Nady ENC-I Support and Manuals
Popular Nady ENC-I Manual Pages
Manual - Page 2
... unit. CONTENTS
CONTENTS ...2 INTRODUCTION 2 USING THIS MANUAL 2 SYSTEM FEATURES 3 ENC-I RECEIVER 4 WHT HANDHELD MICROPHONE TRANSMITTER 7 WLT LAVALIER/LAPEL OR HEADWORN MICROPHONE BODYPACK TRANSMITTER 9 WGT INSTRUMENT BODYPACK TRANSMITTER 11 SPECIFICATIONS 13 SERVICE INFORMATION 14 WARRANTY 15
INTRODUCTION
Thank you for choosing the Nady Enc-I wireless microphone system, we know you...
Manual - Page 3
... WLT BODYPACK TRANSMITTERS • Choice of -sight
• Noise-free transmitter ON-OFF operation
ENC-I RECEIVER • Half-rack receiver design with retractable front panel antenna • RF and ...by‑side) optional rack mounting
WHT HANDHELD MIC TRANSMITTER • Features the Nady DM-10D unidirectional neodymium dynamic cartridge for
optimum true sound, maximum feedback rejection and ...
Manual - Page 4
...Single mounting: Remove the receiver SIDE MOUNT CLIP (1) from both Encore receivers, join the two receivers with the EJC-2 JOINING CLIP (...display extinguishes, the transmitter is sometimes called) may need to be set fully counterclockwise to re‑establish the radio link.
4 this could degrade the performance of the Enc-I RECEIVER
1. However, in a rack directly above an amplifier or...
Manual - Page 5
...instrument cord connection. If the volume controls are set at the factory and are preset at a ...the Audio Output The Enc-I receiver provides both of the mixer is set too high, you...on the input of the XLR OUTPUT JACKS on the Encore I receiver clockwise to about 3/4 rotation, until the ...provide 4dB gain over a cord. 5. This setting is comfortable for the Instrument Connection (above), ...
Manual - Page 7
... is screwed on the mic element at all input signals. Make sure the cover is the possibility of the above Enc-I receiver instructions. It is recommended that the battery should now be replaced with a fresh one. A fresh alkaline battery can easily be destroyed by sliding the OFF/STANDBY/ON SWITCH (20) to the...
Manual - Page 9
...antenna, and rolling up to the ON position and adjust the volume of the above Enc-I receiver instructions. Slip the transmitter into a pocket or clip on to the side of the front...LED DISPLAY (5) on and off during use . Occasional flickering on the Enc-I receiver should be avoided. The BATTERY INDICATOR LED (28) will be replaced with a 3.5 mm LOCKING JACK (24) for all of the mouth...
Manual - Page 11
... supplied INSTRUMENT CORD (35) has a factory installed capacitor inside the 1/4" plug. The BATTERY INDICATOR... unplug, reverse the process. Set for the maximum possible gain ...Enc-I receiver should be sure to extend it on the plug clockwise to the instrument also serves as the antenna, be replaced... (transmitter and audio both on the Enc-I receiver instructions. In the case of the RF...
Manual - Page 13
... mic, with phantom power (WLT);
typical (depending on site conditions); SPECIFICATIONS
ENC-I RECEIVER Controls Connectors
LED Indicators Dimensions (Max.) Weight Power Requirements
Antenna
...battery) • WHT • WLT/WGT
Nady DM-10D neodymium dynamic cartridge 3.5mm mono locking jack for purposes of -sight
ENC-I OVERALL SYSTEM PERFORMANCE
Frequency Response Dynamic Range
2152...
Manual - Page 14
... card) per instructions by the Nady Service Department. If your system, please refer to : Nady Systems, Service Department, 6701 Shellmound Street, Emeryville, CA 94608. Include a brief description of a unit under warranty, please follow the instructions in your unit prepaid to the Support page at (510) 652-2411 to service this product. For service of the problem you are experiencing...
Manual - Page 15
... service not performed by Nady's service department. items damaged in material or workmanship for repair or replacement. Make sure the R/A number is required, please contact our Service Department at (510) 652-2411 for repair. Nady ... cases/housings or parts; If any Nady serial number has been removed or defaced.
This warranty gives you specific legal rights and you .
Manual - Page 16
Nady Wireless Systems are type accepted under FCC rules parts 90, 74 and 15. The device complies with RSS-210 of Industry & Science Canada. Operation is subject to the following two conditions: (1) this device ... any interference received, including interference that may cause undesired operation.
6701 Shellmound Street | Emeryville, CA USA 94608 T 510.652.2411 | F 510.652.5075 | www.nady.com
Nady ENC-I Reviews
Do you have an experience with the Nady ENC-I that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Nady yet.
Earn 750 points for your review!