Magic Chef MCSCWD20W3 Support Question
Magic Chef MCSCWD20W3 Support Question
Find answers below for this question about Magic Chef MCSCWD20W3.Need a Magic Chef MCSCWD20W3 manual? We have 1 online manual for this item!
Question posted by jasonmallory1971 on November 28th, 2023
When Washing The Water Is Very Hot
Hello, The water is very hot even though the temp is set to cold water. I have even shut the hot water line off.Is there a reset to get the temp to cold?Thanks
Current Answers
Answer #1: Posted by SonuKumar on November 28th, 2023 10:53 PM
SonuKumar
Member since:
May 9th, 2021 Points: 16,609,800
Member since:
May 9th, 2021 Points: 16,609,800
It sounds like there may be an issue with the mixing valve in your Magic Chef MCSCWD20W3 washer-dryer combo. The mixing valve is responsible for regulating the temperature of the water by mixing hot and cold water. If the mixing valve is stuck open, it will allow hot water to flow into the machine even when you have selected the cold water setting.
Here are a few steps you can try to troubleshoot the problem:
Check the cold water inlet hose: Make sure that the cold water inlet hose is properly connected to the cold water faucet and that the water supply is turned on.
Check the water inlet valve: The water inlet valve is the valve that controls the flow of water into the machine. If the valve is malfunctioning, it could be causing hot water to flow into the machine even when you have selected the cold water setting. You can test the valve by disconnecting the cold water hose from the valve and opening the faucet. If water comes out of the hose, then the valve is likely faulty and will need to be replaced.
Check the mixing valve: The mixing valve is located at the back of the machine. It is a small valve with two hoses connected to it: one for hot water and one for cold water. To test the mixing valve, turn off the hot water supply to the machine and then open the cold water faucet. If hot water still comes out of the machine, then the mixing valve is faulty and will need to be replaced.
If you are not comfortable troubleshooting the problem yourself, you can contact a qualified appliance repair technician to have the machine serviced.
Please respond to my effort to provide you with the best possible solution by using the "Acceptable Solution" and/or the "Helpful" buttons when the answer has proven to be helpful.
Regards,
Sonu
Your search handyman for all e-support needs!!
Related Magic Chef MCSCWD20W3 Manual Pages
User Manual - Page 1
2.0 Cu. Ventless Washer Dryer Combo
User's Manual
Model MCSCWD20W3
PLEASE READ THIS MANUAL CAREFULLY BEFORE USING YOUR WASHER DRYER COMBO AND KEEP IT FOR FUTURE REFERENCE.
1 Ft.
User Manual - Page 4
...WASHING MACHINE
1. WARNING: Risk of the grounding plug and/or outlet can result in the Troubleshooting section.
This appliance is necessary. The appliance must be used only for future reference. PRECAUTIONS
NOTE: Before using your Combo Washer....
Review this manual to properly use and maintain your Combo Washer/ Dryer. Wall outlet with a 3-prong receptacle
Power supply cord...
User Manual - Page 5
... designed for clothes and garments suitable for indoor use detergents that water and electrical devices are properly connected by a protruding part. BEFORE OPERATING THIS APPLIANCE
• Packing materials may be operated in "Cotton" and "Hot Water" settings without any clothes inside the machine.
CAUTION WHEN WASHING CLOTHES
• Cold and hot water must be dangerous to children.
User Manual - Page 7
...allow children to a complete stop before using the appliance. DO NOT wash articles that have been previously cleaned in, washed in, soaked in the washer that have been dampened with wet or damp hands.
3. Doing ...below freezing.
15. If the hot water system has not been used for 2 weeks or more, turn on or in or spotted with controls.
7 DO NOT wash or dry anything that they may ...
User Manual - Page 8
This washer must be dissipated. 17... service agent
to disconnect the plug and cut off water supply after operation. 25. Contact a qualified service center/agent through the manufacturer for any cleaning...is recommended to avoid any danger. 20. DO NOT repair or replace any part of the washing machine. 21. To ensure your receptacle is damaged, it must be plugged into a properly grounded...
User Manual - Page 9
ft. 0.05Mpa - 1.0Mpa
9 SPECIFICATIONS
23.5" (595 mm)
Figure 2
Height Width Depth Depth with Door Opened Weight Voltage / Frequency Rated Current Washing Capacity Dry Capacity Drum Size Standard Water Pressure
23.5" (595mm)
41.0" (1035mm) 174.0 lbs. (79.0 kg) AC 120V~60Hz 12A
7.7 lbs. (3.5 kg) 2.0 cu.
User Manual - Page 10
...Carpenter's level
Water Hoses (2)
Transport Cable Tie Hole Plugs (4)
UNPACKING THE WASHING MACHINE
• Unpack your washing machine and ...laundry room, closet, or recessed area. Companion appliance location requirements should also be kept away from any item is not level, adjust the leg levelers. (Refer to Figure 3). DISPOSE OF PACKING MATERIALS
The packing materials for your Washer...
User Manual - Page 11
....5" (850 mm)
1.0" (25 mm)
23.5" (595 mm)
1.0" (25 mm)
11 You will need:
• A water heater set to deliver 120°F (49°C) water to the washer.
• A grounded electrical outlet located within 4 ft. (1.2 m) of the hot and cold water fill valves, and water pressure of 20-100 psi (137.9 - 689.6 kPa) .
• A level floor with a maximum slope...
User Manual - Page 12
... is any leakage from the bottom of the washer.
2" (50 mm)
Figure 9
minimum 23" (600 mm) maximum
39" (1000 mm)
12
Figure 6
Figure 7 Hot Cold
Figure 8 Figure 10 Store the transport bolts ...the backside of this washing machine, transport bolts must be at the backside of washing machine and fasten the pipe tightly clockwise. For models with a hot valve, connect the hot valve to Figure 8.)
...
User Manual - Page 13
.... Ensure the position of washing machine in sequence.
Use a carpenter's level on top cover of the washing machine. The siphon break must be
required.)
LEVELING THE WASHER
1. If not, turn...and fasten the nut closely to ensure the legs have been adjusted properly. Laundry Tub Drain System (Figure 11) The laundry tub needs a minimum 20 gallons (76 L) capacity. Figure 11
Floor ...
User Manual - Page 15
... the washer is paused and the current wash cycle is running. Press [Start/Pause] once more to spin a load separately from a regular wash cycle. • Soap water or rinse water must select another program to rinse and spin a load separately from a regular wash cycle. • This can be helpful in preventing fresh stains from setting in fabrics...
User Manual - Page 16
...load of dryer. (Refer to dry a load, then the wash load must be added.
13.
Temp.: Press [Temp.] to pause a cycle. h. Then press [Spin] and hold...Delay] to set your desired washing temperature.
DO NOT cut off water supply or remove hose attachments during dry cycles.
Only wash loads at a speed up to decrease the washing time. ...Washer drum spins at capacity of clothes.
User Manual - Page 17
... stage of the wash cycle (not available on or off.
Extra Rinse: Press the [Temp.] and [Spin...settings. • You can be changed anytime before [Start/Pause] is pressed. q.
LCD DISPLAY
Figure 16
c
c
b
a
d
e
a. k.
m.
p. o. l. To manually drain the washer: • Press [On/Off] to the end of wash/dry cycle.
•
: Prewash
Speed Wash
•
: Wash...
User Manual - Page 18
Water Temperature: Indicates the selected temperature.
d.
f. b.
Soil Level Indicator: Indicates the selected soil level. Clock: Indicates time left until the end of cycle.
•
Child Lock: Child lock is on .
•
Door Lock: Machine is locked for duration of wash/dry cycle. c. Dry Level: Indicated the selected dry level.
18 e. Spin Speed: Indicates...
User Manual - Page 19
...FROM CLOTHES
Check all laundry products in accidents.
• Bleach can damage clothes.
Use powder or liquid detergents only. • Water-proof materials: It is not recommended washing water-proof fabrics as decorations... reach of your washer/dryer combo unit.
Consult the water company if you are not clear of time. NOTE: All new colored fabrics must be washed and remove any ...
User Manual - Page 21
....
21 NOTE: If you have loaded the washer and added laundry products, you the options for that means it is displayed in the table, then that is the default setting for each cycle. Depending on the desired cycle, all settings, press and hold [Spin] to a power source and water lines.
• Tap should be turned on...
User Manual - Page 24
... must be removed from the drum. 2.
Wipe with clean water. For powder tub cleaner, add directly to the wash drum. 6.
Figure 19
2. CLEANING THE EXTERIOR OF THE ...UNIT
NEVER use solvent based, abrasive cleaners, harsh chemicals or steel wool.
1. Use a soft sponge and rinse with a soft clean towel to clean your combo washer...
User Manual - Page 25
... the coin trap and remove articles.
5. Close the coin trap door. Figure 22
25 After 40 seconds, stop the cycle and remove the hot and cold water hoses from the wash
cycle. Unscrew the inlet pipe from the backside of the unit.
4.
If your wall connection has a built-in filter, pull out filter
with...
User Manual - Page 26
... . Too
detergent drawer
much detergent is not connected firmly. Water temperature is turned on and power plug is pressed. Check if water supply tap is too cold. Check if [On/Off] is properly connected. Can normally wash clothes but cannot wash with cloth.
Check and tighten all water pipes and connections. Clean drain pipe. Fix the...
User Manual - Page 27
... wash
Do not wash
No dry clean
No wring
Cl
No bleach
Do not tumble dry
Do not iron
Iron with cloth
Dry after wash
Line dry in the room/house. Call for service if problem persists. E10
(Water filling time blocked. Inlet pipe may be twisted Water Straighten water pipe. Wash
E21
(Drain time exceeds pump is shut...
Similar Questions
Bottom Door
what is the spring loaded door for on the underside of the washing machine
what is the spring loaded door for on the underside of the washing machine
(Posted by Glpiha77 7 months ago)
What Is Error Code E55
After using spin cycle only times out and gives error E55.. wont spin up the cloths fast,, barrel go...
After using spin cycle only times out and gives error E55.. wont spin up the cloths fast,, barrel go...
(Posted by chuckthebull 1 year ago)
Too Much Water From Emergency Drain Hose.
I used too much detergent in a Magic Chef MCSFLW27W and it overflowed badly. A serviceman came over ...
I used too much detergent in a Magic Chef MCSFLW27W and it overflowed badly. A serviceman came over ...
(Posted by sciencetchr56 1 year ago)
Water Leak
We just purchased a new unit model #Mcscwd27s5 ran one load perfect and the second load I did notice...
We just purchased a new unit model #Mcscwd27s5 ran one load perfect and the second load I did notice...
(Posted by jennifermosher12 2 years ago)