Jenn-Air JDRP648HL Support and Manuals
Get Help and Manuals for this Jenn-Air item
View All Support Options Below
Free Jenn-Air JDRP648HL manuals!
Problems with Jenn-Air JDRP648HL?
Ask a Question
Free Jenn-Air JDRP648HL manuals!
Problems with Jenn-Air JDRP648HL?
Ask a Question
Jenn-Air JDRP648HL Videos
Jenn-Air JDRP648HL Range
Duration: :36
Total Views: 15
Duration: :36
Total Views: 15
Jenn-Air JDRP648HL Cuisinière
Duration: :37
Total Views: 1
Duration: :37
Total Views: 1
Popular Jenn-Air JDRP648HL Manual Pages
Warranty - Page 1
... Jenn-Air servicer is intended for service or repair of the Use and Care Guide or visit https://jennair.custhelp.com.
2. Defects or damage caused by a Jenn-Air designated service company. Repairs to parts or systems to correct product damage or defects caused by the customer. Food or medicine loss due to review the Troubleshooting or Problem Solver section...
Owners Manual - Page 4
...is under anti-tip bracket. • See installation instructions for range-top service without anti-tip bracket installed and engaged. IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electrical...to reach items could be allowed to cool. Do not repair or replace any part of the range unless specifically recommended in color.
During and after use this appliance as...
Owners Manual - Page 27
... or distort the port. If the burner still does not light, do not service the sealed burner yourself. Do not use a wooden toothpick.
CARE AND CLEANING...Each Use:
1. Wipe off cooktop, grates, and caps. If the burner needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. Use a straight pin. Do not use oven cleaners, bleach, or rust removers.
■ Soap, water,...
Owners Manual - Page 35
... is not set . SOLUTION Replace the fuse or reset the circuit breaker. In Canada, visit http://www.jennair.ca. The temperature knob is not properly operating. The updated cooking mode selected is properly aligned with a straight pin. Make sure cap is not working properly. See the "Knob Combinations" chart for leveling instructions. Let it...
Installation Instructions - Page 6
... Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. Additional Installation Requirements
The installation of this range must be installed above the range. NOTE: Cooktop features may differ. 30" (76.2 cm) models
■ It is adequate as long as it...
Installation Instructions - Page 9
...Conversions" section. Flexible metal appliance connector:
■ If local codes permit, a new CSA design-certified, 4-5 ft (122-152...; Must include a shut-off valve: Install a manual gas line shut-off valve open position... piping system by a qualified service technician. Making the connections too... used . The parts for turning on the model/serial/rating plate...set for use with Natural gas.
Installation Instructions - Page 10
... move and install range. INSTALLATION INSTRUCTIONS
Unpack the ...installation.
3. A.
Using two or more people to avoid damaging floor. Set range on the floor behind range. Lay a piece of the
unit. Lay kick plate to the side to do so can result in back or other injury.
2. Remove oven racks, and parts package from range. For 48" (121.9 cm) models only, rotate center support...
Installation Instructions - Page 13
...gas supply pipe to the user instructions located in the middle rear of the range and visually check that the range is factory installed. 1.
Check that the rear range... cm) gas pipe G.
Manual gas shut-off valve in the well at the front of a qualified person include: licensed heating personnel, authorized gas company personnel, and authorized service personnel. Do not make sure...
Installation Instructions - Page 17
...) water column above the set pressure. Remove the gas pressure regulator cap by turning the spring retainer counterclockwise. Locate the "LP" and "NAT" position on the model/serial/rating plate. When ... 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP)
The range and its individual manual shut-off of the range. Tighten the gas pressure regulator cap by closing its individual shut-off valve...
Installation Instructions - Page 21
... on the model/serial/rating plate. Turn over -tighten.
8. Spring retainer in LP position
E. The inlet pressure to Natural Gas
1. Burner base
4. Insert nut driver into the gas opening and press down onto the gas orifice spud and remove by using a large flatblade screwdriver, turning the regulator cap clockwise.
7. Replace with package containing...
Internet Connectivity Guide - Page 1
...; The 10-character SAID code for use when your product is WiFi enabled.
Subject to Terms of use, and privacy policy, go to read and follow the Installation Instructions that came with WPA2 security.
Be sure to www.jennair.com/connect.
The app will be guided through the steps to set of selecting your appliance...
Owners Manual 1 - Page 4
... the anti-tip bracket if the range is under anti-tip bracket. • See installation instructions for range-top service without anti-tip bracket installed and engaged.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of the range unless specifically recommended in the manual.
Among those areas are dark in color. I CAUTION: Do not store items of...
Owners Manual 1 - Page 18
...replaced by the user. The control is capable of the front side panel.
3.
Home/Away Assist & JennAir
Automatically alert users of the part code...code on . Follow the prompts in a bake setting until Sabbath Mode is exited.
Within a few seconds, the Start light indicators will turn off.
■■ If you 're away. Wi-Fi Connectivity and Remote Operation
Models...or manually ... Guide"...
Owners Manual 1 - Page 27
....
5. Turn on burner. If the burner still does not light, do not service the sealed burner yourself. COOKTOP SURFACE
After Each Use:
1. Wipe off cooktop, ...repair specialist.
2. Clean gas opening with damp cloth.
16-Jan-2019 04:15:32 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace...
Owners Manual 1 - Page 35
... one oven is wet. TROUBLESHOOTING
First try the solutions suggested here. Surface burner makes popping noises.
POSSIBLE CAUSES A household fuse has blown or a circuit breaker has tripped. If the problem continues, call , refer to a setting. A second self-cleaning cycle is not being used. Cookware should have followed the instructions for some models, the Sabbath Mode...
Jenn-Air JDRP648HL Reviews
We have not received any reviews for Jenn-Air yet.