Intel SRCSASJV - RAID Controller Support and Manuals
Get Help and Manuals for this Intel item
View All Support Options Below
Free Intel SRCSASJV manuals!
Problems with Intel SRCSASJV?
Ask a Question
Free Intel SRCSASJV manuals!
Problems with Intel SRCSASJV?
Ask a Question
Popular Intel SRCSASJV Manual Pages
Hardware User Guide - Page 3
...; Chapter 3 provides the characteristics and technical specifications for an overview of the software drivers, see the Software User's Guide on the Resource CD. Intel® RAID Controller SRCSASJV Hardware User's Guide
iii Preface
This is included with RAID controllers and related support devices.
It contains installation instructions and specifications. For details on the Resource CD...
Hardware User Guide - Page 5
...Notices 28
Intel® RAID Controller SRCSASJV Hardware User's Guide
v Contents
Preface ...iii
Audience ...iii Organization ...iii Related Publication ...iii
Chapter 1, Overview 1
Benefits of SAS ...1 Intel® RAID Controller SRCSASJV 2
Protocol Support ...2 Operating System Support 2 Usability ...2 Redundancy and Error Handling 3 SAS/SATA Features of the 1078 Controller 4 Beep Codes...
Hardware User Guide - Page 6
... SCSI cable or 40-wire ATA cable. 1 Overview
The Intel® RAID Controller SRCSASJV is compatible with existing ATA firmware.
1
Intel® RAID Controller SRCSASJV Hardware User's Guide
SAS offers a higher bandwidth per pin than parallel SCSI. The SAS interface uses the proven SCSI command set .
SAS controllers leverage a common electrical and physical connection interface that is...
Hardware User Guide - Page 7
... expander interfaces. The PCI-Express* connector fits into an x8 or x16 PCI-Express slot capable of the mini SAS 4i multi-lane connectors, this controller supports up to point transfer rate. Intel® RAID Controller SRCSASJV Hardware User's Guide
2 Eight independent ports are available, using any two of 2.5 Gbps per drive: 8, 16, 32, 64 (def), 128, 256, 512...
Hardware User Guide - Page 8
... at least four times. • Firmware provides best effort to recognize an error and recover if possible. • Failures...Intel® RAID Controller SRCSASJV Hardware User's Guide See Appendix A for a missing drive to be marked as failed.
• Auto-resume on reboot of initialization or rebuild (must be set for cache write to use Peer Read mode.
• Dirty cache LED plus error...
Hardware User Guide - Page 9
... of each read will be sequential and buffers this data into the
cache. - Intel® RAID Controller SRCSASJV Hardware User's Guide
4 Hot-swap support. - I /O: Checks cache first, only reads disk if data is on the drives (COD). -
Faster because it does not wait for cache memory. Predicts next read . - Adaptive Read Ahead. Configuration stored in the cache. ✧...
Hardware User Guide - Page 10
... than one virtual disk in rebuild. Array has failed.
Beep Codes
• Short beep, 1 second on , 1 second off. To enable alarm, choose Enable Alarm
To disable alarm only until the next event or until next power cycle, choose Silence Alarm.
5
Intel® RAID Controller SRCSASJV Hardware User's Guide Data has been lost . • Long beep, 3 seconds on...
Hardware User Guide - Page 11
... SRCSASJV Hardware User's Guide
6 Changing the Bracket
AF002212
4.
Note: Intel Corporation strongly recommends using an uninterruptible power supply (UPS). Figure 1. Install the RAID controller into an available server system x8 or x16 PCI-Express* slot.
Follow the instructions that came with an available x8 or x16 PCI-Express* slot. • The Resource CD, which contains drivers...
Hardware User Guide - Page 12
...SAS or SATA backplane, or an expander device. Only connect to the upper internal or external connector. To prevent throughput problems...Intel® RAID Controller SRCSASJV Hardware User's Guide Internal connectors have a snap spring latch that controller and cables are deep-seated and require caution when connecting and disconnecting cables.
5. Installing the Intel® RAID Controller SRCSASJV...
Hardware User Guide - Page 14
... to configure the RAID controller and to update the NVRAM. 5. Press and select YES to install the operating system drivers. Replacing a Controller, Resolving a Config Mismatch
To replace the RAID controller, see the NVRAM and drive configurations.
3.
See the Intel® RAID Controller SRCSASJV Quick Start User's Guide and the Software User's Guide for instructions to be sure...
Hardware User Guide - Page 15
... management support, usually for no jumper Provides signal to enclosure to indicate that the cache needs to write data Cable connector to the battery backup pack. Card Layout
Intel® RAID Controller SRCSASJV Hardware User's Guide
10 This connector is for nonexpander hot-swap backplane Default is on the back of the card
Figure 4. 3 Intel® RAID Controller SRCSASJV
Characteristics...
Hardware User Guide - Page 16
... virtual drives per array.
11
Intel® RAID Controller SRCSASJV Hardware User's Guide Shared connectors for debug use only LSI 1078 2x4 internal ports, SFF8087, 2x4 external ports SFF8088 2x4 ports total: 240 drives per controller; 64 virtual drives per controller; 240 hot spares per controller (global and/or dedicated) DDR2 667 MHz SDRAM, optional battery backup 4 MB in -band...
Hardware User Guide - Page 17
... 255
Support for any array; without reboot
Background services
Rebuild, Consistency Check, Migration, OCE, and Patrol Read
Cache options
Write-back or Write-through Read Ahead, Adaptive Read Ahead, NonRead Ahead, Cache I/O or Direct I /O requests 6.4 Mbytes in NVRAM, event log, CIM, Smart, Intel® RAID Web Console 2
Intel® RAID Controller SRCSASJV Hardware User's Guide
12...
Hardware User Guide - Page 21
... meet specifications.
7.
Follow the instructions that came with your server documentation for instructions to which you start the system, the controller detects the RAID configuration from the first system and install them into the second system. The controller to install and... power on the same port and be migrated; Intel® RAID Controller SRCSASJV Hardware User's Guide
16
Hardware User Guide - Page 24
... left loose tools or parts inside the system.
5.
The power cord(s) is considered the disconnect device to the chassis with the chassis covers removed. To do this document before turning on the back of the system if a padlock has been installed. 2. Check first to the system.
19
Intel® RAID Controller SRCSASJV Hardware User's Guide Check that the...
Intel SRCSASJV Reviews
We have not received any reviews for Intel yet.