Jenn-Air JDRP848HL Support and Manuals
Get Help and Manuals for this Jenn-Air item
View All Support Options Below
Free Jenn-Air JDRP848HL manuals!
Problems with Jenn-Air JDRP848HL?
Ask a Question
Free Jenn-Air JDRP848HL manuals!
Problems with Jenn-Air JDRP848HL?
Ask a Question
Jenn-Air JDRP848HL Videos
Jenn-Air JDRP848HL Range
Duration: :36
Total Views: 5
Duration: :36
Total Views: 5
Jenn-Air JDRP848HL Cuisinière
Duration: :35
Total Views: 3
Duration: :35
Total Views: 3
Popular Jenn-Air JDRP848HL Manual Pages
Warranty - Page 1
... unless such damage results from natural gas or propane gas.
7.
Please take a few minutes to review the Troubleshooting or Problem Solver section of non-genuine Jenn-Air parts or accessories.
6. and Canada, direct all requests for service or repair of this limitation may not apply to you . house wiring, fuses or water inlet hoses).
4. Travel...
Installation Instructions - Page 6
...check that are minimum clearances.
A
■ Follow the range hood or microwave hood combination installation instructions for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes.
When such standard is not applicable, use the Standard for dimensional clearances above the range. Model/serial/rating plate location/SAID label
(located on the right-hand side...
Installation Instructions - Page 9
...Install a manual...9632; If local codes permit, a new...model/serial/rating plate. For elevations above the manifold pressure shown on the model/serial/rating plate are for Canada). Type of Gas
Natural Gas: This range is factory set...parts for use TEFLON®† tape. A smaller size pipe on the types of gas that can be disconnected from the gas supply piping system by a qualified service...
Installation Instructions - Page 10
...pallet under range. Remove Kick Plate 1. Set range on cardboard to do so can result in back or other injury.
2. Kick plate b. Remove oven racks, and parts package from range. A. Remove shipping ...range is not needed for installation.
3.
Remove kick plate from packaging on top of the
unit. For 48" (121.9 cm) models only, rotate center support counterclockwise off shipping pallet. Lay...
Installation Instructions - Page 17
... as follows for operation and checking the regulator setting:
Propane Gas:
Minimum pressure: 10" (25... at least 1" (2.5 cm) water column pressure above the set pressure. Line pressure testing at 1/2 psi (3.5 kPa) gauge...35.6 cm] WCP)
The range and its individual manual shut-off valve during any pressure testing of the ...order to remove or replace kick plate. Kick plate slot
2. A
NAT
LP
B
NAT
...
Installation Instructions - Page 21
... changing it.
Set gas orifice spud aside.
5. 5. A
LP
NAT
B C
LP
D
LP
NAT
LP
NAT
E
NAT
A. Spring retainer in excess of a 1/4" (7 mm) nut driver to serial tag for future use and keep with correct Natural gas orifice spud. main Large burner - Replace with package containing literature.
7. Burner base
4. The inlet pressure to the regulator...
Internet Connectivity Guide - Page 1
... to Terms of Service available at 1-800-JENNAIR (536-6247). Internet Connectivity Guide Guide de connexion Internet
Get the App and Get Connected
There are unsure of your router's capablilities, refer to the router manufacturer's instructions.
■■ The router to connect your appliance. Press the START button. Be sure to set of knobs needs...
Owners Manual 1 - Page 4
... injured. I DO NOT TOUCH SURFACE UNITS OR AREAS NEAR UNITS - I Storage in use a towel or other servicing should be allowed to
heat or warm the room.
Do not repair or replace any part of the range unless specifically recommended in the
oven bottom or cover an entire rack with materials such as a space heater to...
Owners Manual 1 - Page 18
...guide and walk you 're away.
Reference the "Internet Connectivity Guide" for more information.
Wi-Fi Connectivity and Remote Operation
Models... replaced ...manually added. The SAID can detect when you are disabled or deactivated.
■■ The Sabbath Mode sets...set , the oven will turn the oven off . Using Sabbath Bake Mode:
■■ Monitor progress of the part code...
Owners Manual 1 - Page 27
... burner still does not light, do not service the sealed burner yourself. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
16-Jan-2019 04:15:32 EST | RELEASED
In some European factories the letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace burner cap. Do not enlarge or...
Owners Manual 1 - Page 35
... you have been converted improperly. See the Installation Instructions for disabling.
Make sure you want to perform.
Allow more than 12 hours between self-cleaning cycles.
Surface burner flames are clogged.
If the problem continues, call , refer to -heavy cookware made of the surface burner and contact a service technician.
Make sure cap is shut...
Owners Manual - Page 4
... reach items could be worn while using the range, follow these instructions can tip the range and be hot even though they have had sufficient time to children in or on Grease Fires -
I User Servicing - I Wear Proper Apparel - Do not repair or replace any part of the range.
During and after use this appliance as...
Owners Manual - Page 18
...sets the oven to be scanned or manually added. NOTE: Before utilizing Sabbath Mode after successfully connecting to turn off .
Reference the "Internet Connectivity Guide...code on the lower right of the appliance from the app such as: ■■ Access the oven from any mobile device ■■ Set... Wi-Fi Connectivity and Remote Operation
Models are provided with a Wi-Fi ...
Owners Manual - Page 27
...appliance is cool. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
27 If the burner still does not light, do not service the sealed burner yourself. Do ...a soft cloth or sponge are cool.
If the burner needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. After Each Use:
1. Wipe off cooktop, grates, and caps. CARE AND CLEANING
...
Owners Manual - Page 35
... some models, the Sabbath Mode is properly aligned with a straight pin. SOLUTION Replace the fuse or reset the circuit breaker. Push in knob before turning to the proper heat level. Clean clogged burner ports with the burner. Make sure cap is set correctly. Contact a trained repair specialist. See the "Knob Combinations" chart for leveling instructions...
Jenn-Air JDRP848HL Reviews
We have not received any reviews for Jenn-Air yet.