NaceCare TGB2228 COMING SOON Support and Manuals
Get Help and Manuals for this NaceCare item
View All Support Options Below
Free NaceCare TGB2228 COMING SOON manuals!
Problems with NaceCare TGB2228 COMING SOON?
Ask a Question
Free NaceCare TGB2228 COMING SOON manuals!
Problems with NaceCare TGB2228 COMING SOON?
Ask a Question
Popular NaceCare TGB2228 COMING SOON Manual Pages
Owners Instructions - Page 1
Read instructions before using the machine www.numatic.co.uk TGB 2228/8572
BATTERY SCRUBBER DRYER
Owner Instructions
Warning!
Owners Instructions - Page 2
... Panel Overview Page 4
Machine Set up Guide Page 5
Fitting the Brush / Pad Page 6
Adjusting Deck Pitch Page 6
Fitting the Floor Tool Page 6
Fitting the Hose Guide Page 7
Filling the Clean Water...Page 14
Specifications
Page 15
Trouble Shooting
Page 15
Rating Label / Personal Protective Equipment /Recycling Page 16
Safety Precautions Page 17-18
Recommended Spare Parts Page ...
Owners Instructions - Page 5
...THE FIRST FUSE YOU MAY NOTICE A SPARK, THIS IS NORMAL.
! When the machine is removed and in start-up Guide
!
Fit battery fuses (contained in a safe position, turn key back to the position (0) 'OFF'
Note: During...OF ALL THE PACKAGING, CAREFULLY OPEN AND CHECK THE CONTENTS.
! Machine Set-up pack) into the battery fuse holders as illustrated. (Fig. 1, 2, 3.)
Insert Key into ignition located on...
Owners Instructions - Page 6
...apply left , turn the knob counterclockwise to apply right hand bias to the left. Machine Set-up Guide
! Note: Safety gloves are recommended for cleaning operation using the detent pin.
The brush ...side while cleaning forwards, this can be compensated for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature if the floor tool gets snagged, whilst in the ...
Owners Instructions - Page 7
Machine Set-up Guide
Fitting the Hose Guide
The vacuum hose has a U-bend clip which creates a U-bend in the raised position. If you need to the rear of the machine in the centre ...
Owners Instructions - Page 8
... scale on the rear of the machine.
The clean water bottom tank holds 85 litres. Machine Set-up Guide
Fill Level Indicator
The water level in auto scrubber-dryers.
!
!
IMPORTANT Do not operate machine unless the Operator Manual has been read and fully understood.
! NOTE: always ensure that chemical manufacturer's safety guidelines are...
Owners Instructions - Page 9
... 01460 68600
9 NOTE: Do not drive the machine backwards with an electronic braking system.
Set desired traction speed as required, depending on floor type
and level of the machine.
Move ...will be disabled. The machine will stop.
B
(Fig.A) The traction status light will illuminate. A
Set the flow rate (Fig.C). The TGB 8572 is equipped with the floor tool in the lowered position...
Owners Instructions - Page 10
Allowing it to safely disengage from its holder. First loosen the retaining knobs on an obstruction, during forward machine movement. Machine In Use
To operate, set water flow rate, lower brush deck, lower the floor tool, press the vacuum switch, pull brush On/Off trigger.
Clean only while descending (driving down ...
Owners Instructions - Page 14
... you reach your final destination / before using the machine..
! Note: Drive functions on Third Phase (Constant Voltage Mode) Charge Complete.
Swing to move the machine manually if required.
T 01460 68600
14 The motor brake will be in a discharged state.
Free Wheel Function
1
2
The machine is located on the right side of...
Owners Instructions - Page 15
... high load Handle safety fuse blown
Trouble Shooting
SOLUTION
Fit or replace fuse (page 5) Charge batteries (page...problem or in the event of a breakdown contact your Numatic dealer or Numatic Technical helpline +44 (0)1460 269268
T 01460 68600
15 Replace fuse & reduce load (page 5) Replace fuse (or contact service engineer)
Failure to best suit the floor type (page 10). Specifications
Model...
Owners Instructions - Page 16
... Floor Sign
Safety Critical Component:
Charging Leads: H05VV-F x 1.0 mm2 x 3 Core Battery Charger: 220V / 240V (50-60Hz) DC Output: 24VDC, 20A Ref page 19 for component part numbers
In the event of scrubber-dryer into national law. About the Machine
Rating Label
1
Company Name & Address
1
11
2
Machine Description
3
Voltage Frequency
2
4
Power rating...
Owners Instructions - Page 17
... the instruction manual before further use. • Only replace the power cord with the correct Numatic approved replacement parts.
• Ensure that the work area is clear of obstructions and / or people.
• Ensure that routine and preventative maintenance is not suitable for the specific task being performed. WARNING
When ordering spare parts always quote the Model Number...
Owners Instructions - Page 18
...Care
1. Leaving the charger to be disposed of 4 hours after use genuine Numatic replacement batteries. 11. Daily Keep the machine clean. Flush out system with circuit disconnect switch...any worn or damaged parts and replace immediately. This can be disconnected from the mains supply. 6. Do not steam clean or pressure wash. ORIGINAL INSTRUCTIONS READ MANUAL BEFORE USE
Information for...
Owners Instructions - Page 19
... (2 required)
SQUEEGEE Squeegee Knob Squeegee Castor Wheel Squeegee Castor Assembly Set Squeegee 750 Blade Set Complete 750 Squeegee Assembly
FILTERS Clean Water Filter Filter Basket Filter Basket Lid Foam Filter Body Foam Filter Float Switch Attachment
Spare Parts
Part No. 900903 903341 902468 Part No. 206953 204116 220386 221047 230104 221091 903066 903683 204115
HOSES...
Owners Instructions - Page 24
....numatic.pt
This Product has been comprehensively inspected and checked during every stage of its manufacture, including an in-depth electrical safety and functionality test. Specification subject to change without prior notice www.numatic.co.uk © Numatic International Limited
905442 06/17 (A01) Sihlbruggstrasse 142, 6340 Baar. SCHWEIZ Tel: 0041...
NaceCare TGB2228 COMING SOON Reviews
We have not received any reviews for NaceCare yet.