Home » Troy-Bilt » Lawn & Garden » Troy-Bilt TB6044 XP

Troy-Bilt TB6044 XP Support Question

Find answers below for this question about Troy-Bilt TB6044 XP.
Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!

Troy-Bilt Overview Questions Manuals Reviews Videos Research

Question posted by geistys on August 28th, 2021

Diagram For Correct Fuel Line Connections For Tb6044xp Trimmer

The person who posted this question about this Troy-Bilt product did not include a detailed explanation. Please use the "Request More Information" button to the right if more details would help you to answer this question.

Requests for more information

Request from dchila22 on April 29th, 2022 4:41 AM
The primer bulb has three ports, not two. I never worked on a motor before, but I am trying. I need the fuel line connections.

Thanks

I Know the Answer!

I have the same question
Request More Information

Current Answers

Answer #1: Posted by techyagent on September 12th, 2021 5:26 PM

This answer was accepted by the poster of the original question.

techyagent

Member since:
June 17th, 2014

Points: 4,799,770

1,090
points

Please check this link below:-

https://www.fixya.com/support/t26329607-need_routing_gas_lines_tb6044xp

Hi this is the way it should go: 1 from the filter in the tank to the bottom of the carby,2 from the top of the carby to the inlet on the primer,3 from the outlet on the primer back to the tank as this is the return line nothing goes onto it.

Thanks

Techygirl

Related Troy-Bilt TB6044 XP Manual Pages

Operation Manual - Page 1

... obtain a list of printing. PROOF OF PURCHASE WILL BE REQUIRED FOR WARRANTY SERVICE. Operator's Manual Electric Start Capable 4-Cycle Trimmer TB6044 XP TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20 SAVE THESE INSTRUCTIONS...

Operation Manual - Page 2

...to yourself or to the idle position. Wash hands after handling. Please read these instructions for spilled fuel. Please keep them outside a 50-foot (15 m) radius, at least 30 ft. (9.1 ...smoke. • Never operate the unit without the fuel cap securely in place. • Avoid creating a source of ignition for later use the trimming line described in serious injury to liability or a fine...

Operation Manual - Page 3

... before repairing damage. Wear a face mask or dust mask if the operation is not in contact with fuel in the tank, inside a building where fumes may reach an open flame (pilot lights, etc.) or... parts or accessories could block moving parts. Use of the vibration. Do not extend the trimming line beyond the length of children. • Never douse or squirt the unit with a foreign object...

Operation Manual - Page 4

... manual describes safety and international symbols and pictographs that fuel containing greater than 10% ethanol will likely damage this ...protection when operating this product. You may appear on trimmer attachment shield. To prevent serious injury, do so can... Sharp blade on this unit. Failure to do not touch the line cutting blade. 4 These parts get burned. Keep away from the ...

Operation Manual - Page 5

... with cutting head, cutting head shield and handle 13 - 14 lbs. (5.9 - 6.4 kg) Trimmer Mechanism Bump Head Trimming Line Diameter 0.095 inches (2.41 mm) Cutting Path Diameter 18 in. (45.7 cm) * All ...Lubrication SAE 30 Oil Crankcase Oil Capacity 2.03 oz. (60 ml) Fuel Tank Capacity 12 oz. (355 ml) Approximate Unit Weight (No fuel, with this unit. We reserve the right to make changes at the ...

Operation Manual - Page 7

... using any attachment, read and understand the manual that came with a string trimmer attachment, lock the release button into the primary hole (Fig. 5) and ...sure the release button is securely tightened. Removing the Attachment 1. Knob Fig. 3 Coupler 90˚ Edging Hole (Trimmer Only) Nut Upper Shaft Housing Fig. 4 Release Button Lower Shaft Housing Primary Hole Fig. 5 7 Follow all...

Operation Manual - Page 8

... the cap from the oil bottle. Reinstall the oil fill plug. Change the oil according to the fuel tank. Cut the tip off the funnel spout (Fig. 6). 3. Unscrew the oil fill plug ...O-Ring Oil Fill Hole Fig. 7 8 Oil must be overemphasized. Refer to measure the correct amount of the correct type can cause premature engine wear and failure. NOTE: This unit comes with gasoline. 6....

Operation Manual - Page 9

... the fill hole on the container. Reinstall the fuel cap. 6. Using Fuel Additives Use a fuel additive, such as STA-BIL Fuel Stabilizer or an equivalent, to federal, state and local regulations. Definition of Blended Fuels Today's fuels are often a blend of fuel, according to avoid injury from fuel spray. Alcohol-blended fuel absorbs water. Keep sparks and open flames...

Operation Manual - Page 10

... On/Off switch in the ON ( I ) / Start Throttle Lockout STARTING INSTRUCTIONS 1. Refer to Fueling the Unit. Check the oil level. In cold weather (below 40°F), move the cold weather ...the starting procedure with a controlled and steady motion until the engine comes to idle. 2. If fuel cannot be used during this unit only in a stable position when pulling the starter rope (...

Operation Manual - Page 11

... Engine Starter Bit 49MRBESP966 or 49MRBESY966 Cordless Electric Starter STARTING INSTRUCTIONS 1. Fill the fuel tank. IF COLD... IF... If fuel cannot be seen in the ON ( I ) position at all times (Fig...procedure with step 3. Press and hold the On/Off switch in the OFF (O) position until fuel is above 40°F. 3. In cold weather (below 40°F), move the cold weather start...

Operation Manual - Page 12

OPERATION HOLDING THE TRIMMER WARNING: Always wear eye, hearing, hand, foot and body protection to reduce the risk of trimming line is released. Trimming line can be released from the operator. • Do not trim...14) while operating the unit at a 30° angle to the proper length if any excess line is at high speed. NOTE: Do not rest the cutting head on the ground while the unit ...

Operation Manual - Page 13

... (Fig. 17). NOTE: Maintenance, replacement, or repair of equal length. 5. Refer to align the arrows (Fig. 16). 4. REPLACING THE TRIMMING LINE Only use the correct line length when installing trimming line. Installing New Trimming Line 1. Turn the bump knob clockwise to Maintaining the Air Filter. • Change the oil. MAINTENANCE SCHEDULE Perform these procedures, take...

Operation Manual - Page 14

Remove any old trimming line and/or obstructions. 4. Inspecting the Oil Level Window 1. Stop the engine and allow it to ...add oil. Remove the spool cover (Fig. 18). 3. Reinstall the oil fill plug. Removing Old Trimming Line and Obstructions If necessary, remove any old trimming line and/or obstructions from entering the oil fill hole. 2. NOTE: Failure to prevent debris from the cutting head...

Operation Manual - Page 15

...air filter housing (Fig. 23). Rinse the air filter thoroughly and allow it to measure the correct amount of the old oil according to Checking the Oil Level. Push the air filter cover back...and air filter cover will flow freely and carry away more impurities. 1. oz (60 ml) fill line indicated on the air filter housing. Lightly coat the air filter with clean SAE 30 oil. 5. ...

Operation Manual - Page 16

... the engine will not idle, adjust the idle speed screw as needed ) until snug. Checking the fuel, cleaning the air filter, and adjusting the idle speed should make carburetor adjustments. Tighten the spark plug ... WARNING: The cutting head may spin during idle speed adjustments. If, after checking the fuel and cleaning the air filter, the engine still will not idle • the engine ...

Operation Manual - Page 17

... high quality motor oil into an approved container. Remove the fuel cap, tip the unit and drain the fuel into the cylinder. Reinstall the fuel cap. 2. Allow the engine to Changing the Oil. Household...or damage. • Store the unit in a horizontal position. Change the oil. Do not use fuel that has been stored for more than 30 days. This ensures that contain aromatic oils such as ...

Operation Manual - Page 18

... is dirty The spark plug is fouled Drain the fuel tank and add fresh fuel Clean or replace the air filter Replace the spark plug THE CUTTING HEAD WILL NOT ADVANCE LINE The cutting head is bound with grass The cutting head is out of line The inner reel is bound up The cutting...

Operation Manual - Page 20

...Plugs, Carburetor Adjustments, Filters B. Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw ... fire, water or damage because of any Troy-Bilt Product without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for rental expenses to temporarily replace a warranted product....

Parts Diagram - Page 1

MODEL TB6044 XP 4-CYCLE TRIMMER PPN 41ADZ6PC766 46 47 1 48 49 2 5 37 38 39 27 41 6 3 4 50 42 43 45 44 40 36 35...Intake Port Boot Assembly Carburetor Gasket Insulator Insulator Gasket Washer Screw Aircleaner Assembly Screw Screw Carburetor Assembly O-Ring Aircleaner Spacer Screw Fuel Tank Assembly Fuel Tank Pad Lead Wire Thottle Cable Item 27 28 29 30 31 32 33 34 35 36 37 38 39 40...

Parts Diagram - Page 2

MODEL TB6044 XP 4-CYCLE GAS TRIMMER PPN 41ADZ6PC766 Item Part No. Description 1 753-06887 Throttle Housing Assembly (includes 2 - 5) 2 791-182405 Switch Assembly 3 753-05171 Throttle Lock-out 4 753-05007 Throttle Trigger ...