Hayward Stratum Vacuum Release Support and Manuals
Get Help and Manuals for this Hayward item
View All Support Options Below
Free Hayward Stratum Vacuum Release manuals!
Problems with Hayward Stratum Vacuum Release?
Ask a Question
Free Hayward Stratum Vacuum Release manuals!
Problems with Hayward Stratum Vacuum Release?
Ask a Question
Popular Hayward Stratum Vacuum Release Manual Pages
Model: All Models - Owners Manual - Page 2
... metal parts of swimming pool, spa, or hot tub, and to electric supply. WARNING - There is constructed so that it cannot be in an entrapment. If installed within 5 ft. (1.5 m) of inside walls of 16
STRATUM™ Model VR1000
P/N: ISVR1000 Rev: M
IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOW ALL INSTRUCTIONS IN THIS OWNER'S MANUAL AND ON EQUIPMENT. The National Electrical Code...
Model: All Models - Owners Manual - Page 3
...lost, order replacement parts from the suction outlets
can result in an increase potential for suction entrapment as described above . This vacuum release system is damaged...codes applicable. To reduce the risk of 16
STRATUM™ Model VR1000
P/N: ISVR1000 Rev: M
WARNING - Pool and spa water circulation systems operate under hazardous pressure during pump start up . Before servicing...
Model: All Models - Owners Manual - Page 4
... manual carefully and completely. Automatic soft start should be in pressure and electrical power. WARNING - Failure to install and/or
operate according to defined instructions and/or use of the Hayward VR1000 Vacuum Release System.
C27.2 No. 218.1.
CAUTION - which can be followed precisely.
The instructions in most instances. FIG 1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS...
Model: All Models - Owners Manual - Page 6
...the exterior/bottom of 16
STRATUM™ Model VR1000
P/N: ISVR1000 Rev: M
CUSTOMER SCREENS ON VR1000
HAYWARD POOL PRODUCTS
02-02-07 12:00 P.M.
No Action Required No Action Required
SET TIME AND DATE?
Action Required: Reset "STOP Switch"
Sensor/Solenoid Venting Error.
The pump may cycle and restart. USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville...
Model: All Models - Owners Manual - Page 9
... normal pool monitoring. When this time a High Vacuum setting provides protection. The system is still in entering the Vacuum Anomaly Detected state. Three occurrences of a second. The audible alarm(s) may also reduce equipment damage due to help reduce the risk of certain types of 16
STRATUM™ Model VR1000
P/N: ISVR1000 Rev: M
OPERATIONS
Normal operational mode monitors...
Model: All Models - Owners Manual - Page 12
...ATTENTION - Install a Ground Fault Circuit Interrupter (GFCI) in suction and outlet pipes. 3. See Pump Owners Manual For Troubleshooting Guide. Have a professional perform this test:
1. Turn on end of 16
STRATUM™ Model VR1000
P/N: ISVR1000 Rev: M
Wiring
WARNING -
See filter owner's manual. ATTENTION - See filter owner's
manual for GFCI, see manufacturer's instructions. The...
Model: All Models - Owners Manual - Page 14
... warranty apply. To obtain warranty replacements or repair, defective components or parts should be responsible for a period of ONE (1) year from the date of this equipment, Hayward Pool Products, 620 Division Street, Elizabeth, New Jersey, warrants its vacuum release systems to the nearest authorized Hayward service center.
Hayward shall not be returned, transportation...
Model: All Models - Service/Installation - Page 1
...alert symbol.
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Pomona, CA Clemmons, NC Nashville, TN Tel: 908.351.5400 www.haywardpool.com All electrical wiring MUST be alert to follow all instructions in conformance with all applicable local codes, regulations, and the National Electrical Code (NEC).
PN: ISVR1000TECH Rev: J
_____
MODEL VR1000 SERVICE MANUAL
INSTALLATION & PARTS
WARNING - To...
Model: All Models - Service/Installation - Page 2
...- Pump MUST be in an entrapment. Suction Entrapment Hazard.
This vacuum release system is intended for outdoor use of the body or limbs can result in injury or death. Risk of 24
STRATUM™ Model VR1000
P/N: ISVR1000TECH Rev: J
READ AND FOLLOW ALL INSTRUCTIONS IN THIS SERVICE AND INSTALLATION MANUAL AND ON EQUIPMENT. Failure to bond pump to the electrician...
Model: All Models - Service/Installation - Page 3
...:
o When suction outlets are less than 40 PSI. floor or wall), must be installed a minimum of two functioning ASME112.19.8 suction outlets per current revision of 24
STRATUM™ Model VR1000
P/N: ISVR1000TECH Rev: J
WARNING - o Dual suction fittings shall not be set in violent
separation of burns. o Never use the Pool or Spa if any suction...
Model: All Models - Service/Installation - Page 4
... lasts
30 minutes, providing NO protection for the proper installation and operation of ASTM Specification F2387-04.
NOTICE -The STRATUM™ is designed as certified to Can/CSA Std. which can be installed and serviced only by holding "NO" & "OK" buttons. The VR1000 meets the requirements of the Hayward VR1000 Vacuum Release System. Meets ASME Standard 112.19.17. DO...
Model: All Models - Service/Installation - Page 6
...Hayward Technical Service.)
5. A lug for bonding is down and toward the board. Power should NEVER be done unless directed to connect the booster pump through this "FACTORY SET" position unless a low voltage error...CONNECTION INSTRUCTIONS:...STRATUM™ Model VR1000
P/N: ISVR1000TECH Rev: J
INITIAL REQUIRED SETTINGS: 1. Thus if a "Manual" override is suitable for Canada) wire. Replace...
Model: All Models - Service/Installation - Page 9
...VR1000 has been set to restart the system. Y/N
SELECT POOL TECH. Action Required: Reset "STOP Switch"
VR1000 VER X.X S/S VENT ERROR
Sensor/Solenoid Venting Error.
VR1000 UNDER WINDOW VACUUM
Under Vacuum Window indicates a problem...set , the battery may need to be replaced.) "YES" follow screen instructions
SET TIMER EVENTS Y/N
SET TIMER EVENTS is required that the "Custom Install ...
Model: All Models - Service/Installation - Page 13
... to five (5) minutes.
STOP PUMP before starting motor. See filter
owner's manual for Troubleshooting Guide. WARNING -
Failure to do so may take up to suction pipe level....24
STRATUM™ Model VR1000
P/N: ISVR1000TECH Rev: J
Start-Up & Operation
Prior to pool/spa system directly in severe personal injury. Remove any trapped air in suction and outlet pipes. 3.
RELEASE ALL...
Model: All Models - Service/Installation - Page 22
... difference between expected high value and low vacuum value. Page 22 of 24
STRATUM™ Model VR1000
P/N: ISVR1000TECH Rev: J
ET = 38
ET = 39 ET = 40 ET = 41 ET = 42
ET = 50 ET = 51 ET = 52 ET = 53 ET = 54
ET = 55 . parm set to 99, the expected high vacuume value was less than the low vac...
Hayward Stratum Vacuum Release Reviews
We have not received any reviews for Hayward yet.