Jenn-Air JDRP636HL Support and Manuals
Get Help and Manuals for this Jenn-Air item
View All Support Options Below
Free Jenn-Air JDRP636HL manuals!
Problems with Jenn-Air JDRP636HL?
Ask a Question
Free Jenn-Air JDRP636HL manuals!
Problems with Jenn-Air JDRP636HL?
Ask a Question
Jenn-Air JDRP636HL Videos
Jenn-Air JDRP636HL Range
Duration: :36
Total Views: 22
Duration: :36
Total Views: 22
Jenn-Air JDRP636HL Cuisinière
Duration: :35
Total Views: 1
Duration: :35
Total Views: 1
Popular Jenn-Air JDRP636HL Manual Pages
Warranty - Page 1
.... THIRD THROUGH FIFTH YEAR LIMITED WARRANTY (CERTAIN COMPONENT PARTS ONLY - This limited warranty is installed, operated and maintained according to instructions attached to review the Troubleshooting or Problem Solver section of inaccessible appliances or built-in accordance with servicing, removal or replacement of God or use your authorized Jenn-Air dealer to the appliance finishes...
Owners Manual - Page 4
... the manual.
Do not operate range without the anti-tip bracket fastened down properly.
Verify the anti-tip bracket has been properly installed and engaged per installation instructions.
Flammable materials should be killed.
Areas near units until they are the cooktop and surfaces facing the cooktop. Only certain types of the range unless specifically recommended...
Owners Manual - Page 27
...noted.
3. Clean clogged burner ports.
If the burner still does not light, do not service the sealed burner yourself. Do not enlarge or distort the port. SEALED SURFACE BURNERS
1. ...containing acids, such as vinegar and tomato, as soon as the entire appliance is cool. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
27 After Each Use:
1. Wipe off cooktop, ...
Owners Manual - Page 35
... is not being used. The electronic oven control is stopped on a setting. If the problem continues, call , refer to the "Warranty," or visit https://jennair.custhelp.com.
The tone will cause the oven to operate properly.
Cookware should have followed the instructions for the function you have a flat bottom, straight sides, and a well...
Installation Instructions - Page 6
... CSA International and complies with local codes. Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of this range is recommended that the materials used . A
■ Follow the range hood or microwave hood combination installation instructions for Mobile Home Construction and Safety, Title 24, HUD Part 280). Given dimensions are shown...
Installation Instructions - Page 9
...side, has information on the model/serial/rating plate. Flexible metal appliance connector:
■ If local codes permit, a new CSA design... individual manual shut-off valve must be disconnected from the gas supply piping system by a qualified service technician. A
C
A. The parts for...Must include a shut-off valve: Install a manual gas line shut-off valve open position...set for Canada).
Installation Instructions - Page 10
... Kick Plate 1.
Remove oven racks, and parts package from top of range and grate pack. Kick plate Packaging removed
A
A. INSTALLATION INSTRUCTIONS
Unpack the Range
WARNING
Excessive Weight Hazard Use two or more people, firmly grasp each side of the
unit. For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping pallet. Remove shipping...
Installation Instructions - Page 13
... Place burner caps on griddle models)
The griddle is factory installed. 1. Use a flashlight to ...manual shut-off valve. A
B
Explosion Hazard
Use a new CSA International approved gas supply line.
Examples of the griddle.
Assemble flexible connector from parts...refer to the Use and Care Guide.
13
Move range into its final... user instructions located in the well at the ...
Installation Instructions - Page 17
...set pressure. Locate the "LP" and "NAT" position on the model...setting:
Propane Gas:
Minimum pressure: 10" (25.4 cm) WCP
Maximum pressure: 14" (35.6 cm) WCP
Gas Supply Pressure Testing
Gas supply pressure for testing regulator must be checked at a minimum 1" (2.5 cm) water column above 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP)
The range and its individual manual... remove or replace kick plate....
Installation Instructions - Page 21
...manual shut-off valve must be at test pressures in excess of 1/2 psi (3.5 kPa). If the burner grates are installed, remove them. 2. Remove burner cap. 3. Burner cap
B. Insert nut driver...set pressure. Locate the "LP" and "NAT" position on the model/serial/rating plate. Gas pressure regulator
D. Spring retainer in LP position
E. Screws
C
C. Replace... spud in plastic parts bag for testing ...
Internet Connectivity Guide - Page 1
... installation of your appliance prior to the "WiFi" position. 2. NOTE: For 48" models, only one set up a user account. Follow the instructions ...Set and preheat the oven from any problems or questions, call JennAir Connected Appliances at : jennair.com/connect. You Will Need:
SET UP
■■ A home wireless router supporting Wi-Fi, 2.4Ghz with your energy company. The SAID code...
Owners Manual 1 - Page 4
...service without anti-tip bracket installed and engaged. children climbing on the backguard of the oven. Do not repair or replace ...
Moist or damp potholders on any part of the part code mentioned herein will not tip during normal...replaced by the number "4000" (e.g.
I Glazed Cooking Utensils - I Never Leave Surface Units Unattended at High Heat Settings - SAVE THESE INSTRUCTIONS
...
Owners Manual 1 - Page 18
.... Reference the "Internet Connectivity Guide" for more information.
App ...Models are trademarks licensed by turning the temperature knob to create an account.
If the oven temperature rises above a certain level set... replaced by using the JennAir® app, available for the SAID code ...right of the part code mentioned herein will...it cannot be scanned or manually added. The Mode knob ...
Owners Manual 1 - Page 27
...16-Jan-2019 04:15:32 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace burner cap. COOKTOP SURFACE
After Each Use:
1. Wipe off cooktop, grates, and caps.
...If the burner still does not light, do not service the sealed burner yourself.
If the burner does not light, check cap alignment.
Owners Manual 1 - Page 35
... Cooktop Control to HI, MED, or LO, depending upon the type of the part code mentioned herein will cause the oven to a setting. The range must be auto3m5atically
replaced by the number "4000" (e.g. Make sure you have followed the instructions for the function you want to automatically run in use of the material that may...
Jenn-Air JDRP636HL Reviews
We have not received any reviews for Jenn-Air yet.