Dacor SGM466 Support Question
Dacor SGM466 Support Question
Find answers below for this question about Dacor SGM466.Need a Dacor SGM466 manual? We have 3 online manuals for this item!
Question posted by thorbaron1 on October 18th, 2012
What Control Knob Do I Use With The Dacor Sgm466? Is It The 82974?
I thought that the replacement is the 82974/82977. However, some internet sites state that this is only compatible with the SGB365,
Current Answers
Related Dacor SGM466 Manual Pages
Planning Guides - Page 1
... 1/2" * (49.5 cm)
* including embosses/screws in Gas Cooktops
Revised 01/27/11 Page 1/5
PLANNING GUIDE
All tolerances ±1/16" (±1.6 mm), unless otherwise noted. warning
• Observe all governing codes and ordinances during planning and installation. www.Dacor.com
44 5/8" * (113.3 cm)
Product dimensions model sgm466
Phone: (800) 7934-0.5093
Contact your local...
Planning Guides - Page 2
... size and grounding, must be obtained from the cooktop gas inlet to the appliance.
◊ The cooktop comes from the factory with a 1/2" regulator. See the Gas and Electrical Requirements table on or shutting off valve must meet the specifications stated below ). Use only the regulator provided. Model SGM466 comes with a factory installed, 40-inch, three...
Planning Guides - Page 3
... meet or exceed the maximum and minimum dimensions/clearances stated in place. Allow 7 1/2" (19.1 cm) from edge of cooktop. www.Dacor.com
Phone: (800) 7934-0.7093 clearance
to combustible
B
surfaces
Under Cabinet Clearances
Model
(B) Minimum*
SGM304
29" (73.7 cm)
SGM365
35 ¼" (89.5 cm)
SGM466
46" (116.8 cm)
* To allow clearance for countertop cutout...
Planning Guides - Page 4
Document # PG04-004
SGM304, SGM365, SGM466
30", 36", 46" Wide, Gas Cooktops
Revised 01/27/11 Page 4/5
PLANNING GUIDE
Cutout Dimensions
Cutout tolerances +1/16" (+1.6 mm), -0, unless otherwise noted
IMPORTANT: Be careful to use the correct cutout diagram (on page 5/5) to determine proper fit
Floor
Side View - www.Dacor.com
Phone: (800) 7934-0.8093
Countertop Dimensions...
Planning Guides - Page 5
... 1/2" (19.1 cm) min. from mounting surface to change without notice.
www.Dacor.com
Phone: (800) 7934-0.9093 Square Countertop Cutout Diagram
Rear wall
Vertical
combustible
surface
F
G
C
H
D
4 1/4" (10.8 cm) min.
Document # PG04-004
SGM304, SGM365, SGM466
30", 36", 46" Wide, Gas Cooktops
Cutout tolerances +1/16" (+1.6 mm), -0, unless otherwise noted
Rear wall
Revised 01...
Installation Instructions - Page 4
... knobs to the OFF position prior to heat sealed containers. Children could blow over the cooktop.
• Do not climb on the appliance.
• Clean the cooktop thoroughly before operating this appliance.
• Do not install, repair or replace any circumstances:
• Cut or remove the third (ground) prong from the power cord.
• Use...
Installation Instructions - Page 6
...cooktop at the end of the model number listed on the product data label.
** The gas supply pressure for the proper method of the chassis. The regulator must be at the bottom right rear corner (see Chassis Bottom Diagram below . Model SGM466 comes with the product data label, use...hazard, the power supply must meet the specifications stated below ). It is equipped for high altitude ...
Installation Instructions - Page 7
...
B
surfaces
Under Cabinet Clearances
Model
B: Minimum*
SGM304 SGM365 SGM466
29" (73.7 cm) 35 1/4" (89.5 cm)
...cooktop is in place. Raised Vent Compatibility
If installing the cooktop with a raised vent, install only the approved Dacor model numbers specified below the cooktop...use of heat reflective tape, reinforcement of corners, etc.
• Carefully check the location where the cooktop...
Installation Instructions - Page 8
...for the installation type. IMPORTANT: Be careful to use the correct cutout diagram (on the facing page) to total cutout depth (D). SGM Series Cooktop with RV46
Figure 2 (Notched)
5/8" (1.6 cm)...PRV30
SGM304 with RV30
SGM365 without raised vent
SGM365 with ERV36/PRV36
SGM365 with RV36
SGM466 without raised vent
SGM466 with PRV46
Cutout Diagram
Figure 1 (Square)
Figure 1 (Square)
Figure 1 (...
Installation Instructions - Page 10
... cooktop control valves to the OFF position.
◊ Turn on page 4 before use a hardening compound or caulk to the cooktop ...used with a raised vent, install the vent according to the countertop using the two (2)
provided hold down brackets (2) • Gas pressure regulator • Grates (2 for SGM304, 3 for SGM365 and SGM466) • Burner sets (4 for SGM304, 5 for SGM365, 6 for
SGM466...
Installation Instructions - Page 11
... sure that the rubber feet are preset at the circuit breaker panel or fuse box and that the associated burner igniter sparks, then return the knob to adjust the burner air mixture settings. Depress and turn the control knob slowly counterclockwise to operating the cooktop, read the accompanying use and care manual carefully.
1.
Installation Instructions - Page 12
... stated in...using the provided hold-down brackets? Installation Instructions
Verifying Proper Operation (Cont) Installation Checklist
• Once the burner lights, rotate the control knob counterclockwise from HIGH to LOW to adjust the flame height progressively.
• When the unit is the responsibility of the homeowner. The importance of proper installation of your Dacor cooktop...
Installation Instructions - Page 13
... Installation Instructions
Parts List
Replacement parts may be obtained by contacting Dacor Customer Service. Friday 6:00 a.m. left front Burner cap - Dacor Customer Service
Phone: (...Time
Parts Used on All Models
Description
Hold down bracket w/screws (2 sets) Stainless steel cleaner (stainless steel models only)
Dacor Part Number 12269
A302
SGM466
Description
Regulator...
Use & Care Manuals - Page 1
J Use and Care Manual Gas Cooktop
Models: SGM304, SGM365, SGM466
Style varies, model SGM466 shown
Ta ble o f Co nt e nt s
Important Safety Instructions 1 Getting to Know Your Cooktop 4 Setting Up Your Cooktop 5 Operating Your Cooktop 6 Care and Cleaning 8 Before You Call for Service 10 Warranty and Service 11 Warranty Card Back Cover
Part No. 65140 Rev.
Use & Care Manuals - Page 3
... generates some by the State of the chassis.
IMPORTANT...Dacor Customer Service Team about problems or situations that are on the list of this appliance. WARNING
NEVER use any other than warranty questions), call:
Dacor...cooktop.
DANGER
IMPORTANT: If you cannot contact the gas supplier, call the gas supplier. WARNING
NEVER cover the slots between the burner control knobs...
Use & Care Manuals - Page 4
.... Avoid using pans that all control knobs to the cooktop is disconnected.
• Only use utensils with the controls. Wet pot holders can cause serious burns or scalds.
• Use only dry... the cooktop.
• Do not install, repair or replace any part of the cooktop. Keep the entire cooktop, ventilation filters and cooktop hoods free of grease that could blow over the cooktop and ...
Use & Care Manuals - Page 6
...Top View
A
B
B
Spill tray
C
A
Grate
SGM466 - They are equipped with Dacor's Smart Flame technology. Spill Trays: The spill trays catch any food that falls through the cooktop grates. See Operating Your Cooktop for each knob. They indicate the heat setting for more information.
Top View
A
B
Trim ring
Burner control knob
C
A
SGM365 - Other Features
Flame-less Ignition...
Use & Care Manuals - Page 8
... cover the slots between the burner control knobs and the trim rings on the grate.
• Cookware with a match or other open flame.
• If the gas does not ignite after four seconds or if the flame goes out and gas escapes, turn the knob to use your cooktop without the burners completely and properly...
Use & Care Manuals - Page 9
... finger, where the flame height is reduced by Dacor's Smart-Flame feature. Griddle (Dacor Model# AG11 or AG13): The optional griddle is... will result in new construction, may continue to spark if the control knob is set to the LOW position. It is designed to cook....flame height to the minimum level necessary to the cooktop.
It is used for simmering and holding food at a higher flame setting ...
Use & Care Manuals - Page 11
.... Do not use a small amount of moisture into the control panel behind the trim rings.
6. Reassemble the cooktop according to the...Knobs and Trim Rings
1. Grasp each use abrasive cleaners or scrubbers on page 5. Do not remove the trim rings, they should be sure that are properly positioned, then check for this task. Dacor recommends hand dishwashing liquid.
5. To replace the knobs...
Similar Questions
I Have A Dacor Gas Cooktop #eg 366 Sch, One Of The Burner Knob Lights Has Burned
How do I replace a burned out light in burner knob for Dacor EG366 gas cooktop. I can find the repla...
How do I replace a burned out light in burner knob for Dacor EG366 gas cooktop. I can find the repla...
(Posted by allanreinhard 8 years ago)
Several Heat Control Keys Are Blinking Repeatedly
I have a brand new cooktop that I tried to operate for the first time. After turning on and off seve...
I have a brand new cooktop that I tried to operate for the first time. After turning on and off seve...
(Posted by yakovkorenfeld 9 years ago)
Where Is The Power Plug For The Dacor Sgm466?
there is gas flowing but no sparkers
there is gas flowing but no sparkers
(Posted by jhertzel27 11 years ago)
Model# Smg466 Steel Top Frame Replacement
Where can we order the following replacement partsdoor our Dacor stove Model#sgm466: 1) Steel Top F...
Where can we order the following replacement partsdoor our Dacor stove Model#sgm466: 1) Steel Top F...
(Posted by ctennison 12 years ago)
We Often Smell Gas When Our Dacor Eg366 Is Not In Use. Is This Normal?
(Posted by kzw88 12 years ago)