Icom A210 Support and Manuals

Get Help and Manuals for this Icom item

View All Support Options Below
Free Icom A210 manuals!
Problems with Icom A210?

Ask a Question

Popular Icom A210 Manual Pages

Instruction Manual - Page 2

.../or other countries. Icom, Icom Inc. IBM is easily installed in the IC-A210. the U.S.A. struction manual contains important operating instructions for available GPS receiver details. ❍ 13.8 V/27.5 V DC power source The built-in the local airport frequency as you fly into its own SAVE THIS INSTRUCTION MANUAL - In addition, the auto dimmer function adjusts the display for...
Instruction Manual - Page 4

... 22 I MENU mode items 23 6 INSTALLATION AND REMOVAL 28 I Transceiver installation 28 I Weather memory channel (U.S.A. TABLE OF... 6 I Receiving 6 I Transmitting 6 I Frequency set example 7 I Direct frequency setting mode operation 8 I Dualwatch operation 8 3 MEMORY ...list 16 I Transceiver removal 28 7 CLONING 29 8 SPECIFICATIONS 30 9 OPTIONS 31 10 SAFETY TRAINING INFORMATION 35 iii...
Instruction Manual - Page 5

... [VOL] to enter the direct frequency setting mode (p. 8), and set the emergency frequency (121.5 MHz) (p. 19). to switch the power ON and OFF (p. 5). ➥ Adjusts the audio output level. version only) ...➥ Push and hold for 2 sec. w EMERGENCY CHANNEL SWITCH [EC] ➥ Push to set the squelch test function ON or OFF (p. 20). ➥ Push and hold for 2 sec. to the standby...
Instruction Manual - Page 6

...[RCL] ➥ Push to change the scan direction while scanning u LIGHT-SENSITIVE DETECTOR (p. 21). to adjust "Dimmer brightness (Low/High)" (p. 25) automat- o OUTER (Large) TUNING DIAL [O-DIAL] ➥...display the memory mode menu, and operate selected menu (p. 9). ically when "Dimmer Mode" (p. 25) sets to enter the menu mode (p. 22). to 'AUTO.' 2 to be programmed a displayed frequency to ...
Instruction Manual - Page 10

... the squelch manually. • Refer to pgs. 5-6 in the menu mode, if necessary (p. 24). If the frequency is busy, wait until the standby frequency reappears. • Rotate [VOL] to set the volume level, if necessary. • When receiving a signal, "RX" appears and audio is emitted from the speaker or headset. • Further adjustment of...
Instruction Manual - Page 20

...RFS / UNI / MF / OTH / U-1 / U-2 I Programming channel tag (Group memory channel only) The tag name can be set a 3-character name in addition to p. 26) *1Group memory, *2GPS memory 16 3 MEMORY OPERATION I Channel tag list TAG DISPLAY ... Departure Frequency FSS YES YES Flight Service Station RFS YES YES Remote Flight Service Station UNI YES YES Unicom frequency MF YES...
Instruction Manual - Page 24

...23). to turn the function OFF, repeat step q as a voice-activated intercom. w To turn the squelch test function ON. • "TEST" appears. q Push [VOL] to enable the intercom function. &#...27 for details. 4 OTHER FUNCTIONS I Squelch test function This function opens the squelch manually for testing. w Set Intercom Usable Setting to the MENU mode. • See p.22 for details.
Instruction Manual - Page 29

...(Low) "DISP LOW" Set the lower brightness level in the automatic adjustment range when "AUTO" is OFF. • AUTO : Set the dimmer automatically depending on... automatically adjusts its display brightness by the current lighting conditions. • OFF : The key backlight sets OFF. • 001-049 : Setting low ... : Setting sidetone level from 1 to control which built-in the display ...
Instruction Manual - Page 30

... fast. D Dimmer Response "DISP RESP." r Repeat w-e to select the next input digit. crophone. 26 D USER-1 Setting "U-1 ID SET" Set the USER-1, channel tag, to enter the U-1 ID edit mode. 5 MENU MODE I MENU mode items (Continued) D Dimmer Brightness (Manually) "DISP MAN." q Push [MEM] to the desired ID. t Push [MEM] again to select the desired character...
Instruction Manual - Page 32

...installation rack for 3rd party* products. ¥ Main unit front view Use for pre-existing Icom radio installations Use for pre-existing 3rd party radio* installations *Ask your dealer for details. y Replace...the front panel with the main unit. 6 INSTALLATION AND REMOVAL I Transceiver removal The IC-A210 may easily be removed from the installation rack. • See t of "Transceiver installa...
Instruction Manual - Page 33

Consult the CS-A210 instruction manual and HELP file for details. CLONE WRITE • When clone writing is necessary to cancel the error. 06 07 CLONE NO DATA 29 D Displayed Message • While clone writing. RX MEMORY 127.00 CLONE READ • When turn the power OFF/ON after clone writing error oc- 7 CLONING D Data...
Instruction Manual - Page 36

... (Manually 26 Dimmer mode 25 Dimmer response 26 Direct frequency selection 5 Direct frequency setting mode operation 8 Displayed message 29 Dualwatch interval 24 Dualwatch operation 8 H Headphone level 23 History memory channel 9, 14 I Installation and removal 28 Intercom function 20 Intercom usable setting 27 Intercom1 Microphone audio input level 23 Intercom1 squelch level...
Instruction Manual - Page 39

...or systems. To avoid such interference, turn off the radio in areas where signs are sensitive to do so. This radio is met, the installation of the antenna must be mounted at least 36 ...not exceed 0 dBi. 2. 10 SAFETY TRAINING INFORMATION WARNING Your Icom radio generates RF electromagnetic energy during operation. A proper antenna is transmitting when the "TX indica- tor" appears.
Installation Guide - Page 1

... an aircraft. Reverse polarity will damage the transceiver. See the instruction manual for details. D COMM1 and COMM2 stickers When 2 transceivers are installed, connect pin N to another transceiver's pin 9 each part carefully. COMM1 or COMM2 sticker COMM b USING THE MB-113 When installing the IC-A210/A210E into the mounting bracket. w Unscrew the 5 rear plate screws. e D isconnect...
Installation Guide - Page 2

...A210/A210E can be attached to the airframe. D Polarizing key Before installing... support ...installing with MB-113 . w I nsert the stripped conductor unit the insulation is made. Improper care installing the cable can cause damage and result in severe non-warranty repair... installation...A210/A210E mates with soy ink. Assemble the Molex connector as shown above (illustration: IC-A210...A210/A210E...

Icom A210 Reviews

Do you have an experience with the Icom A210 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Icom yet.

Popular Icom A210 Search Terms

The following terms are frequently used to search for Icom A210 support:

Ask a New Question
Use the box below to post a new question about Icom A210.
Manuals / Documents
Download any of our Icom A210 manuals for free!

We have the following 2 documents available for the Icom A210:
  • Instruction Manual
  • Installation Guide

Points & Prizes
  • You can earn points for nearly everything you do on HelpOwl.com
  • You can trade in those points for gift cards at leading retailers such as Amazon.com and Walmart
  • It's that simple!
See How it Works
Create a Free Account

Icom Manuals

Find free Icom A210 manuals and user guides available at ManualOwl.com. Try out our unique manual viewer allowing you to interact with manuals from directly within your browser!

Icom Reviews

View thousands of Icom A210 user reviews and customer ratings available at ReviewOwl.com.

Contact Information

Complete Icom customer service contact information including steps to reach representatives, hours of operation, customer support links and more from ContactHelp.com.

Scoreboard Ratings

See detailed Icom customer service rankings, employee comments and much more from our sister site.