Whirlpool WUI95X15H Support and Manuals
Get Help and Manuals for this Whirlpool item
View All Support Options Below
Free Whirlpool WUI95X15H manuals!
Problems with Whirlpool WUI95X15H?
Ask a Question
Free Whirlpool WUI95X15H manuals!
Problems with Whirlpool WUI95X15H?
Ask a Question
Popular Whirlpool WUI95X15H Manual Pages
Owners Manual - Page 1
... risk of the part code mentioned herein will rinse itself before operating.
SAVE THESE INSTRUCTIONS
State of injury, and tell you to move and install ice maker. Under normal operating conditions, the ice maker will tell you first start your ice maker, the water pan will fill and the system will Wbe1a1u2t5o6m9a1ti2cAally replaced by the...
Owners Manual - Page 4
...part code mentioned herein will both clean and rinse itself.
8. Condenser fins 5. Read and follow all parts...Part Number W10355010
In U.S.A., order Part Number W10355016
In Canada, order Part Number W10355010B
In Canada, order Part Number W10355016B
11-Jun-2018 15:29:29 EDT | RELEASED
In some European 4factories the letter "W" of the front panel support...will be automatically replaced by the ...
Owners Manual - Page 5
... . Replace the fuse or reset the circuit breaker. Otherwise, bin thermostat may not restart once it is level. Ice Maker Operation
WARNING
PROBLEM Ice Maker Will Not Operate
Ice Maker Seems Noisy
Electrical Shock Hazard
Plug into a grounded 3 prong outlet. TROUBLESHOOTING
Visit www.whirlpool.com/product_help for the drain pump to follow these instructions...
Owners Manual - Page 6
...some European 6factories the letter "W" of the part code mentioned herein will be blocking the airflow ...°C) will melt and form clumps. PROBLEM Ice Maker Runs But Produces No Ice
... ice in place and that all parts and panels before servicing.
If the drain cap is mineral... properly installed. Check that there are clumps of installation. If there are no ice.
Replace all ...
Owners Manual - Page 7
... "400012345678") PERFORMANCE DATA SHEET
Ice Maker Water Filtration System
Model P6GEG2KL, P6KG2KL, P6WG2KL Capacity 2000 Gallons (7571 Liters)
System tested and certified by the number "4000" (e.g. Flow = 0.50 gpm (1.89 Lpm). Style 1 -
Failure to 22°C).
NOTE: Service technicians cannot repair plumbing problems outside of the substances listed below. Call a licensed...
Owners Manual - Page 8
...29 EDT | RELEASED
1
In some European 8factories the letter "W" of the part code mentioned herein will pay for factory specified replacement parts
household electrical or plumbing (e.g., house wiring, fuses, or water
and repair labor to correct improper product maintenance or installation, installation
Whirlpool Corporation or Whirlpool Canada LP (hereafter
not in materials or workmanship...
Installation Instructions - Page 1
We have provided many important safety messages in this manual and on some models 5 Drain Connection 8 Door Reversal-Side Swing Only 9 Leveling 11 Cleaning 11
SÉCURITÉ DE LA MACHINE À GLAÇONS 13 INSTRUCTIONS D'INSTALLATION.......... 14
Déballage de la machine à glaçons........ 14 Exigences d'emplacement 14 Spécifications...
Installation Instructions - Page 2
...models) is not intended for use by persons (including children) with your fingers. Wipe with a flammable propellant in on the stainless steel surfaces of the ice maker.
and catering and similar non-retail applications.
Do not store explosive substances such as shown. SAVE THESE INSTRUCTIONS
INSTALLATION INSTRUCTIONS... replacement parts... replaced by the manufacturer, its service ...
Installation Instructions - Page 3
...34" (86.4 cm) Min. 34½" (87.6 cm) Max. Failure to follow these instructions can adjust the height of the leveling legs. B Width of the power supply may be provided. ... the floor is connected to avoid problems with the National Electrical Code and local codes and ordinances. If needed, you have a properly grounded, 3 prong wall receptacle installed by a qualified electrician.
3 &#...
Installation Instructions - Page 5
...the wall for service. Inlet water... on some models)
NOTES:
...codes and ordinances.
■ It may be sure the copper tubing does not touch the cabinet's side wall or other parts inside the cabinet.
8. Bend the copper tubing to meet the water line inlet which is not installed, please proceed to ice maker bin and drain pump reservoir inlet) (3)
■ Rear panel (2)
■ Instruction...
Installation Instructions - Page 8
... Sleeve kit, Part Number W10365792, is adequate, follow these guidelines when installing drain lines. Plug... pipe system to the floor with a gravity drain system, follow these instructions can result in back or other injury.
22 1/8"
C
(56.2... with all state and local codes and ordinances. See "Gravity... installation has a standpipe with or without the 3/4" (1.91 cm) panel on some models)...
Installation Instructions - Page 9
... the required tools and parts before starting installation.
■ 5/16"...and Care Guide. Place the...Set the door aside.
9 Replace all parts and panels before servicing. Beginning top corner end cap
C
C. Failure to the door.
8. Remove the screw and end cap at corner A, and tighten screw.
6. A
B
A
A.
Remove the door from the door
and pull up and outward on your model...
Installation Instructions - Page 10
...opposite side of the ice maker cabinet. Phillips-head countersink screw C. Place the hinge on some models)
1. Replace the handle and handle screws. Hinge pin sleeve
E.
Hinge pin sleeve
D. Remove the top hinge ... door with the top hinge hole and replace the top
hinge pin. 3. Install the two hex-head screws into the bottom of the door and set aside.
2. Remove the screws from the...
Installation Instructions - Page 11
...required tools and parts before starting installation. ■ ...Failure to follow these instructions can result in order to remove. Depending upon where you install the ice maker,...will empty from the cutter grid cover. 5.
Replace the drain cap securely on the opposite side... death, fire, or electrical shock.
4. NOTE: On some models)
A
A. Unplug the wiring harness from the cutter grid....
Installation Instructions - Page 12
...models, remove the holder by replacing the screws.
Then clean the same parts with a solution of 1 tbs (15 mL) of the unit. Do not wash plastic parts...instructions.
■ Replace the ice scoop holder by replacing the mounting screw.
13. Hook up and out. NOTE: On some models, pushing in on other models... are set the water pan inside the ice bin. Water pan B. Remove, clean and replace the ...
Whirlpool WUI95X15H Reviews
We have not received any reviews for Whirlpool yet.