Icom IC-T70A HD Support and Manuals
Get Help and Manuals for this Icom item
View All Support Options Below
Free Icom IC-T70A HD manuals!
Problems with Icom IC-T70A HD?
Ask a Question
Free Icom IC-T70A HD manuals!
Problems with Icom IC-T70A HD?
Ask a Question
Popular Icom IC-T70A HD Manual Pages
Instruction Manual - Page 1
...: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. WARNING: MODIFICATION OF THIS DEVICE TO RECEIVE CELLULAR RADIOTELEPHONE SERVICE SIGNALS IS PROHIBITED UNDER FCC RULES AND FEDERAL LAW. INSTRUCTION MANUAL
VHF/UHF DUAL BAND FM TRANSCEIVER
iT70A iT70 E
This device complies with...
Instruction Manual - Page 2
... with years of your time to take a moment of trouble-free operation. Many hours or research and development went into the design of your radio of personal injury, fire or electric shock. This
instruction manual contains important operating instructions for making your IC-T70A/T70E your IC-T70A/T70E.
With proper care, this fine Icom product. EXPLICIT DEFINITIONS
WORD R DANGER!
Instruction Manual - Page 4
... to comply with the limits for help. If this equipment does cause harmful interference to radio or television reception, which the receiver is encouraged to try to part 15 of the following measures:
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment and re- ceiver. • Connect the equipment into...
Instruction Manual - Page 5
SUPPLIED ACCESSORIES
The following accessories are registered trademarks of
19
Microsoft Corporation in the United States and/or other countries.
18
Microsoft, Windows and Windows Vista are supplied with the transceiver. q Hand strap 1 w Antenna 1 e Battery pack (BP-264 1 r Belt clip 1 t Battery charger (BC-167SA/SD/SV 1
* Not supplied, or the shape is different, depending on the ...
Instruction Manual - Page 6
... ii-iii FCC INFORMATION iii SUPPLIED ACCESSORIES iv TABLE OF CONTENTS v-vi
1 ACCESSORY ATTACHMENT 1-2 ■ Hand strap 1 ■ Belt clip 1 ■ Battery pack 2 ■ Antenna 2
2 PANEL DESCRIPTION 3-8 ...mode 18 ■ Setting the tuning step 19 ■ Setting the frequency 19 ■ Operating mode selection 21 ■ Key lock function 21 ■ Receiving 22 ■ ...
Instruction Manual - Page 11
... During set mode operation, rotate to select the options. (p. 51)
t PTT SWITCH [PTT] ➥ Push and hold to transmit, release to receive. (p. 23)
For IC-T70E only ...EXTERNAL DC IN JACK [DC IN] ➥ Connects the supplied wall charger, BC-167S, to send the
DTMF code. (pp. 66, 67)
9
• [0]-[9] send "0"-"9," [A](SET) sends "A," [B](BAND) sends "B,"
10
[C](H/M/L) sends "C," ...
Instruction Manual - Page 19
...
Prior to the DC power supply, the battery pack may have problem. D Battery icons
While charging..., the icons show " ," " " and " (disappears)" in sequence, and "CHARGE" appears when the transceiver's power is completely charged.
In this case, contact your Icom...antenna used.
12 Transceiver
• BC-167S
to AC outlet
3
The shape may receive...
Instruction Manual - Page 26
... tuning steps are available for both band.
e R otate [DIAL] to select the tuning step set the tuning step.
[DIAL]
• 144 MHz band
Push [BAND] • 440 MHz ...See the previous topic to set item, then ro-
w P ush [BAND] to select the desired frequency band. 4 BASIC OPERATION
■ Setting the tuning step
The tuning step can be selected for the IC-T70A/T70E.
• 5.0 kHz...
Instruction Manual - Page 36
... saved to a bank. quency or DTCS code with a frequency offset
(p. 26) •... 21) • Duplex direction (+DUP or -DUP) with polarity (p. 53) • Scan skip setting (p. 46) • Memory bank (p. 32) • Memory name (p. 34) • Tuning step...be erased by malfunction and during repairs. 6 MEMORY/CALL CHANNELS
■ General description
The IC-T70A/T70E has 300 memory channels,...
Instruction Manual - Page 39
6 MEMORY/CALL CHANNELS
■ Memory bank setting
The IC-T70A/T70E has a total of 26 banks (A to enter the select memory write mode. • 1 ... 1 sec. w Rotate [DIAL] to the previous indication before entering the select
19
memory write mode. 32 e P ush [SET] to select the "bAnk" item.
• The bank group and channel number are assigned to toggle the bank group selection and ...
Instruction Manual - Page 73
...](BAND) transmits a 1750 Hz tone burst signal.
However, while continuing to the frequency display. w R otate [DIAL] to select the DTMF TX key item.
[DIAL] [VOL]
D Manual DTMF code transmission
2
First, set the DTMF TX key to "kEy" in the Set mode.
3
➥ While continuing to push [PTT], push the desired keys to 4
transmit a DTMF...
Instruction Manual - Page 78
...-written automatically when it is not over-written in a received signal. to stop the scan.
• If the scan is decoded, the set mode contents are not changed .
By monitoring a signal that... for a tone frequency or DTCS code. r W hen the tone frequency or DTCS code is cancelled before the transceiver detects the tone or code, the set mode contents are programmed with the scanning...
Instruction Manual - Page 81
...to clone/edit contents with a PC (for 1 sec. OTHER FUNCTIONS 10
■ Cloning function
The IC-T70A/T70E has transceiver-to RS-232C
14
(RS-232C type) port
15
PC
16
17
18
19
74...optional OPC-474 cloning cable is useful when you want to copy all of the programmed contents from one IC-T70A/T70E to "CLOnE
4
m."
q T urn the transceiver's power OFF, then connect an optional OPC-474...
Instruction Manual - Page 83
... is set.
p. 58
10
Contacting with another • Different tone or code is...
grammed.
11 TROUBLESHOOTING
If your transceiver seems to be set. • ...set mode.
channels.
p. 18
13
weather channel mode is selected.
14
A program scan does not • The memory mode, Call channel mode, or • Push [V/M/C] repeatedly to a service center.
1
PROBLEM...
Instruction Manual - Page 84
.... impedance
: 2.2 kW
D Receiver
• Receive system
: Double-conversion superheterodyne
•...dB
All stated specifications are subject to +140°F)
• Power supply : 10.0-16.0 V DC for external DC power,
or specified Icom battery pack
... a 16 W load
External speaker More than 400 mW with antenna and BP-264)
77
D Transmitter
• Modulation system
: Variable reactance ...
Icom IC-T70A HD Reviews
We have not received any reviews for Icom yet.