Icom A220 Support and Manuals
Get Help and Manuals for this Icom item
Popular Icom A220 Manual Pages
Instruction Manual - Page 1
Operation is subject to the condition that this device does not cause harmful interference. INSTRUCTION MANUAL
VHF AIR BAND TRANSCEIVERS
iA220 iA220E
This device complies with Part 15 of the FCC Rules.
Instruction Manual - Page 2
...harmful interference to part 15 of ...A220 and IC-A220E. If disregarded, inconvenience only. Icom, Icom Inc. This in which case the user will be required to comply with the instruction manual, may occur.
S'il n'a pas été installé conformément aux instructions, il peut par ailleurs créer des interférences perturbant les communications radio. struction manual...
Instruction Manual - Page 5
...do so. A proper antenna is met, the installation of the time can cause FCC RF exposure compliance ...radio by the manufacturer or an antenna specifically authorized by individuals aware of total radio use time ("50% duty cycle"). This radio...ensure that your Icom radio generates RF energy that are posted to bystanders. SAFETY TRAINING INFORMATION
Your Icom radio generates RF electromagnetic ...
Instruction Manual - Page 9
... with the ac- PANEL DESCRIPTION 1
r FREQUENCY EXCHANGE (FLIP-FLOP) SWITCH [e]
■■Rear panel
01
➥ Push to 'INSTALLATION GUIDE' for details.
*Ask your dealer for available GPS receiver details. w
cy setting mode. (p. 6) t MEMORY SWITCH [MEM]
q
e
q
Hold down for
and two
esexictothnedsmtoemenotreyrmthoedSe.e(tpti.n8eg)s
menu.
(p. 18)
➥ Push to enter...
Instruction Manual - Page 13
...squelch mode
You can switch the squelch mode when the Auto squelch "AUTO SQL" item in the Settings menu. (p. 21)
eeWhen receiving a signal, "RX" is RX
displayed and audio is ... set below 100 kHz digit.
• You can set to mute undesired noise when no signal
received.
cy setting mode.
• Only the active frequency is
turned OFF.
• MN (manual): Uses the squelch level set ...
Instruction Manual - Page 18
... [O-DIAL] to select a memory group from GRP01 to GRP05. • Push [DIAL] again to set to the group number. ttPush [MEM] to select "CH TAG."
Non-tag
TWR YES YES
Tower...YES YES Common Traffic Advisory Frequency
DEP YES YES
Departure
FSS YES YES
Flight Service Station
RFS YES YES Remote Flight Service Station
UNI YES YES
Unicom frequency
MF YES YES
Mandatory frequency
OTH YES
...
Instruction Manual - Page 20
...set ...replacing, and so on) of the regular memory and group memory. NOTE: The GPS memory data is stored in the desired group memory channel.
NOTE: Refer to the GPS receiver's instruction manual... for available GPS receiver details. lected GPS memory channel already contains other data. Refer to select a desired group memory. • "GPS" and airport code blink. Airport code...
Instruction Manual - Page 23
...Settings menu.
04
wwRotate [O-DIAL] to select "FREQ.
eeRotate [DIAL] to set...is displayed. • Y ou can set the headphone output level in the Settings menu. (p. 20) • You... the Settings menu. (p. 20)
■■Opening the squelch for test
This function manually opens ...rrP ush [RCL] to exit the Settings menu. STEP." Refer to "INSTALLATION GUIDE" for testing. wwTo turn ON...
Instruction Manual - Page 24
Repeatedly scans all weather memory channels. You can set the interval time (scan speed) for two seconds to "WX10" channels for weather channel signals. wwHold down [VOL] for details.
qqPush [RCL] to enter the memory mode, and then rotate [O-DIAL] to cancel the scan manually. version transceivers)
Scanning automatically searches for...
Instruction Manual - Page 27
... level to between 1 and 80. DDIntercom 2 microphone audio Input level "IN- 05 COM LV2"
Sets the intercom 2 microphone input level. • OFF (0): Mutes the intercom 2 microphone. •... the Auto squelch "AUTO SQL" item in the Configuration menu (p. 22) is set to "USER SET." • MN (manual): U se "SQL LEVEL" to set the squelch level. • AU (auto): Prevents the audio from breaking ...
Instruction Manual - Page 28
...;-10 and
10.
DDManual dimmer control "DISP MAN." DDSetting microphone 2 Gain "MIC2 GAIN"
Sets microphone 2's gain. • -010 to 010: Sets the microphone 2's gain to between 1 and 100. Sets the brightness manually to suit your dealer in the Settings menu. DDSidetone level "SIDETONE LV"
When using an external speaker, the beep tone
level...
Instruction Manual - Page 30
... your preference. • OFF: The dimmer function is OFF. • AUTO: Automatically sets the dimmer according to the current
lighting condition. • MANUAL: M anually sets the dimmer in the Manual dimmer control
"DISP MAN" item. (p. 21)
DDDimmer auto mode "DISP AUTO"
Sets the method to automatically control the dimmer brightness.* *Displayed only when the Dimmer...
Instruction Manual - Page 31
... dimmer brightness level to the desired tag name. While the intercom function is output from an external audio device.
e Rotate [O-DIAL] to 'INSTALLATION GUIDE' for the tag name.
ration menu is set three characters for an external audio device
connection details.
• OFF: The external audio is not used.
• ON: The external...
Instruction Manual - Page 34
...°C;
-4°F to +131°F)
IC-A220E
±1 ppm (0˚C to +40˚C)
• Operating temperature: -20˚C to +55˚C;
-4˚F to +131˚F
• Antenna impedance:
50 ø
• Number of this radio is strictly prohibited and shall not be used in Canada. 7 SPECIFICATIONS
Use of 8.33 kHz Channel Spacing of...
Instruction Manual - Page 38
... 20 Intercom 2 squelch level 22 Intercom usable setting 24 Interlock 25 Interlock mode 25
L Lock function 15 Lock mode 20
M Manual dimmer control 21 Memory clear 25 Memory operation ...16 Remote exchange 25 Remote incom 25 Remote recall 25
S Settings menu items 20 Settings menu 18 Sidetone level 21 Specifications 27 Squelch settings 6 Squelch test 16 Squelch mode 20
T Time-Out-...
Icom A220 Reviews
We have not received any reviews for Icom yet.