LiftMaster HS670 Support and Manuals
Get Help and Manuals for this LiftMaster item
View All Support Options Below
Free LiftMaster HS670 manuals!
Problems with LiftMaster HS670?
Ask a Question
Free LiftMaster HS670 manuals!
Problems with LiftMaster HS670?
Ask a Question
LiftMaster HS670 Videos
MOTOR PUERTA INDUSTRIAL LIFTMASTER HS670 www.syserm.com.mx
Duration: :22
Total Views: 88
Duration: :22
Total Views: 88
Popular LiftMaster HS670 Manual Pages
HS670 GL BOARD Manual - Page 1
GLCONTROLLER BOARD
MODEL HS670
HEAVY DUTY HYDRAULIC SLIDE GATE OPERATOR
2 YEAR WARRANTY
Serial located on electrical box cover) Installation Date
MODEL HS670 IS FOR VEHICULAR PASSAGE GATES ONLY AND IS NOT INTENDED FOR PEDESTRIAN PASSAGE GATE USE
HS670 GL BOARD Manual - Page 2
... Entrapment Protection 15 Control Board Illustration 16 Program Settings (DIP Switch 17-18 Programming the Radio Receiver 19
Before beginning your installation check that all safety instructions.
• DO NOT attempt repair or service of damage to your gate and/or the gate
Operator Notes 35
AVERTISSEMENT Repair Parts and Service 36
ATTENTION operator if you do not comply with the...
HS670 GL BOARD Manual - Page 3
...
Drive wheels are 24 VDC. HS670 1HP = 1-1/2" wide, 6" ...gate. D. Set at side of NEMA 3, 4, and 13 construction. for operation is 3 position, 4 way. G. When positioned downward, it will allow manual operation of 12 cubic inches per revolution. LIMIT SWITCH
All limit switches are T.E.F.C. (totally enclosed, fan cooled) and operate at 3450 R.P.M.
OPERATOR SPECIFICATIONS
OPERATOR...
HS670 GL BOARD Manual - Page 4
...
14" 26-1/2"
4 Maximum Gate Weight - 5000 lbs. MODEL HS670 GI • 1 HP Motor Gate Speed - 18"/sec. MODEL HS670 GI • 2 HP Motor Gate Speed - 18"/sec. OPERATOR SPECIFICATIONS
OPERATOR DIMENSIONS AND HORSEPOWER CHART
MODEL HS670 GC • 1 HP Motor
Gate Speed - 12"/sec. Maximum V-Track Gate Width - 80 ft. Maximum V-Track Gate Width - 80 ft. Maximum Gate Weight - 3000 lbs.
HS670 GL BOARD Manual - Page 5
... or other building servicing the general public. SAFETY ACCESSORY SELECTION
All UL325 compliant LiftMaster gate operators will accept external entrapment protection devices to warn pedestrians of the dangers of the gate within the operator. This system must sense and initiate the reverse of motorized gate systems.
Model HS670 meets the following specifications:
Moving Gate Can Cause Injury...
HS670 GL BOARD Manual - Page 8
... and Photo Beams Anytime They Are
Adjusted or Serviced
Gate Edge
Pinch-Point Hazard
Gate Edge for
AVERTISSEMENT Gate Edge for Close Direction
OR
Close Photo Beam
OR
Unit Open Photo Beam
WARNING SIGN PLACEMENT
ADWVEARRTNEINNGCIA
To prevent SERIOUS INJURY or DEATH from the gate. This entrance is operating. Non-contact sensors such as photo eyes...
HS670 GL BOARD Manual - Page 11
...set; If more force to get the gate started .
MANUAL OPERATION
NOTE: When manually opening or closing the gate, it is required, adjust both wheels to "float" so they can not interfere with LiftMaster Drive Rail)
Upper Drive Wheel
Drive Rail
Guide... handle down (manual operation), the gate can follow any slight misalignment of the drive rail, locate and install the (2) "gate stops" to...
HS670 GL BOARD Manual - Page 15
...gate to pause the gate during the close , if enabled, will have no effect. On most operators this input when the gate is closing will be disabled until another command is closing gate... ENTRAPMENT PROTECTION ADJUSTMENTS
Force Control
Set the force control pot such that the unit will stop and alarm. Once the input is detected (gate edge or RPM sensor), gate will complete a full cycle ...
HS670 GL BOARD Manual - Page 17
... be set to the off position. SL = Slide, 1 second delay SW = Swing, 1.5 second delay
TTC
SW
RT
SWING GATE S1
ON ON
1 2 34
SAVE
TTC
SW
RT
SLIDE GATE S1
ON ON
1 2 34
SAVE
LT
SL
LT
SL
RIGHT/LEFT OPERATION This switch (S1-3) selects the gate opening direction, to the left or to optimize gate behavior for specific...
HS670 GL BOARD Manual - Page 23
... DVERTENCIA X
NOTES:
1. moving. Never use separate entrance. KEEP GATES PROPERLY MAINTAINED. Have a qualified service person make
NO ONE SHOULD CROSS THE PATH OF THE MOVING
repairs to be performed by a LiftMaster
SEMENT
AVERTISSEMENT Failure to the operator it is within ten percent of the operators rating.
23
The gate MUST reverse
use grease or silicone spray.
5. ALL...
HS670 GL BOARD Manual - Page 25
...operator by consulting the wiring specifications section on /off switch. OPERATOR RUNS SLOW AND/OR TRIPS THE INTERNAL OVERLOAD
1) Low primary (high voltage) power
2) Problem in the motor 3) Problem in a dual gate...LEDs are correct replace the transformer.
➤ Stand-alone Operators: Make sure there is a jumper installed across TB11 and TB12.
➤ Master/Second Operation: Make sure that...
HS670 GL BOARD Manual - Page 26
..., repair the gate.
➤ Observe the drive wheels as they move . OPERATOR OPENS
1) Active or malfunctioning accessory
IMMEDIATELY UPON
check the red input status LEDs,
POWER UP AND DOES NOT D11-D13
CLOSE
OPERATOR HAS TROUBLE 1) Operator's manual release is engaged LEARNING THE MOTOR
PROGRAMMING CHANGES 1) Check the save switch on . Apply power and retest the operator. An installed...
HS670 GL BOARD Manual - Page 28
... around six inches.
Both models have a 4 way, 3 position, dual solenoid activated directional valve.
Test Station Connect Point R.V. x 6" dia.) HS670 2HP (2" w. M1
T.F. The HS670-100 is 37 RPM and gate speed of 12 in3/rev.
2. It operates on each is suggested that a ruler be used like a dip stick. TROUBLESHOOTING
HYDRAULIC SYSTEM INFORMATION
FLUID
1. Single...
HS670 GL BOARD Manual - Page 34
... by this product. THIS LIMITED WARRANTY ALSO DOES NOT COVER ANY PROBLEMS CAUSED BY INTERFERENCE. WARRANTY POLICY
LIFTMASTER® TWO YEAR LIMITED WARRANTY
The Chamberlain Group, Inc. You will be advised of shipping instructions when you . Products returned to our service center for warranty repair. Some States do not allow limitations on your compliance with any...
HS670 GL BOARD Manual - Page 36
REPAIR PARTS AND SERVICE
HOW TO ORDER REPAIR PARTS
OUR LARGE SERVICE ORGANIZATION SPANS AMERICA For installation and service information, call our TOLL FREE number: 1-800-528-2806 www.liftmaster.com When ordering repair parts please supply the following information:
PART NUMBER DESCRIPTION MODEL NUMBER ADDRESS ORDER TO:
THE CHAMBERLAIN GROUP, INC. All Rights Reserved Technical Support Group ...
LiftMaster HS670 Reviews
We have not received any reviews for LiftMaster yet.