Kenwood TK-3307 Support and Manuals
Get Help and Manuals for this Kenwood item
View All Support Options Below
Free Kenwood TK-3307 manuals!
Problems with Kenwood TK-3307?
Ask a Question
Free Kenwood TK-3307 manuals!
Problems with Kenwood TK-3307?
Ask a Question
Kenwood TK-3307 Videos
B? ?ÀM KENWOOD TK 3307 | SIÊU TH? B? ?ÀM GIÁ R?.
Duration: 3:44
Total Views: 26
Duration: 3:44
Total Views: 26
Kenwood TK-3307 Two Way Radio
Duration: 2:20
Total Views: 1,079
Duration: 2:20
Total Views: 1,079
Counterfeit transceivers on eBay & Amazon. Don't worry Trustpilot approves! TK3307
Duration: 3:02
Total Views: 1,530
Duration: 3:02
Total Views: 1,530
B? ?àm kenwood tk 3307
Duration: :38
Total Views: 42
Duration: :38
Total Views: 42
Popular Kenwood TK-3307 Manual Pages
Operation Manual - Page 1
INSTRUCTION MANUAL
VHF FM TRANSCEIVER
TK-2307
UHF FM TRANSCEIVER
TK-3307
B62-2317-20 (C)
Operation Manual - Page 2
...replacing the battery pack.
• Do not immerse the transceiver in KENWOOD product memories are reserved for many hours, the
radiator and chassis will become hot. Firmware...9670; Refer service to qualified ...installing optional
accessories. • The charger is punishable by KENWOOD.
• If the die-cast chassis or other transceiver part is damaged, do not touch the damaged parts...
Operation Manual - Page 3
... air is dry, it is easy to your KENWOOD dealer. • Use of the transceiver while you use of the transceiver must follow the instructions
and regulations provided by the airline crew.) •...such a time may be ejected and strike the driver or passengers. • Do not transmit while touching the antenna terminal or if any metallic parts are posted regarding the use only a speaker/...
Operation Manual - Page 6
... eyes with fresh water as soon as possible, without rubbing your eyes. • Do not touch a ruptured and leaking battery! The battery may cause eye-problems.
• Do not charge the battery for any other reason, remove it .
The battery may generate heat or smoke, rupture, or burst into flame.
•...
Operation Manual - Page 7
... with the carrier immediately.
SUPPLIED ACCESSORIES
• Antenna 1 • Speaker/ microphone jack cover 1 • Speaker/ microphone locking bracket 1 • Belt clip (KBH-10 1 • Screw set
• M2.6 x 7 mm (Black 1 • M3 x 8 mm 2 • Instruction manual 1 Note: Refer to "PREPARATION" for accessory installation instructions.
1
Operation Manual - Page 8
PREPARATION INSTALLING/ REMOVING THE (OPTIONAL) BATTERY PACK
◆ Do not short the battery terminals or dispose of the battery by fire. ◆ Never attempt to remove the ...
Operation Manual - Page 9
... belt clip is neither a handle, a key ring retainer, nor a speaker/ microphone attachment point.
Belt clip
Do not use glue which is designed to the transceiver.
INSTALLING THE BELT CLIP
If necessary, attach the belt clip using the two supplied M3 x 8 mm screws. Using the antenna in these ways may damage the...
Operation Manual - Page 10
... with the supplied cover.
Note: To keep the transceiver water resistant, you are not using a speaker/ microphone, install the cover over the speaker/ microphone jacks using the supplied M2.6 x 7 mm screw. Speaker/ microphone jack cover
INSTALLING THE OPTIONAL SPEAKER/ MICROPHONE (OR HEADSET)
1 Insert the speaker/ microphone (or headset) plugs into the speaker...
Operation Manual - Page 11
...Always switch OFF a transceiver equipped with a battery pack into an AC outlet. Charging outside this range may not fully charge the battery.
◆ The battery pack life is over when its ...at the factory; CHARGING THE BATTERY PACK (OPTIONAL BATTERY CHARGER)
The battery pack is in progress.
Replace the battery pack.
5 Note:
◆ When the indicator blinks red, the battery pack is ...
Operation Manual - Page 16
...VOICE OPERATED TRANSMISSION (VOX)
VOX operation allows you adjust it. To activate VOX and set the VOX Gain level, perform the following steps: 1 Connect the headset to the ...is switched ON and the VOX Gain level is selected, a beep sounds.
5 Press the PTT switch to save the setting. • A beep will sound. • The transceiver announces the new VOX Gain level.
6 Turn the transceiver ...
Operation Manual - Page 17
..., the Low Battery Warning sounds an alert tone every 30 seconds and the LED indicator blinks red when the battery needs recharged or replaced. Pressing the PTT switch will cause an alert tone to stop the tone. If you from using QT, DQT, DTMF, or FleetSync...default is operating, the LED may flash green when receiving a QT/DQT signal which does not match the QT/DQT tone/code set up in use.
Operation Manual - Page 18
... with ID, "Wild Card" Group Calling, and Radio Stun.
■ FleetSync Utilizing KENWOOD's FleetSync digital signaling protocol, this transceiver has PTT ID and Selective Calling capabilities for dispatch ... Decode.
The DTMF decode capabilities include Selective Call ID, Transpond with a stun reset code.
A DTMF PTT ID is transmitted when you release the PTT switch.
12 Stun...
Kenwood TK-3307 Reviews
We have not received any reviews for Kenwood yet.