Intel SRCSASLS4I - RAID Controller Support and Manuals
Get Help and Manuals for this Intel item
View All Support Options Below
Free Intel SRCSASLS4I manuals!
Problems with Intel SRCSASLS4I?
Ask a Question
Free Intel SRCSASLS4I manuals!
Problems with Intel SRCSASLS4I?
Ask a Question
Popular Intel SRCSASLS4I Manual Pages
Hardware User Guide - Page 3
... who are designing an Intel® RAID Controller SRCSASLS4I storage adapter into a system.
• Anyone installing an Intel® RAID Controller SRCSASLS4I storage adapter in included on how to do a drive migration. Audience
This document assumes that shipped with RAID controllers and related support devices. It contains installation instructions and specifications. For details on the...
Hardware User Guide - Page 5
... 3 SAS/SATA Features of the 1078 Controller 4 Beep Codes ...5
Chapter 2, Intel® RAID Controller SRCSASLS4I Hardware Installation 7
Requirements ...7 Install the RAID Controller ...7 Configure the RAID Controller 10 Replacing a Controller, Resolving a Config Mismatch 10
Chapter 3, Intel® RAID Controller SRCSASLS4I Characteristics 11
Technical Specifications ...12 Array Performance...
Hardware User Guide - Page 7
... FC, and is a high-performance intelligent PCIExpress* SAS/SATA RAID controller that offers reliability, high performance, and faulttolerant disk subsystem management.
The SAS/SATA connector and cable are serial, point-to sixteen drives. Intel® RAID Controller SRCSASLS4I Hardware User's Guide
1 This is a RAID solution that leverages the proven SCSI protocol set to ensure reliable data...
Hardware User Guide - Page 8
... Intel® RAID Controller SRCSASLS4I to make sure the RAID card supports your server board. The SAS controller supports the ANSI Serial Attached SCSI (SAS) standard, version 1.0 and the Serial ATA (SATA) protocol defined by your operating system. The operating systems supported may not be supported by the Serial ATA specification, version 1.0a.
Operating System Support
• Windows...
Hardware User Guide - Page 9
... from controller and drive firmware, and SMART monitor. • Failures are five
or more disks in NVRAM, viewable from 0-100%).
Drive roaming. -
RAID 5 arrays of only three or four drives use from OS Event Log, Intel® RAID Web
Console 2; Caution: Exceeding 50% rate may require OCE). - CIM, LEDs, and via alarm. Intel® RAID Controller SRCSASLS4I Hardware User's Guide
3 See...
Hardware User Guide - Page 10
... (not cache)
• Redundancy through an expander.
4
Intel® RAID Controller SRCSASLS4I Hardware User's Guide
Usually slower but data will be lost if power is on...specific performance optimization:
- Non Read Ahead. Optional battery backup for the disk but ensures data is lost.
- Write-through an expander if using SATA 2.0- Controller provides fast or trickle charges. SAS...
Hardware User Guide - Page 11
.... Intel® RAID Controller SRCSASLS4I Hardware User's Guide
5 Beep Codes
• Short beep, 1 second on, 1 second off. Using hot spare in a logical array. • Migration and OCE cannot be done on Spanned Arrays (RAID 10, 50, 60). • Migrations supported are : RAID 1 to RAID 0, RAID 5 to RAID 0, RAID 6 to RAID
0.
• With OCE migrations supported are RAID 0 to RAID 1, RAID 0 to...
Hardware User Guide - Page 13
...which contains drivers and documentation. • SAS or SATA 3.0 hard drives.
Turn off the power to fit the height of the server system. See the following figure. Note: Intel Corporation strongly recommends using an uninterruptible power supply (UPS).
Changing the Bracket
Intel® RAID Controller SRCSASLS4I Hardware User's Guide
AF002636
7 Install the RAID Controller
1. If necessary...
Hardware User Guide - Page 14
... to locate an appropriate slot and for instructions on installing an add-in card. Decrease the maximum length by one 4-port combined end of an internal cable to the connector. To prevent throughput problems, use the cable provided or use a cable longer than one meter. 4.
Installing the Intel® RAID Controller SRCSASLS4I
5. For the four drives, ports 0 - 3, connect one...
Hardware User Guide - Page 17
... connector
Receiver/Transmitter (UART)
J6
Mode 0 Select
2-pin connector
J7
Keyed I2C Connector
3-pin keyed connector
Comments LED signal support for drive activity.
No jumper is required for firmware recovery; Out-of-band enclosure management (SES2)
Intel® RAID Controller SRCSASLS4I Hardware User's Guide
11 Reserved For factory and debug use. For connection to enclosure LED.
Hardware User Guide - Page 18
... port SAS controller SAS/SATA ports Physical and virtual drive support Cache Firmware Compatible devices
Cabling
Redundant configuration Enclosure management Enclosure support
Intel® RAID Controller SRCSASLS4I LSI 1078 Integrated RAID on -disk (COD) in reflashable flash ROM 2.5-inch and 3.5-inch SAS or SATA 3.0 drives; Technical Specifications
Specification Processor Operating voltage Card...
Hardware User Guide - Page 19
... any array; Array Performance Features
Host data transfer rate
2.5 Gigabit/s per PCI Express* lane
Drive data transfer rate
3 Gigabit/s per lane
Maximum scatter / gather
26 elements
Maximum size of I /O
Fault Tolerance
Self Monitoring Analysis and Reporting Technology (SMART) support Optional Battery Backup
Drive Replacement Drive Rebuild Using Hot Spares
Error Checking and Indication...
Hardware User Guide - Page 24
...electricity can harm delicate components inside the computer, periodically touch an unpainted metal
surface to install the component in a static-safe area. Some cables have accumulated. Just before you connect...; Handle components and cards with locking tabs; If possible, use antistatic floor
pads and workbench pads.
18
Intel® RAID Controller SRCSASLS4I Hardware User's Guide
Hardware User Guide - Page 25
... the system covers. Intel® RAID Controller SRCSASLS4I Hardware User's Guide
19 Remove and save all screws from wall
outlets. 4. To install the covers:
1. ...support.intel.com\support\motherboards\server\sb\cs010770.htm. Check first to the system. Connect all external cables and the AC power cord(s) to make sure you must unplug each AC power cord from the back of the instructions...
Hardware User Guide - Page 33
...) • RRL, MIC Notice No. 1997-41 (EMC) & 1997-42 (EMI) (Korea)
Product Regulatory Compliance Markings
The RAID Controller Card is marked with the following compliance markings.
CSA 950 (US/Canada) • EN 60 950 (European Union) • IEC60 950...• CE Mark (Europe) • VCCI Mark (Japan) • MIC Mark (Korea)
Intel® RAID Controller SRCSASLS4I Hardware User's Guide
27
Intel SRCSASLS4I Reviews
We have not received any reviews for Intel yet.