Troy-Bilt TB575 Support Question
Troy-Bilt TB575 Support Question
Find answers below for this question about Troy-Bilt TB575.Need a Troy-Bilt TB575 manual? We have 2 online manuals for this item!
Question posted by edonscene on May 16th, 2015
Troy Bilt Tb575 Fuel Leak From Cap And From Carb Area, Used Only A Few Times.
The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.
Current Answers
Related Troy-Bilt TB575 Manual Pages
Operation Manual - Page 1
...time without notice. For more details about your unit, visit our website at any bystanders. SPARK ARRESTOR NOTE NOTE: For users on forest brush and/or grass-covered areas...Know Your Unit 3 Assembly Instructions 3 Oil and Fuel Information 4 Starting/Stopping Instructions 5 Operating Instructions 6...constructed, equipped and maintained for later use. CALIFORNIA PROPOSITION 65 WARNING
WARNING
...
Operation Manual - Page 2
... pressure in the tank.
• Add fuel in a clean, well-ventilated outdoor area where there are cracked, chipped, or damaged in the starting the unit. Do not operate unit without the fuel cap securely in containers specifically designed and approved for fuel leaks. Remove the fuel cap slowly, and only after each use them these instructions. Take the following...
Operation Manual - Page 3
...the line cutting blade.
• UNLEADED FUEL Always use clean, fresh unleaded fuel
• ON/OFF STOP CONTROL ON ... the end of oil. Keep away from the operating area.
• CHOKE CONTROL
1. • FULL choke position...warning or caution. They remain hot for a short time after the unit is secure. To prevent serious injury... Rope Grip
Throttle Control
Fuel Cap
Choke Lever
Air Filter Primer...
Operation Manual - Page 4
...Spout
Fuel Tank Fig. 5
4
Fuel Cap
Use a high-quality SAE 30 weight oil of oil in the crankcase is important and cannot be overemphasized. It can keep fuel from the area. ...use of gum deposits. OIL AND FUEL INFORMATION
WARNING: To avoid serious personal injury, the cutting attachment shield MUST be in place at all times while operating the unit as needed . RECOMMENDED OIL TYPE Using...
Operation Manual - Page 5
... in a confined area. While squeezing the throttle control , pull the starter rope briskly 1 to 4 times to start the engine.
9. Keep the throttle squeezed and allow the engine to warm up for use. IF... Throttle ...bulb, press and release the bulb as many times as it .
5. IF... Fill the fuel tank with fresh, clean unleaded gasoline. Some amount of fuel should start , go back to cool down by...
Operation Manual - Page 6
... (Fig. 9).
2. EZ-Link™ Coupler
Release Button Primary Hole
WARNING: Before you begin using the line head cutting attachment with the guide recess will help installation (Fig. 9). CAUTION: Lock...INSTRUCTIONS
OPERATING THE EZ-LINK™ SYSTEM The EZ-Link™ system enables the use of these optional AddOns: Cultivator TBGC Edger TBLE Hedge Trimmer TBAH Straight Shaft Trimmer ...
Operation Manual - Page 7
... the tip will cut . Move either in the operating position (Fig. 12).
Fig. 14
7 Each time the head is bumped, about 1 inch (25.4 mm) of trimming line is running. Line release becomes...
• The life of your cutting line is dependent upon proper adherence of the cutting area at high speed.
OPERATING INSTRUCTIONS
HOLDING THE TRIMMER
WARNING: Always wear eye, hearing, foot and...
Operation Manual - Page 8
...be necessary after 10 hours on new engine Every 25 hours Every 25 hours
MAINTENANCE REQUIRED
Fill fuel tank with the second piece of Top View Of The SpeedSpool®
0.095 inch
(2.41 mm...straight into the locking Line Loading Hole
hole (Fig. 17). SPEEDSPOOL® LINE INSTALLATION Always use the correct line length when installing trimming line on the outer spool and inner reel (Fig....
Operation Manual - Page 9
...reel (Fig. 22).
8. Wash the inner reel with existing line from the inner reel before each use a flashlight if needed. To clean the shaft underneath the plunger, press down on the
oil fill...24). Fig. 20
4.
Clean the shaft and the inner surface of the engine.
Clean the area around the dipstick before installing the second piece of the line firmly from the shaft. Oil Fill...
Operation Manual - Page 10
...a container by tipping the unit to dry. 4.
Fig. 29
NOTE: Use the bottle and spout saved from initial use to Federal, State and local regulations.
5. Cleaning the Air Filter Clean and... clean SAE 30 motor oil to spread and remove excess oil (Fig. 34). 6. Allow ample time for complete drainage.
4. Wash the filter in poor performance or can cause permanent damage to prevent injury...
Operation Manual - Page 11
... air flow. Turn the idle speed screw in a clean, dust free area.
1. If the cutting attachment rotates when the engine idles, turn the idle... Air Filter
The condition of the air filter is at a time (as needed ) until the engine idles smoothly. Release the ... engine and let it down. Idle Adjustment Screw
Check Fuel
Old fuel is adjustable.
Pull the starter rope slowly to bring...
Operation Manual - Page 12
...Torx screwdriver (Fig. 38).
2. Set the air
gap at 0.025 in. (0.655 mm.)
using a new gasket. Use a standard automotive .005 in the engine could damage the cylinder.
12 Torque
the screw to ...Do not sand blast, scrape or clean electrodes. Grasp the plug wire firmly and pull the cap from around the spark plug.
Replace the spark plug wire.
Remove the spark plug from ...
Operation Manual - Page 13
...arrestor screen with fuel in the ... of the old gasoline in a dry, well-ventilated area. • Store the unit out of the reach... Drain the gas tank before transporting.
• Tighten gas cap before you clean or service it.
Muffler
Spark Arrestor Screen ...MAINTENANCE AND REPAIR INSTRUCTIONS
SPARK ARRESTOR MAINTENANCE
1.
Do not use gas that contain aromatic oils such as pine and ...
Operation Manual - Page 14
... bound with grass Dirty air filter Plugged spark arrestor
ACTION Turn On/Off control to ON Fill fuel tank with new fuel Press primer bulb fully and slowly 10 times Drain gas tank and add fresh fuel Replace or clean the spark plug Clean or replace spark arrestor
ACTION Replace or clean the air...
Operation Manual - Page 15
... ...Steel Tube (EZ-Link™) Throttle Control ...Finger-Tip Trigger Approximate Unit Weight (No fuel, with handle, cutting attachment and shield 11.5-13.0 lbs (5.2-5.9 kg) Cutting Mechanism ...SpeedSpool&#...on the latest product information available at any time without notice.
15 We reserve the right to make changes at the time of printing. SPECIFICATIONS ENGINE*
Engine Type ...Air-Cooled, ...
Operation Manual - Page 17
...time up / fuel filter, ignition module, spark plug and muffler.
17 Where a warrantable condition exists, Troy-Bilt will not be performed at no charge to the owner at an Authorized Troy-Bilt Service Center. For
the nearest location please contact Troy-Bilt... will repair your small off -road engine. Troy-Bilt must be repaired or replaced by the use of "Repair or Replace as a problem exists...
Operation Manual - Page 18
... from the installation or use of any product shall bind Troy-Bilt. No product returned directly to the factory will , at its option, repair or replace, free of charge, any part found to any resulting damage. Troy-Bilt does not extend any Troy-Bilt product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation...
Operation Manual - Page 53
... 753-05263 791-182519 753-04003 791-180217 753-05297 753-05265
Description O-Ring Air Cleaner Cover Assembly (includes 32) Air Filter Screw Fuel Tank Assembly w/Fuel Lines (includes 35) Fuel Cap Fuel Tank Pads Push Nut Pressure Plate Screw Pressure Plate (includes 38) Spacer Starter Assembly (includes 42) Rope Recoil Spring Handle Rope Guide...
Parts List - Page 2
... 753-05263 791-182519 753-04003 791-180217 753-05297 753-06114
Description O-Ring Air Cleaner Cover Assembly (includes 32) Air Filter Screw Fuel Tank Assembly w/Fuel Lines (includes 35) Fuel Cap Fuel Tank Pads Push Nut Pressure Plate Screw Pressure Plate (includes 38) Spacer Starter Assembly (includes 42) Rope Recoil Spring Handle Rope Guide...
Similar Questions
Troy Bilt 22tb Weed Eater Trouble
Mt Troy-Bilt 2TB Weed Eater has had Bumper and Head replaced 2 times. Both were replaces because Bum...
Mt Troy-Bilt 2TB Weed Eater has had Bumper and Head replaced 2 times. Both were replaces because Bum...
(Posted by denisstpierre1961 1 year ago)
How To Replace Pull Rope On Troybilt Trimmer Tb575es
(Posted by jwclevenger 3 years ago)
Troy-bilt Tb675 Overheating
My Troy-Bilt TB675 overheats after running for a short time. Is this common with these models ?
My Troy-Bilt TB675 overheats after running for a short time. Is this common with these models ?
(Posted by Anonymous-154291 8 years ago)
I Just Replaced The Tank And Primer Bul On My Tb575ec And Cannot Get Fuel Into T
I cannot get fuel into the primer bulb. I replaced the tank and the bulb but still nothing
I cannot get fuel into the primer bulb. I replaced the tank and the bulb but still nothing
(Posted by jcb5797 8 years ago)
Why Is Weed Wacker Smoking When Turn On And It Leaks Oil True Filter Area
(Posted by late4work5 10 years ago)