Troy-Bilt TB6044 XP Support Question
Troy-Bilt TB6044 XP Support Question
Find answers below for this question about Troy-Bilt TB6044 XP.Need a Troy-Bilt TB6044 XP manual? We have 2 online manuals for this item!
Question posted by memeishere on September 19th, 2020
Fuel Lines For Tb6044xp
I think I have fuel lines going to the wrong nipples on the primer bulb. It is a three nipple bulb. Is there a detailed diagram for connecting all the fuel lines?
Current Answers
Answer #1: Posted by INIMITABLE on September 19th, 2020 7:44 AM
INIMITABLE
Member since:
April 3rd, 2020 Points: 2,088,520
Member since:
April 3rd, 2020 Points: 2,088,520
Hello here is a video guide: https://www.youtube.com/watch?v=sfSg0oOT9EM
I hope this is helpful? PLEASE "ACCEPT" and mark it "HELPFUL" to complement my little effort. Hope to bring you more detailed answers
-INIMITABLE
Related Troy-Bilt TB6044 XP Manual Pages
Operation Manual - Page 1
... the unit can be performed by an authorized and approved service dealer. Operator's Manual
Electric Start Capable 4-Cycle Trimmer
TB6044 XP
TABLE OF CONTENTS Service 1 Safety 2 Know Your Unit 5 Specifications 5 Assembly 6 Oil and Fuel 8 Starting and Stopping 10 Operation 12 Maintenance 13 Cleaning and Storage 17 Troubleshooting 18 Warranty 20
SAVE THESE INSTRUCTIONS...
Operation Manual - Page 2
... must be accompanied and guided by themselves eliminate any bystanders. If you to cool before fueling.
• Always add fuel in containers specifically designed and approved for later use . WARNING: Signals a SERIOUS hazard.... with loose or damaged parts.
• Only use metal-reinforced line, wire, chain or rope. Make all adjustments or repairs before starting the engine. Failure to...
Operation Manual - Page 3
...line installed. Stop the unit. 2. Clean the unit after the unit is delayed or when walking from all moving parts.
• Do not touch the engine, gear housing or muffler. Do not wear loose clothing, jewelry, short pants, sandals or go...pants, boots, gloves and a long sleeve shirt. Do not operate the unit with fuel in the tank, inside a building where
fumes may reach an open flame (pilot...
Operation Manual - Page 4
... INTERNATIONAL SYMBOLS •
This operator's manual describes safety and international symbols and pictographs that fuel containing
greater than 10% ethanol will likely damage this unit. Read the operator's manual ...touch the line cutting blade.
4 SYMBOL MEANING
• ON/OFF STOP CONTROL ON / START / RUN
• ON/OFF STOP CONTROL OFF or STOP
• PRIMER BULB Push primer bulb, fully ...
Operation Manual - Page 5
...
Air Filter Cover
Throttle Control
Starter Rope Grip
Primer Bulb
Fuel Cap
Cold Weather Start Lever
Cutting Head
Coupler
Cutting Head Shield
Oil Fill Plug
Line Cutting Blade
SPECIFICATIONS*
Engine Type Air-Cooled, ... shield and handle 13 - 14 lbs. (5.9 - 6.4 kg) Trimmer Mechanism Bump Head Trimming Line Diameter 0.095 inches (2.41 mm) Cutting Path Diameter 18 in . (0.635 mm) Spark Plug...
Operation Manual - Page 7
... (Fig. 3). While firmly holding the attachment, push it straight into the
coupler until the release button snaps firmly into
the primary hole only. Using the wrong hole could lead to personal injury or damage to assembling the attachment.
1. Installing the Attachment
NOTE: Remove the protective cap and gray spacer from the...
Operation Manual - Page 8
...7). Refer to the Maintenance Schedule. Change the oil according to Checking the Oil Level.
Failure to the fuel tank. Unscrew the top of the oil bottle. 2. DO NOT mix oil with a 2.03 fluid ... (Fig. 7). 5.
Oil must be overemphasized. NOTE: This unit comes with gasoline. 6. OIL AND FUEL
USING THE RIGHT OIL
Use a high-quality SAE 30 weight oil of oil. 1. The importance of ...
Operation Manual - Page 9
... spout into the fill hole on the container. Do not smoke while filling the tank. NOTE: Dispose of ignition for spilled fuel.
Add 0.8 oz. (23 ml) of fuel additive per gallon of fuel, according to inhibit corrosion and minimize gum deposits. NOTE: Do not overfill the tank. 4.
Move the unit at a distance from...
Operation Manual - Page 10
... start , begin the starting procedure with step 4. The unit may be seen in the primer bulb, press and release the primer bulb until the unit starts (Fig. 11). the engine does not start lever to turn the unit on. Fill the fuel tank.
Pull the starter rope with step 3. Allow the engine to idle. 2.
begin...
Operation Manual - Page 11
.... The On/Off switch is visible.
4. If fuel cannot be seen in the primer bulb, press and release the primer bulb until fuel is in intervals no need to the Closed position... lever to turn the unit on. Refer to a complete stop (Fig. 8).
11 Slowly press and release the primer bulb 10 times (Fig. 9).
NOTE: The engine is above 40°F.
3. USING THE ELECTRIC START ACCESSORY
This unit...
Operation Manual - Page 12
...contacts the grass without stopping the engine. This may stall the engine. Fig. 15
12
Line release
becomes more line, lightly tap the bump knob on the ground (Fig. 14) while operating the unit... eye, hearing, hand, foot and
body protection to reduce the risk of trimming line is released. Attempting to release line in the operating position (Fig. 13). • Hold the shaft grip with ...
Operation Manual - Page 13
...REQUIRED
• Clean and re-oil the air filter. DO NOT align the arrows when the line winding is too long.
NOTE: The outer spool will remain attached to prevent the unit from ...Fig. 17 If you are of the emission control devices and system may not release properly if the line is complete.
Refer to Changing the Oil. • Have the rocker arm clearance checked by an ...
Operation Manual - Page 14
... the oil fill plug. 3. NOTE: Make sure the O-ring is approximately
halfway up any old trimming line and/or obstructions from entering the oil fill hole. 2. Add oil to keep the engine level may ...
14 Firmly press in place on the cutting head (Fig. 18). 2. Remove any old trimming line and/or obstructions. 4. Check the oil level before each use a flashlight if necessary. If the...
Operation Manual - Page 15
...oil fill hole. Tighten the cover screw to federal, state and local
regulations. 4. Fig. 21
Fill Line
Fig. 22
Hole
Air Filter Housing
Tab
Air Filter Cover
Air Filter
Fig. 23
Cover Screw
15 ...screw completely. Tip the unit vertically to spread and remove excess oil. 6. oz (60 ml) fill line indicated on the back of the oil fill hole and into the hole on the air filter
housing. ...
Operation Manual - Page 16
...all safety instructions to reduce the idle speed (Fig. 24). If, after checking the fuel and cleaning the air filter, the engine still will not idle • the engine ...25
16 Do not over tighten.
6. NOTE: Careless adjustments can seriously damage the unit. Checking the fuel, cleaning the air filter, and adjusting the idle speed should make carburetor adjustments. Tighten the spark ...
Operation Manual - Page 17
... and put 5 drops of any loose or damaged parts. Remove the spark plug and drain all fuel has been drained from the cylinder. 2. NOTE: Do not use strong detergents. CLEANING AND STORAGE
...to federal, state and local regulations.
17 Use a small brush to clean the outside of old fuel according to Changing the Oil. Household cleaners that all of children. If this is not possible, store...
Operation Manual - Page 18
...is in the closed position
SOLUTION
Fill the fuel tank with fresh fuel Press the primer bulb 10 times or until fuel is visible Drain the fuel tank and add fresh fuel Replace the spark plug Move the cold ...head is dirty The line is welded The line is twisted
Not enough line is extended
Stop the engine and clean the cutting head Refill the cutting head with new line Rewind the line Clean the inner ...
Operation Manual - Page 20
... and territories. Damage resulting from the installation or use the product. Bump Knobs, Outer Spools, Cutting Line, Inner Reels, Starter Pulley, Starter Ropes, Drive Belts, Saw Chains, Guide Bars,
Cultivator Tines,... without limitation, expenses incurred for substitute or replacement lawn care services, for transportation or for related expenses, or for loss, damage, or injury to state...
Parts Diagram - Page 1
MODEL TB6044 XP
4-CYCLE TRIMMER
PPN 41ADZ6PC766
46
47
...-06167 746-05053
769-08524 / 01
Description Top Housing Assembly Air Purge Primer Top Cover Gasket Screw Starter Housing Assembly Screw Electric Start Adapter O-Ring Intake... Screw Aircleaner Assembly Screw Screw Carburetor Assembly O-Ring Aircleaner Spacer Screw Fuel Tank Assembly Fuel Tank Pad Lead Wire Thottle Cable
Item 27 28 29 30 31...
Parts Diagram - Page 2
... (includes 20)
20 753-08163 Bump Knob
1
2 3
6
5
7
8
10 9
12
13 14
15 16
11
19 17
20
769-08524 / 01
12
18
08/13 MODEL TB6044 XP
4-CYCLE GAS TRIMMER
PPN 41ADZ6PC766
Item Part No.
Similar Questions
How To Replace Primer Bulb Lines On Tb675ec With A Two Port Primer
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
how do you replace the primer bulb lines on a tb676ec with a two bulb prime
(Posted by dsnyder488 9 months ago)
Where Do The Fuel Lines Go On The Primer Bulb?
(Posted by woodssrjoe74 1 year ago)
My Tb6044xp Primer Bulb Has 3 Nipples, Not Two. I Am Looking For A Fuel Linev D
I am looking for a diagram for the fuel lines. I was given this TB6044XP with no fuel lines. I have ...
I am looking for a diagram for the fuel lines. I was given this TB6044XP with no fuel lines. I have ...
(Posted by dchila22 2 years ago)
Diagram For Correct Fuel Line Connections For Tb6044xp Trimmer
(Posted by geistys 2 years ago)
Fuel Lines
I'm having trouble knowing where to correctly place the 3 fuel lines any help?
I'm having trouble knowing where to correctly place the 3 fuel lines any help?
(Posted by Reynaldoher98 8 years ago)