Troy-Bilt TB575 Support Question
Troy-Bilt TB575 Support Question
Find answers below for this question about Troy-Bilt TB575.Need a Troy-Bilt TB575 manual? We have 2 online manuals for this item!
Question posted by jcb5797 on August 26th, 2015
I Just Replaced The Tank And Primer Bul On My Tb575ec And Cannot Get Fuel Into T
I cannot get fuel into the primer bulb. I replaced the tank and the bulb but still nothing
Current Answers
Answer #1: Posted by TechSupport101 on August 27th, 2015 3:26 AM
TechSupport101
Member since:
May 24th, 2013 Points: 12,171,305
Member since:
May 24th, 2013 Points: 12,171,305
The fuel lines may also/or be the ones that have issues. Please see the article here http://homeguides.sfgate.com/fix-lawn-mower-carburetor-primer-not-priming-102114.html for some more insight on this subject.
Related Troy-Bilt TB575 Manual Pages
Operation Manual - Page 1
... Rights Reserved.
(5/06) Please read these instructions for later use. If it requires replacement, ask your state or local authorities for regulations pertaining to obtain a list of California... Rules for Safe Operation 2 Know Your Unit 3 Assembly Instructions 3 Oil and Fuel Information 4 Starting/Stopping Instructions 5 Operating Instructions 6 Maintenance and Repair Instructions 8...
Operation Manual - Page 2
....
• All guards and safety attachments must be fatal. Make sure all fasteners are no sparks or flames. Replace parts that are cracked, chipped, or damaged in any pressure in the tank.
• Add fuel in a clean, well-ventilated outdoor area where there are in a well-ventilated outdoor area.
• Wear safety glasses...
Operation Manual - Page 3
...of oil.
Remove the screws and
bottom clamp piece that were installed on the handle just enough to the location that provides you make the handle adjustment. You may appear on...On/Off Stop
Control D-Handle
Click Link
Starter Rope Grip
Throttle Control
Fuel Cap
Choke Lever
Air Filter Primer Cover Bulb
Shaft
Line Cutting Blade
Cutting Attachment Shield
• ON/OFF STOP CONTROL...
Operation Manual - Page 4
... the engine.
NOTE: Do not overfill the tank.
3. it to avoid injury from the crankcase (Fig. 3).
4.
Replace the top. Refer to the unit's gas tank. Use fresh fuel (less than 60 days old), when using dirty oil, can keep fuel from the area.
FUELING THE UNIT
WARNING: Remove fuel cap slowly to cool before each use the...
Operation Manual - Page 5
.... The engine fails to 30 seconds.
10.
Check the oil level in Position 3 and squeeze the throttle control. Fill the fuel tank with fresh, clean unleaded gasoline. Fully press and release the primer bulb 10 times, slowly. Squeeze the throttle control lever. Press the On/Off Stop Control switch in the ON ( I )
WARNING: Avoid...
Operation Manual - Page 8
... necessary after 10 hours on new engine Every 25 hours Every 25 hours
MAINTENANCE REQUIRED
Fill fuel tank with new line
• Install a pre-wound inner reel
Winding the Inner Reel With ... line is inserted correctly.
6. If you are two methods to replace the SpeedSpool® trimming line:
• Wind the inner reel with fresh fuel Check oil
Clean and re-oil air filter
Change oil Change oil...
Operation Manual - Page 9
... the engine. Remove any debris or grass from the outer spool.
3. Remove any dirt or debris from the holding slots in the crankcase cannot be just touching the inner most thread on the plunger (Fig. 25). Inner Reel Fig. 24
CHECKING THE OIL LEVEL
The importance of checking and maintaining the...
Operation Manual - Page 10
...7. NOTE: If the unit is an important item to spread and remove excess oil (Fig. 34). 6. Replace the oil fill plug. 7. Then pull the air filter cover out and up any oil residue on the air...clean SAE 30 motor oil to measure the correct amount of oil and recheck. Squeeze the filter to maintain. Replace the filter (Fig. 31). Fig. 32
Fill Level
Fig. 33
Fig. 34
Fig. 30
6. Reconnect the...
Operation Manual - Page 11
... spark plug. Remove the engine cover (Fig. 38). Drain and refill the tank with a feeler gauge after checking the fuel and cleaning the air filter, the engine still will not idle, adjust the ...Screws
Fig. 38
5. Clean dirt from around the rocker arm cover. Idle Adjustment Screw
Check Fuel
Old fuel is usually the
reason for an out of adjustment carburetor. If, after the first 10 hours ...
Operation Manual - Page 12
...screws. Grasp the plug wire firmly and pull the cap from around the spark plug. Replace cracked, fouled or
dirty spark plug.
Grit in . (0.127 mm) feeler gauge.
...the engine cover with a slight amount of operation and check its condition.
1. REPLACING THE SPARK PLUG
Use a replacement part number 753-05255 spark plug. socket counterclockwise.
0.025 in the cylinder head...
Operation Manual - Page 13
...plug and drain all gasoline from the carburetor.
3. Repair or replace damaged parts and tighten loose screws, nuts or bolts. Do not... muffler (Fig. 43). Clean the spark arrestor screen with fuel in accordance to start the trimmer after storage.
4.
Remove ...8226; Secure the unit while transporting.
• Drain the gas tank before transporting.
• Tighten gas cap before you clean or ...
Operation Manual - Page 14
.../Off control to ON Fill fuel tank with new fuel Press primer bulb fully and slowly 10 times Drain gas tank and add fresh fuel Replace or clean the spark plug Clean or replace spark arrestor
ACTION Replace or clean the air filter Drain gas tank and add fresh fuel Adjust carburetor
ACTION Drain gas tank and add fresh fuel Take to an authorized...
Operation Manual - Page 15
... Plug Gap ...0.025 inch (0.655 mm) Lubrication ...SAE 30 Oil Crankcase Oil Capacity ...3.04 oz (90 ml) Fuel ...Unleaded Carburetor...Diaphragm, All-Position Starter...Auto Rewind Muffler ...Baffled with Guard Throttle...Manual Spring Return Fuel Tank Capacity...14 oz (414 ml)
DRIVE SHAFT AND CUTTING ATTACHMENT* Drive Shaft Housing ...Steel Tube (EZ-Link...
Operation Manual - Page 17
...in material and
workmanship which cause the failure of a warranted part for replacement, as the carburetor or fuel-injected system, the ignition system, and catalytic converter. If you have any...to ensure the performance of the engine, air filter, carburetor, primer, fuel lines, fuel pick up to the first scheduled replacement point for that the engine is scheduled for only for regular
...
Operation Manual - Page 18
...improve the design of any Troy-Bilt product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for products sold through Troy...those sold or exported outside of the United States of America, its option, repair or replace, free of export distribution. Tune-ups - During the period of the Warranty, the exclusive...
Operation Manual - Page 53
PARTS LIST
REPLACEMENT PARTS - MODELS TB575SS & TB525CS 4-CYCLE GAS ...23) Muffler Screw Spark Plug Insulator Gasket Nut Insulator Carburetor Gasket Carburetor w/Primer
Item 30 31 32 33 34 35 36 37 38 39 40 41...Ring Air Cleaner Cover Assembly (includes 32) Air Filter Screw Fuel Tank Assembly w/Fuel Lines (includes 35) Fuel Cap Fuel Tank Pads Push Nut Pressure Plate Screw Pressure Plate (includes 38...
Operation Manual - Page 54
PARTS LIST
REPLACEMENT PARTS - MODELS TB575SS 4-CYCLE GAS TRIMMER
1
4 1
23 56 7
10
15 Item Part No. Description
1 753-04234 Throttle Housing Assembly (includes 2-4) 2 753-04119 Throttle Trigger 3 791-...
Operation Manual - Page 55
5 4
PARTS LIST
REPLACEMENT PARTS - Description 753-04234 Throttle Housing Assembly (includes 2-4) 791-182690 Throttle Trigger Spring 753-04119 Throttle Trigger 791... Assembly (includes 34 & 35) 753-04929 Complete Cutting Head Assemly
(includes 17, 20, 21, 24-36)
Optional Accessorie * 791-180120 Replacement Line, 0.095"
* Items Not Shown
7 12 13 14
11 15
17 22
23 21
24 25
28 30
32
34 35
16 ...
Parts List - Page 2
REPLACEMENT PARTS - MODEL TB575es
4-CYCLE GAS TRIMMER
PPN ... 23) Muffler Screw Spark Plug Insulator Gasket Nut Insulator Carburetor Gasket Carburetor w/Primer
Item 30 31 32 33 34 35 36 37 38 39 40 41 ...Ring Air Cleaner Cover Assembly (includes 32) Air Filter Screw Fuel Tank Assembly w/Fuel Lines (includes 35) Fuel Cap Fuel Tank Pads Push Nut Pressure Plate Screw Pressure Plate (includes 38) ...
Parts List - Page 3
4 1
23 56
REPLACEMENT PARTS - MODEL TB575es 4-CYCLE GAS TRIMMER
PPN 41CDT57C966
1
7
8
9
10
11
13
12
Item 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
...
Similar Questions
How To Replace Primer Bulb Lines On Tb675ec With A Two Port Primer
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
(Posted by dsnyder488 9 months ago)
How Do I Replace The Primer Bulb On Tb625 Ec
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
How do I get the cover off a Troy Bilt TB625 EC Trimmer so I can replace the Primer bulb
(Posted by Myers8708 2 years ago)
How To Replace Pull Rope On Troybilt Trimmer Tb575es
(Posted by jwclevenger 3 years ago)
How To Replace The Starter Rope.
The starter rope of my TB575 EC has come off of the starter housing assembly (spool) and is rapped a...
The starter rope of my TB575 EC has come off of the starter housing assembly (spool) and is rapped a...
(Posted by paparowe62 8 years ago)
Troy Bilt Tb575 Fuel Leak From Cap And From Carb Area, Used Only A Few Times.
(Posted by edonscene 8 years ago)