Weider Pro Xt55 Support and Manuals
Get Help and Manuals for this Weider item
View All Support Options Below
Free Weider Pro Xt55 manuals!
Problems with Weider Pro Xt55?
Ask a Question
Free Weider Pro Xt55 manuals!
Problems with Weider Pro Xt55?
Ask a Question
Most Recent Weider Pro Xt55 Questions
Weider Xt55 Pro
how much does the bar weigh on the weider xt55 pro?
how much does the bar weigh on the weider xt55 pro?
(Posted by wredding09 6 years ago)
Popular Weider Pro Xt55 Manual Pages
English Manual - Page 1
...:
1-800-999-3756
Mon.-Fri., 6 a.m.-6 p.m.
MST
CAUTION
Read all precautions and instructions in the space above for future reference.
®
USER'S MANUAL
Visit our website at www.weiderfitness.com
new products, prizes, fitness tips, and much more!
Save this equipment. Model No.
WEBE19301 Serial No. Serial Number Decal
QUESTIONS? The trained technicians on...
English Manual - Page 2
... assembly. WEIDER is attached in the center of ICON Health & Fitness, Inc.
2 ®
Table of Contents
Important Precautions 3 Before You Begin 4 Part Identification Chart 5 Assembly 6 Adjusting the Weight Rack 12 Exercise Guidelines 14 Ordering Replacement Parts Back Cover Limited Warranty Back Cover Note: A Part List/Exploded Drawing is a registered trademark of this manual.
English Manual - Page 3
It is intended for home use the weight rack. The weight rack is the responsibility of the owner to order a free replacement decal. Inspect and tighten all instructions before using. Replace any exercise program, consult your weights (not included) with pre-existing health problems.
Read all parts each side of the lat bar.
5. until 6 p.m.
ICON assumes no responsibility for...
English Manual - Page 4
... major muscle group of this manual.
4 Lat Tower Upright
Right Side
High Pulley Station Lat Bar
Weight Guide Left Side Weight Glider
Barbell Weight Carriage Foot Plate
Safety Spotter
Low Pulley Station
Note: The terms "right side" and "left on a decal attached to a user standing with the parts that are labeled. The XT55 PRO is WEBE19301. The serial number...
English Manual - Page 5
Note: Some small parts may have been pre-attached. The number in parentheses below to see if it has been pre-...the quantity needed for assembly. If a part is not in the parts bag, check to identify small parts used in the center of the part, from the Part List in assembly. The number following the key number is the key number of this manual. Part Identification Chart-Model No.
English Manual - Page 6
... requires the following information and instructions:
Make Things Easier for Yourself!
Note: Some small parts may be pre-assembled. This manual is completed.
• Tighten all parts as grease or petroleum jelly, and soapy water. By setting aside plenty of the Rear Base (3). Attach the Base to ensure that the weight rack can be more convenient...
English Manual - Page 8
... manner. Press a 38mm Bushing (29) into the indicated end of a second
9
person.
Make sure the Right Weight Glider is oriented exactly as shown.
23
Slide the assembled Locking Bar (34) and the Right
and Left Weight Gliders (31, 32) onto the Weight
Guides (18). Slide the Right Weight Glider onto the indicated end of the
7
Left...
English Manual - Page 10
...
16. Do not overtighten the Nylon Locknut. The Pulley must be able to the Rear Upright using a Support Plate (57), two M10 x 80mm Bolts (41), and two M10 Nylon Locknuts (11). The
Pulley must...able to turn freely.
15. Route the High Cable (13) around a Pulley (5) as shown. Attach the Pulley Bar (53) to the Top Crossbar (9) using two M10 x 65mm Bolts (56), four M10 Small Washers (6), and ...
English Manual - Page 12
... worn parts immediately. To use the weight rack. Note: Always start an exercise with the WEIDER® PRO XT15 weight bench (model number WEBE0910). Attach the indicated end of the Low Cable (8) to a new position
and turn it by inserting the Pin (52) through the leg lever as shown.
Turn the Locking Bar
31
until the hooks engage the...
English Manual - Page 13
...(5) and Cable Trap (21) to the next higher hole in the Uprights. WARNING: Always set both Safety
Spotters (23, 24) at the same height. Make sure the Cable Trap holds the Low...19). Secure the weights with Weight Clips (51). Do not place more than 150 pounds on each end of cable used . WARNING: Always remove the Lat
Bar (16) when performing an exercise that does not require...
English Manual - Page 14
... workouts on the areas that is the highest. WARMING UP
Begin each set . Warming up . Schedule your workouts for each exercise and moving only the appropriate parts of weight for the time of day when your heart and lungs. EXERCISE FORM
You will reshape and strengthen your body and develop your energy level is right...
English Manual - Page 15
... make exercise a regular and enjoyable part of leg)
W. Move slowly as you stretch and do not bounce. Ease into
each stretch gradually and go only as far as you can without strain. List the date, the exercises performed, the weight lifted, and the numbers of calf)
F
L
L. Hip Flexors (upper thigh)
G. Soleus (front of sets and...
English Manual - Page 16
... MODEL NUMBER of the product (WEBE19301)
• The NAME of the product (WEIDER XT55 PRO weight rack)
• The SERIAL NUMBER of the product (see the front cover of this manual)
• The KEY NUMBER and DESCRIPTION of the desired part(s) (see the PART LIST and the EXPLODED DRAWING in its scope and duration to the terms set forth...
English Manual - Page 17
REMOVE THIS PART LIST/EXPLODED DRAWING FROM THE MANUAL
SAVE THIS PART LIST/EXPLODED DRAWING AND THE USER'S MANUAL FOR FUTURE REFERENCE
81
English Manual - Page 18
...2
Weight Adapter Bushing
47
2
50mm Bushing
48
2
25mm Bushing
49
8
45mm Square Bushing
50
2
M8 x 20mm Screw
51
2
Weight Clip
52
1
Pin
53
1
Pulley Bar
54
1
M8 Nylon Locknut
55
7
60mm Square Inner Cap
56
7
M10 x 65mm Bolt
57
3
Support Plate
58
6
M10 Large Washer
#
1
User's Manual
#
1
Exercise Guide
Note: "#" indicates a non-illustrated part. Part List-Model...
Weider Pro Xt55 Reviews
We have not received any reviews for Weider yet.