SanDisk SDCFX-016G-P61 - 16GB Extreme UDMA 60MB/s Compact Flash Card Support and Manuals
Get Help and Manuals for this SanDisk item
This item is in your list!
View All Support Options Below
Free SanDisk SDCFX-016G-P61 manuals!
Problems with SanDisk SDCFX-016G-P61?
Ask a Question
Free SanDisk SDCFX-016G-P61 manuals!
Problems with SanDisk SDCFX-016G-P61?
Ask a Question
Popular SanDisk SDCFX-016G-P61 Manual Pages
Product Manual - Page 28
...
CE Setup Time CE Setup Time CE Recover Time VCC Rising Timeb VCC Falling Timeb Reset Width
Symbol Vi (CE)
TSU (VCC) TSU (RESET) TREC (VCC)
tpr tpf TW (RESET) Th (Hi-z Reset) TS (Hi-z Reset)
Condition 0V Interface Description
SanDisk CompactFlash Card OEM Product Manual
3.3.3
Power Up/Power Down Timing
The timing specification in...
Product Manual - Page 35
....0, 02/07 SanDisk CompactFlash Card OEM Product Manual
Interface Description
Table 3-14 contains the specification information related to the asserted condi tion. In Figure 3-7, all signals originating at the connector of the selected device.
All timing values and diagrams are shown and measured at the host. The minimum cycle time supported by devices...
Product Manual - Page 46
...set 1. Note that the address space of this word register overlaps the address space of the equivalent word access. Registers at offset 8, 9 and D are not supported...
0
0
0
0
1
1
Error Registerb
Featuresb
0
0
0
1
0
2
Sector Count
Sector Count
0
0
0
1
1
3
Sector No. ATA Register Set and Protocol
SanDisk CompactFlash Card OEM Product Manual
a. This register may also be ...
Product Manual - Page 47
SanDisk CompactFlash Card OEM Product Manual
ATA Register Set and Protocol
4.3
Memory Mapped Addressing
When CompactFlash Memory Card registers are not supported...be accessed by a pair of the Error and Feature byte-wide registers that hosts...memory block move instruction.
Repeated word accesses to the data register is the odd byte of the registers at off set 1. Byte accesses...
Product Manual - Page 49
... about the source of a general error.
4.5.3
Feature Register (Address-1F1[171]; This register is in case of an error when an error is detected.
SanDisk CompactFlash Card OEM Product Manual
ATA Register Set and Protocol
Table 4-6 Data Register
Data Register Error/Feature Register Error/Feature Register
CE2- CE1- D6
UNC
Set when an uncorrectable error is specified.
Product Manual - Page 51
... the Auxiliary Status Register does not.
The bits
in some type of performing card operations.
Offset Eh)
This register is capable of error. SanDisk CompactFlash Card OEM Product Manual
ATA Register Set and Protocol
4.5.9
Status & Alternate Status Registers (Address-1F7[177]&3F6[376]; No other bits in this register are defined as follows:
D7...
Product Manual - Page 53
...either of I /O locations 3F7 and 377. Do not install a Floppy and a CompactFlash Memory Card in the Drive...problem for the PCMCIA implementation:
1. D6
-WTG
This bit is 0 when a write operation is in the card that can be accomplished by a Floppy Disk Controller operating at the same addresses as the CompactFlash Memory Card.
SanDisk CompactFlash Card OEM Product Manual
ATA Register Set...
Product Manual - Page 56
... Register
CY Cylinder Registers
DH Card/Drive/Head Register
LBA Logical Block Address Mode Supported
Y
The register contains a valid parameter for this command.
YYYY
Y
F5h
-...-
ATA Command Description
SanDisk CompactFlash Card OEM Product Manual
Table 5-1 Primary and Secondary I/O Decoding
Class 1 1 1 1 1 1 2 2 2 3 3 2 2 2
Command Set Multiple Mode Set Sleep Mode Stand By...
Product Manual - Page 59
... field in Table 5-8.
SanDisk CompactFlash Card OEM Product Manual
ATA Command Description
5.1.5
Identify Device-ECH
The Identify Drive command enables the host to receive parameter information from a CompactFlash Memory Card. of Sectors on Read/Write Long Commands Firmware revision in ASCII (Rev M.ms) set by code Big Endian Byte Order in Word Model number in ASCII...
Product Manual - Page 64
... are not indicated. ATA Command Description
SanDisk CompactFlash Card OEM Product Manual
Word 68: Minimum PIO Transfer Cycle Time With Flow Control.
Obsolete
12
1
Write Buffer command supported by CF Card
13
1
Read Buffer command supported by CF Card
14
1
NOP command supported by the host as meaning that features/command sets enabled are reserved. Bits 1 through 13...
Product Manual - Page 65
... Buffer command supported by CF Card
13
1
Read Buffer command supported by CF Card
14
1
NOP command supported by host implementers. The older modes are reported in these words should not be set not supported by Set Features command
4
0
Removable Media Status feature set to one and bit 15 of word 87 are valid. SanDisk CompactFlash Card OEM Product Manual
ATA...
Product Manual - Page 70
...error.
02/07, Rev. 12.0
5-16
© 2007 SanDisk Corporation The transfer begins at the beginning of requested sectors is still set at the sector where the error occurred. The flawed data is rejected with an Aborted Command error... sectors. ATA Command Description
SanDisk CompactFlash Card OEM Product Manual
5.1.11
Read Multiple-C4H
The Read Multiple command performs similarly to ...
Product Manual - Page 73
SanDisk CompactFlash Card OEM Product Manual
ATA Command Description
Table 5-24 defines the valid extended error codes for the CompactFlash Memory Card Series product. Table 5-24 Extended Error Codes
Extended Error Code 00h 01h 09h 20h 21h 2Fh
35h, 36h 11h 18h
05h, 30-34h, 37h, 3Eh 10h, 14h 3Ah 1Fh
0Ch, 38h, 3Bh, 3Ch, 3Fh 03h
...
Product Manual - Page 74
... no impact on the CF Memory Card Accepted for backward compatibility with the SDP Series but has no impact on the CF Memory Card 4 bytes of defaults at Soft Reset. ATA Command Description
SanDisk CompactFlash Card OEM Product Manual
5.1.18 Set Features-EFH
This command is issued, all features that are not part of the ATA Specification.
Product Manual - Page 106
... be tested to the product's functional and performance specifications. SanDisk reserves the right to repair or replace, at 866-436-6073 with prior authorization from state to state.
02/07, Rev. 12.0
B-2
© 2007 SanDisk Corporation Limited Warranty
SanDisk CompactFlash Card OEM Product Manual
All failing products returned to SanDisk under the provisions of this limited warranty shall...
SanDisk SDCFX-016G-P61 Reviews
Do you have an experience with the SanDisk SDCFX-016G-P61 that you would like to share?
Earn 750 points for your review!
We have not received any reviews for SanDisk yet.
Earn 750 points for your review!