Frigidaire IM115 Support Question
Frigidaire IM115 Support Question
Find answers below for this question about Frigidaire IM115 - Ice Maker Kit.Need a Frigidaire IM115 manual? We have 1 online manual for this item!
Question posted by SupKok on June 2nd, 2014
How To Clean Gd-21 Kenmore Ice Maker
The person who posted this question about this Frigidaire product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Frigidaire IM115 Manual Pages
User Manual - Page 1
..., contact your local hardware or plumbing supply store. The manufacturer will be responsible for cleaning.
ICE MAKER INSTALLATION INSTRUCTIONS
To avoid electric shock, which can cause death or severe personal injury, disconnect the refrigerator from your dealer to install the ice maker kit. • 1/4 inch copper supply line with shelf). Water supply tubing made of the...
User Manual - Page 2
...; Needle Nose Pliers • Adjustable Wrench
2 Use This Page to Identify Parts
1. Screws - Plastic Clamp - Water Inlet Tube - Leveling Bracket Screw - Steel Clamp - Water Valve - Ice Maker
2. Ice Container
3. Plastic Water Supply Tubing
4. Qty 2
5. Qty 1
7. Qty 1
9.
User Manual - Page 3
... bracket screw(s). Slowly lift up and pull on back of refrigerator.
3 Peel off label covering ice maker hole.
7. DO NOT remove compressor sound baffle (A), if installed.Carefully bend condenser out away from... to remove.
4. Rotate while inserting tube until right side of hole. 1. Remove ice tray rack from freezer (some models) by pushing shelf to rear of refrigerator and ...
User Manual - Page 4
...) as far as it will be tightened later.)
13. Tighten another one hand, plug ice maker connector into freezer wall. Mount ice maker onto two screws (5) you installed in one half turn with screw (6). Adjust leveling bracket (7) to level ice maker (1). DO NOT tighten bracket. (Bracket will go and finger tighten nylon compression nut onto threaded...
User Manual - Page 5
... water tubing to rear of cabinet with exterior condenser, reinstall condenser brackets and tighten down screws.
21. On models with two plastic clamps (9). Use a power drill with a Phillips® head bit to water valve. NOTE: Clean back of water valve as far as it will go.
On refrigerators with a commercial household cleaner...
User Manual - Page 6
.... Air in areas where temperatures fall below freezing. • Connect the ice maker to your appliance dealer at the back of arm.)
IMPORTANT: It takes approximately 24 hours for cleaning.
• A shutoff valve to connect the water supply line to begin producing ice. To Avoid Property Damage: • Copper tubing is not tied into...
User Manual - Page 7
... in its
“down” or ON position.
Do not connect the ice maker to the closed position.
7 If your ice quality. Rinse well and dry. • Stop the ice maker when cleaning the freezer or for short vacations. • If the ice maker will be sure the wire signal arm is in the “up ” or...
Similar Questions
Ice Maker Model Number Gd-21.where Is The Filter Located And How To Replace It.
(Posted by soryanth 9 years ago)
How To Adjust Model Type Gd 21 Ice Maker
(Posted by 4s2gcmrharr 10 years ago)
Gd-21?
Does IM115 replace model GD-21? This is for the Frigidaire PLHT219SCK5. Thanks, Susan
Does IM115 replace model GD-21? This is for the Frigidaire PLHT219SCK5. Thanks, Susan
(Posted by honeyholmes 11 years ago)
Space Dimension Requirements For Frigidaire Complete Ice Maker Kit Im-501?
I plan to install an ice maker in a small upright freezer. I need the dimension requirements for th...
I plan to install an ice maker in a small upright freezer. I need the dimension requirements for th...
(Posted by dan1b 12 years ago)
Fridgidaire Ice Maker Model Gd-21. Drips Water Into Tray. No Cubes.
At work we have a Frigidaire refrigerator model GLRT212IDB1 with facory installed ice maker, model G...
At work we have a Frigidaire refrigerator model GLRT212IDB1 with facory installed ice maker, model G...
(Posted by hdmaster 13 years ago)