Makita XBU07Z Support and Manuals
Get Help and Manuals for this Makita item
View All Support Options Below
Free Makita XBU07Z manuals!
Problems with Makita XBU07Z?
Ask a Question
Free Makita XBU07Z manuals!
Problems with Makita XBU07Z?
Ask a Question
Popular Makita XBU07Z Manual Pages
Instruction Manual - Page 2
... working as described in this manual. ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Capacities (Blower)
Air volume...servicing.
2.
The lightest and heaviest combinations, according to be followed, including the following:
READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE.
Do not allow to EPTA-Procedure 01/2014, are subject to change without notice.
• Specifications...
Instruction Manual - Page 3
... or pets are worn or damaged, replace them with your finger on a firm...parts provided by Makita.
3. Avoid operating the machine for damage before checking, cleaning or working condition.
2. Keep all parts of children.
3 ENGLISH SAVE THESE INSTRUCTIONS...is damaged, ask Makita Authorized Service Centers for both household use and... reasonable hours is intended for repair.
14. Do not insert...
Instruction Manual - Page 4
...repair the machine or the battery pack except as those dust masks that all charging instructions and do this type of work. Recharge only with specifically...the symbols used with local codes for tool. Cool down ...instruction manual may be performed by a qualified
repair person using only identical replacement parts. Do not dispose of starting . Avoid dangerous environment. Never service...
Instruction Manual - Page 5
...personal injury.
17.
Overcharging shortens the battery service life.
3. Such conduct may result in ... children.
Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, ...can cause burns or low temperature burns. Installing the batteries to cause burns.
16. Do...explosion.
4. Unless the tool supports the use near high-voltage ...
Instruction Manual - Page 6
....
2
1
3
1
2
Fig.1
► 1 . Claw 2. Screw 2. Align the protrusions on the nozzle with the grooves on the machine. Fig.2 ► 1 . Protrusion To remove the nozzle, perform the installation procedure in the figure. Nozzle 3.
ASSEMBLY
CAUTION: Always be sure that the machine is switched off and the battery cartridge is removed before carrying out...
Instruction Manual - Page 7
For the recommended hanging band, ask Makita Authorized Service Centers. Using other shoulder strap may come off and cause an injury. Attach the hook of...power supply is difficult in case of the backpack-type power supply such as shown in the figure.
Claw 2. Installing or removing the wide nozzle
Optional accessory Insert the wide nozzle with its protrusions facing up the rear side of...
Instruction Manual - Page 8
... into place. NOTE: Depending on the battery cartridge with a little click. CAUTION: Always install the battery cartridge fully until it may have malfunctioned.
3
Fig.7 ► 1 . ...
Failure to draw an abnormally high current, the machine automatically stops. CAUTION: Do not install the battery cartridge forcibly. Indicator lamps 2. If you .
Button 3.
Then turn the ...
Instruction Manual - Page 9
...change lever two or three times to stop automatically. Charge the battery(ies) or replace it on again to a temporary halt or stop .
Control lever
Switching the ... troubleshooting. To use the machine for other causes
Protection system is increased by restoring protection system, then contact your local Makita Service Center. Change lever
Fig.9 ► 1 . NOTE: If you install the...
Instruction Manual - Page 10
... machine firmly and perform the blowing operation by Makita Authorized or Factory Service Centers, always using Makita replacement parts. While operating the machine, adjust the switch trigger so that the... machine is appropriate for the work .
To maintain product SAFETY and RELIABILITY, repairs, any...
Instruction Manual - Page 11
... The drive system does not work correctly. Remedy Install the battery cartridge. Recharge the battery. If recharging is not effective, replace battery. If you find a problem that is not effective, replace battery.
The drive system does not work correctly. Recharge the battery.
TROUBLESHOOTING
Before asking for repair. Abnormal vibration: stop : Remove the battery immediately! Motor...
Parts Breakdown - Page 3
... Complete
Products with multiple versions are listed in subsiding order with the newest version on top not indented. XBU07 Tech Bulletin
Part No.
Description
1
1 GB00000172
HOUSING SET
1
1
2 GB00000072
RUBBER PIN 5.5X8.5
2
1
3 GB00000003
TAPPING SCREW ST4.2X15
16
1
4 GB00000025
TAPPING SCREW ST4.2X20
2
1
5 GB00000183
CONTROLLER ASSY
1
1
6 GB00000191
BRUSHLESS MOTOR...
Parts Breakdown - Page 4
XBU07 Tech Bulletin
1 XBU07
Unit Complete
Products with multiple versions are listed in subsiding order with the newest version on top not indented. Part No. Section Fig.
No. Description
1 36 GB00000035
WHEEL SHAFT
2
1 37 GB00000166
WHEEL 61
2
1 38 GB00000167
WHEEL BRACKET
1
Notes
rev 0_07/17/23
4
Makita XBU07Z Reviews
We have not received any reviews for Makita yet.