RedMax GZ4000 Support and Manuals
Get Help and Manuals for this RedMax item
This item is in your list!
View All Support Options Below
Free RedMax GZ4000 manuals!
Problems with RedMax GZ4000?
Ask a Question
Free RedMax GZ4000 manuals!
Problems with RedMax GZ4000?
Ask a Question
Most Recent RedMax GZ4000 Questions
RedMax GZ4000 Videos
Popular RedMax GZ4000 Manual Pages
Owners Manual - Page 3
... oil 10 7. Operation 12 8. CONTENTS 1. Specifications 4 3. Maintenance 20 10. Symbols on the machine 5 4. Troubleshooting Guide 25 12. Parts location 4 2. Maintenance of the product. IMPORTANT
This mark indicates instructions which could lead to mechanical failure, breakdown, or damage. Installing guide bar and saw chain 8 6. NOTE
This mark indicates hints or directions useful...
Owners Manual - Page 4
... tank 10. W - Gauge Oregon 91VG - 3/8(9.53) - 0.050(1.27) in (cm) Saw chain : Type - Guide Bar
2. of teeth 3/8in(9.53mm) - 6T Dimensions : L - 1. Size Sprocket nose - 16(40) in (mm)
Specifications are subject to change without notice.
4 Starter knob 3. Engine switch 9. Specifications
■ GZ4000 Power unit :
Dis placement 2.45(40.1) cu-in (mm) Dry...
Owners Manual - Page 5
...chain cover
IMPORTANT ENGINE INFORMATION
THIS ENGINE MEETS U.S. The screw at the backright of the rear handle) to the point of the arrow, you pull out the choke knob (at the left of the unit
(d). EM ENGINE DISPLACEMENT : 40cc REFER TO OWNER'S MANUAL FOR MAINTENANCE SPECIFICATIONS... IN JAPAN
Use RedMax 50:1 Oil !
5 It shows the directions that the chain brake is The ...
Owners Manual - Page 6
....
11. Always inspect the chain saw before setting it down.
14. For ...parts. Always hold the flywheel in the wood fibers is mixed, poured, or stored.
4b) Do not smoke while handling fuel or while operating the chain saw .
6. Use a firm grip with the engine stopped, the guide bar and saw chain...chain saw service, other persons to be struck when the tension in order to remove the clutch...
Owners Manual - Page 7
... other obstruction which could be hit while you to lose control of the saw .
Either of these reactions may push the guide bar rapidly back towards the operator. Use a firm grip with thumbs and fingers encircling the chain saw chain. (7) Only use replacement bars and chains specified by the manufacturer or the
equivalent.
7 For safe operation
16...
Owners Manual - Page 10
...63713;10
■ RECOMMENDED MIXING RATIO GASOLINE 50:OIL 1 (when using ZENOAH genuine oil)
50:1 MIXING CHART GASOLINE gal. 1 2 3 4 5 2-CYCLE ...engine temperature may rise and an engine problem such as piston seizing may damage sealing...starting the engine.
• The RedMax engines are lubricated by the fundamental...before refueling the unit. Fuel and Chain oil
WARNING
• Gasoline is...
Owners Manual - Page 11
... ring sticking. 4. Next, activate the engine and empty the carburetor of quality assurance, read the description in product with gasoline or...ingredients, sufficient agitation is not observed as to the internal engine parts very quickly. 2. FOR YOUR ENGINE LIFE, AVOID; 1. It ... CHAIN OIL Use motor oil SAE 10W-30 all year round, or SAE 30-40 in summer and SAE 20 in the instruction manual is...
Owners Manual - Page 12
... the choke knob to run a chainsaw that all the parts including bar and chain are installed properly.
■ STARTING ENGINE 1. Operation
F7 F8 F9 F10
F11 12
WARNING
It is very dangerous to the second-stage position. While holding the saw chain may touch your finger. Fill fuel and chain oil tanks respectively, and
tighten the...
Owners Manual - Page 13
... and fresh, properly mixed fuel. Before adjusting the carburetor, make sure that saw chain as it to set up in low speed for maximum speed.
(1) L needle (2) H needle (3) Idle adjusting screw
13 7. If not, the rotating parts may require fine tuning due to adjust the carburetor with the bar chain attached.
1. Make a test cut adjust the H needle...
Owners Manual - Page 17
... that will
stop the chain in the event of this saw as a lever for lifting, moving or splitting objects. The chain should stop , replace the brake band and clutch drum before use.
• It is forbidden to pull it over fixed stands. Removal of the safety devices, inadequate maintenance, or incorrect replacement of material. Do not use...
Owners Manual - Page 27
.... 4. Parts list
CHAINSAWS
GZ4000
NOTE : 1. Use KOMATSU ZENOAH genuine parts as specified in the parts list for the machine shall be supplied seven (7) years after the machine is discontinued. [It is possible that some specific parts may be available even after the machine is also possible that some parts may change of their delivery term and list price within the...
Owners Manual - Page 29
...DRUM 3/8-6 OIL PUMP ASSY • OIL PUMP • WORM SPARK PLUG RZ7C GROMMET LABEL
Q'TY NOTE /UNIT
1 4 1 1
2 1 1 1 1 1 1 1 1 1 1 1 1 4 1 1 1 1 1 1 1
29 GZ4000
Fig.1 POWER UNIT (S/N 60322501 and up)
Key# PART...
• PIN
27 848-C30-66F1 CATCHER, chain
28 2850-25220 SCREW
29 2850-25411 PLATE
30 ...42 1650-43230 NUT
43 848-C40-5121 CLUTCH ASSY
-
• SHOE
45 2870-51230...
Owners Manual - Page 35
... SURE TO KEEP A COPY FOR YOUR RECORDS. RedMax
CHAIN SAWS LIMITED WARRANTY
EMISSION-RELATED PARTS, FOR TWO (2) YEARS FROM THE DATE OF ORIGINAL DELIVERY, KOMATSU ZENOAH AMERICA INC. (THE COMPANY), THROUGH ANY RedMax DEALER, WILL REPAIR OR REPLACE, FREE OF CHARGE, FOR THE ORIGINAL AND EACH SUBSEQUENT PURCHASER, ANY PART OR PARTS FOUND TO BE DEFECTIVE IN MATERIAL AND/OR...
Parts List - Page 2
.... [It is discontinued. The contents described in the parts list may be supplied seven (7) years after the limit of any parts other than those specified in the parts list, then use parts number described in the parts list for repair and/or replacement, check if the model name and the
serial number are applicable to improvement. 5. Parts list
CHAINSAWS
GZ4000
NOTE : 1.
Parts List - Page 4
...GZ4000
Fig.1 POWER UNIT (S/N 60322501 and up)
Key# PART...
• PIN
27 848-C30-66F1 CATCHER, chain
28 2850-25220 SCREW
29 2850-25411 PLATE
30... 1650-43230 NUT
43 848-C40-5121 CLUTCH ASSY
-
• SHOE
45 2870-...COMP. • KNOB MUFFLER ARRESTER STAY SCREW COVER COMP. • CAP SCREW DRUM 3/8-6 OIL PUMP ASSY • OIL PUMP • WORM SPARK PLUG RZ7C GROMMET LABEL
Q'TY NOTE /UNIT
1...
RedMax GZ4000 Reviews
Do you have an experience with the RedMax GZ4000 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for RedMax yet.
Earn 750 points for your review!