Frigidaire FAQE7011LW Support Question
Frigidaire FAQE7011LW Support Question
Find answers below for this question about Frigidaire FAQE7011LW.Need a Frigidaire FAQE7011LW manual? We have 5 online manuals for this item!
Question posted by Anonymous-160366 on October 12th, 2016
How Dose One Unlock Control Board To Run Tests?
just changed control board it must be unlocked how?
Current Answers
Answer #1: Posted by waelsaidani1 on October 24th, 2016 12:16 AM
waelsaidani1
Member since:
May 12th, 2013 Points: 19,501,777
Member since:
May 12th, 2013 Points: 19,501,777
. If there is power coming to the main board, but not out, you will need to replace the main control board. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Related Frigidaire FAQE7011LW Manual Pages
Wiring Diagram (All Languages) - Page 1
...test again. If problem persists, replace electronic control. control lock is not 50 K (± 10%), replace thermistor. cycle has been interrupted.
137312700A 1003 CAUTION: DISCONNECT ELECTRICAL CURRENT BEFORE SERVICING Please Return This Sheet to third position from dryer...such as: no heating)
Temperature reading of control thermistor has not changed in the digit display. Error Code
E10 ...
Wiring Diagram (All Languages) - Page 2
...is pressed, all LEDs will flash.
1 turn:
Drive motor runs; Dryer will make the numbers decrease. FUNCTION TEST SEQUENCE 1. After entering the test mode, the cycle selector knob can now be ON. When...and numbers appear in the display.
2 turns:
Drive motor runs; Control thermistor reading is off . The control will enter test mode, the buzzer will sound three times and all the ...
Complete Owner's Guide (English) - Page 3
...in, or spotted with gasoline, cleaning solvents, kerosene, waxes, etc. WARNING
FIRE HAZARD A clothes dryer produces combustible lint. This could cause a load to eliminate static unless recommended by the manufacturer of ...to fire or serious injury. Do not stack or place laundry or throw rugs against the front or back of the dryer.
• Do not spray any type of lint around the opening...
Complete Owner's Guide (English) - Page 4
... do so can become airtight chambers.
• Keep laundry products out of all warnings on or in the dryer. Wait until the dryer has stopped completely before attempting any service or cleaning. ... Use only authorized factory parts.
• Do not tamper with controls.
• Do not install or store the dryer where it checked and reinstalled by an authorized servicer unless specifi...
Complete Owner's Guide (English) - Page 6
...there may be sounds generated as the valve opens and closes to control the gas flow. The noise should dissipate as the dryer operates and the flat spot on the edge of the ... injury. This could be a thumping or rolling sound when the dryer starts. This noise is normal and will only occur when the gas is controlled by a set some sounds associated with load size and type. ...
Complete Owner's Guide (English) - Page 7
...door is opened.
See the "Dryer Settings Chart" for ten seconds to return to factory settings.
5 Start the cycle.
• To add or remove items when the dryer is running, open the door. then, ... To change the drying temperature and dryness level, press the Temp or Dry Level buttons to scroll to the desired settings.
• To select or delete an option, press Options; The dryer will ...
Complete Owner's Guide (English) - Page 9
... Protolcol P154 Sanitization Performance of Residential Clothes Dryers
This option will be changed before the cycle is desired.
Í... by NSF International®, an independent third-party testing and certification organization dedicated to public health... higher temperatures is selected in 25 minutes.
To protect your laundry. Allergy (on items to be able to select a Dryness ...
Complete Owner's Guide (English) - Page 11
...drying rack you may be displayed when the cycle is opened to lock or unlock the controls.
11 To remove the control lock, press Options and Select again. The following indicators may order one.... Drum Light The drum light will come on whenever the door is selected.
Reversible Door Your dryer is displayed during loading and unloading. Press and hold for 10 seconds. Place items to be...
Complete Owner's Guide (English) - Page 15
...flow, which causes longer drying times. These areas can damage the finish or controls. The dryer must be connected to 8 parts water).
Remove by pulling straight up , wash them with mild...IMPORTANT
Do not store or place laundry products on top of the tape or label.
• When cleaning chrome parts use any time. Do not operate the dryer without the lint filter in...
Complete Owner's Guide (English) - Page 17
....
Permanently attached items such as belt buckles, zippers and fasteners may be hitting the inside the dryer.*
Always remove foreign objects from drum and restart dryer.
Dryer runs but the heater will be at least 4 inches in INSTALLATION INSTRUCTIONS.
If 1 of natural gas (gas models). Exhaust duct requirements have not been followed.
or ...
Installation Instructions (All Languages) - Page 3
...
‰ Approved strain relief installed ‰ Terminal access cover installed before using this dryer.
CAUTION
CAUTION indicates a potentially hazardous situation which , if not avoided, will result in... turned on ‰ Dryer plugged in
Final Checks
‰ Installation Instructions and Use and Care Guide read all safety messages that follow this guide ‰ Test hinge and latch for...
Installation Instructions (All Languages) - Page 5
... allow, flexible metal tubing may be constructed of the gas supply connection to the dryer.
6 The dryer MUST be disconnected from the gas supply piping system during any pressure testing of the gas supply piping system at test pressures equal to natural gas, causing gas leaks. The tubing MUST be used to connect...
Installation Instructions (All Languages) - Page 7
... the duct work and creating a fire hazard as well as increase drying times. The dryer must be exhausted outdoors. Regularly inspect the outdoor exhaust opening and in the surrounding area.
Lint ... fittings MUST be installed downstream with metal foil duct tape. Do not exhaust dryer into the laundry area. Use an approved vent hood to terminate the duct outdoors, and seal all ...
Installation Instructions (All Languages) - Page 8
... system is acceptable:
1 Connect an inclined or digital manometer between the dryer and the point the exhaust connects to the dryer.
2 Set the dryer timer and temperature to air fluff (cool down drafts causing an increase in vent restriction.
• Running the exhaust system through your local parts distributor or hardware store. Although...
Installation Instructions (All Languages) - Page 12
... hazard.
Electrical shock can cause electrical shorts. For a grounded, cord-connected dryer:
1 The dryer MUST be properly grounded. Grounding requirements - INSTALLATION INSTRUCTIONS
Electrical installation
The following are...If in this dryer. A chemical reaction occurs between copper and aluminum and can result if the dryer is not properly grounded.
Refer to be run with this manual ...
Installation Instructions (All Languages) - Page 14
... technician.
2 Connect a 1/2 inch (1.27 cm) I.D. Apply an approved thread sealer that allows ease of the dryer.
Wait a few minutes for gas leaks with an open flame.
14 WARNING
EXPLOSION HAZARD NEVER test for gas to dryer
Shutoff Valve Open position
from gas pipe at the rear of opening and closing. Manual Shutoff...
Installation Instructions (All Languages) - Page 21
... "T" post on the back of strike to align the mounting holes. "T" POST ON DOOR HINGE
"T" SLOT IN FRONT PANEL
REVERSING DOOR
3 Close the door and test operation of hinge, strike and latch.
2 While supporting the door, install the upper pan head screw first and then the lower one.
Í NOTE...
Installation Instructions (All Languages) - Page 22
... Pen -
P/N CFPWD15N Classic Red Pedestal - UNIVERSAL APPLIANCE WRENCH
P/N 137019200 A UNIVERSAL APPLIANCE WRENCH is available to disconnection when servicing controls. P/N 5304468812 Classic Red Touch Up Pen - P/N 5304458932
*Other colors may be used to the dryer.
(682.57.0cm" )
(3185c.0m")
(2667.5c"m)
DRYING RACK
P/N 137067300
Depending on top of matching washer may be...
Product Specifications Sheet (English) - Page 1
...or less in width.
DrySense™ Technology
Dries your clothes more laundry, even faster. Wrinkle Release Technology
Express-Select® Controls
Easily select options with the touch of
a button. Ultra-Capacity Dryer
The largest in :
Classic Black
(B)
Classic White
(W)
1Based on I.E.C. Front Load Dryers
FAQE7011L B / W
Optional SpaceWise® Pedestal Drawer Shown
Signature Features...
Product Specifications Sheet (English) - Page 2
...7.0 Cu. Depth Depth with Door Open 90˚ Pedestal Dimensions A - Width C -
Refer to change. Ft.) Controls Dryer Drum Interior Interior Light Door Trim Ready Steam™ DrySense™ Technology Wrinkle Release Technology TimeWise™ ...
Features
Total Capacity (Cu.
B
C
A
B
C
A
NOTE: For planning purposes only. Printed in the U.S.A. Ft.
Front Load Laundry -
Similar Questions
Replaced Control Board Frigidaire Dryer Model Feq1442ceso,still Flashing,beeping
(Posted by stlhdr 9 years ago)
Its Seems Fridgidaire Models Agq6000est And Others Made Bad Control Boards Need
(Posted by robertnash18252 10 years ago)
My Frigidaire Dryer #134431300d-0801 Just Quits And All Lights Flash!
My Frigidaire dryer #134431300D-0801 just quits and all lights flash!
My Frigidaire dryer #134431300D-0801 just quits and all lights flash!
(Posted by bananalunajane 10 years ago)
My Frigidaire Affinity Dryer Will Not Start. All Lights On But No Go.
(Posted by Skubinna 11 years ago)
Control Board Power Relay Burned. What Is Cause?
(Posted by emal21578 12 years ago)