A3000FC?
Ask a Question
Popular Fluke A3000FC Manual Pages
Safety Information - Page 1
...Clamp
Safety Information
Go to www.fluke.com to prevent incorrect measurements. • Have an approved technician repair the Product. • Use only specified replacement parts... fire, or personal injury: • Carefully read all instructions. • Use the Product only as specified, or the... and national safety codes.
Hazardous voltage exposure is damaged. • Do not use , examine...
Safety Information - Page 2
...European Union directives. See Manual.
Hazardous voltage
CAT III
CAT IV
Double insulation
Battery
Measurement Category III is applicable to test and measuring circuits connected to the distribution part of the building's low-voltage MAINS installation.
Conforms to Fluke's website for an extended period. • Repair the Product before use...
Safety Information - Page 3
...Service Center with a description of liability may not apply to extend any other warranty on Fluke's behalf.
Fluke Europe B.V. THIS WARRANTY IS YOUR ONLY REMEDY. Resellers are not authorized to you.
FLUKE...damages, this limitation of the problem. Box 1186 5602 BD Eindhoven The Netherlands
11/99 LIMITED WARRANTY AND LIMITATION OF LIABILITY
This Fluke product will be free from ...
Calibration Manual - Page 1
All rights reserved. All product names are subject to change without notice. a3000 FC
Wireless AC Clamp
Calibration Manual
July 2014
© 2014 Fluke Corporation. Specifications are trademarks of their respective companies.
Calibration Manual - Page 2
... damaged by accident or abnormal conditions of repair/replacement parts when product purchased in material and workmanship under normal use and service. Fluke assumes no authority to extend a greater or different warranty on non-defective media.
Fluke Corporation P.O. Box 1186 5602 BD Eindhoven The Netherlands
11/99 Warranty support is available only if product is three years...
Calibration Manual - Page 4
a3000 FC
Calibration Manual
ii
Calibration Manual - Page 6
a3000 FC
Calibration Manual
iv
Calibration Manual - Page 8
a3000 FC
Calibration Manual
vi
Calibration Manual - Page 9
... see the a3000 FC Quick Reference Guide for the a3000 FC Wireless AC Clamp (the Product). Contact Fluke
To contact Fluke, call one of the following telephone numbers: • Technical Support USA: 1-800-44-FLUKE (1-800-443-5853) • Calibration/Repair USA: 1-888-99-FLUKE (1-888-993-5853) • Canada: 1-800-36-FLUKE (1-800-363-5853) • Europe: +31...
Calibration Manual - Page 10
... all instructions. • Use the Product only as specified, or the protection
supplied by the Product can be closed and locked before you
operate the Product. • Replace the batteries when the low battery indicator shows
to prevent incorrect measurements. • Have an approved technician repair the Product. • Use only specified replacement parts. •...
Calibration Manual - Page 12
...is applicable to Fluke's website for recycling information.
4 Table 1.
See Manual. Measurement Category ...installation. a3000 FC
Calibration Manual
Symbols
The symbols in Table 1 are used on the Product or in this product is classed as unsorted municipal waste. Conforms to the distribution part of Danger. Conforms to the equipment types in the WEEE Directive Annex I, this manual...
Calibration Manual - Page 14
... Display
hby002.eps
If segments of the display segments are missing, repair is necessary for performance tests and calibration adjustment. a3000 FC
Calibration Manual
Required Equipment
The equipment in Table 2 is necessary. Push while you keep pushed until all segments of each function against Product specifications. Equipment Calibrator Wired coil
Table 2.
Calibration Manual - Page 16
a3000 FC
Calibration Manual
Conductor
50-Turn Current Coil
5522A
NORMAL
V, , RTD
AUX
A, -SENSE, AUXV
SCOPE 150VPK
MAX
HI
1000V RMS MAX
LO
20V PK MAX
1V PK MAX
TC
20V RMS MAX TRIG
OUT
20V PK MAX
20V PK
MAX
+/
0
•
Figure 3. Performance Test Connections
hby07.eps
8
Calibration Manual - Page 17
...61505; pushed until CAL is shown. To use the maintenance mode:
1. To enter the password:
1. The first "?" Push to change the flashing "?" Maintenance Mode The Product...the "Restore the Default Password" section. Wireless AC Clamp
Before Calibration Adjustment
Before Calibration Adjustment
Before the Product calibration can be used to set different parameters on the ...
Calibration Manual - Page 18
...
Figure 4. a3000 FC
Calibration Manual
Restore the Default Password If the calibration password is lost, the default password (1234) can be manually restored with the subsequent steps:
Warning
To prevent electric shock or personal injury, remove all input signals before you open the Product.
1.
See "Battery Replacement".
2. Remove the Product battery door. Two...
Fluke A3000FC Reviews
We have not received any reviews for Fluke yet.