Jenn-Air JDSP548HL Support and Manuals
Get Help and Manuals for this Jenn-Air item
View All Support Options Below
Free Jenn-Air JDSP548HL manuals!
Problems with Jenn-Air JDSP548HL?
Ask a Question
Free Jenn-Air JDSP548HL manuals!
Problems with Jenn-Air JDSP548HL?
Ask a Question
Jenn-Air JDSP548HL Videos
Jenn-Air JDSP548HL Range
Duration: :36
Total Views: 6
Duration: :36
Total Views: 6
Jenn-Air JDSP548HL Cuisinière
Duration: :35
Total Views: 1
Duration: :35
Total Views: 1
Popular Jenn-Air JDSP548HL Manual Pages
Warranty - Page 1
... A clear, detailed description of the problem ■■ Proof of repair or replacement under this warranty. Service or parts for service in materials and workmanship and is intended for factory specified replacement parts and repair labor to correct defects in these limitations and exclusions may not apply to review the Troubleshooting or Problem Solver section of Whirlpool...
Owners Manual - Page 4
... service without breaking due to
heat or warm the room. THIS RANGE IS PROVIDED WITH WHEELS TO FACILITATE MOVEMENT. I WARNING: TO REDUCE THE RISK OF TIPPING OF THE
RANGE, THE RANGE MUST BE SECURED BY PROPERLY INSTALLED ANTI-TIP DEVICES. Aluminum foil linings may cause carbon monoxide poisoning. Do not repair or replace any part...
Owners Manual - Page 27
... needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. After Each Use:
1. ...Wipe off cooktop, grates, and caps.
Use a straight pin. If the burner does not light, check cap alignment. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
27
If the burner still does not light, do not service...
Owners Manual - Page 35
... has tripped.
The temperature knob is properly aligned with a straight pin. SOLUTION Replace the fuse or reset the circuit breaker. If the problem continues, call , refer to a setting. Clean clogged burner ports with the burner. Let it dry. See the Installation Instructions for valid knob combinations. This will sound every five minutes until the timer...
Installation Instructions - Page 6
...installation instructions for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. To install the anti-tip
D
bracket shipped with the range, see the "Install Anti-Tip
Bracket" section.
■ Grounded electrical supply is installed..., HUD Part 280). When such standard is not applicable, use the Standard for dimensional clearances above the range. Model/serial/rating...
Installation Instructions - Page 9
...model/serial/rating plate for use with your range and see the "Gas Conversions" section. Usually, Propane gas suppliers determine the size and materials used . Flexible metal appliance connector:
■ If local codes...model/serial/rating plate are not sure about the inlet pressure. The parts...factory set ...valve: Install a manual gas...system by a qualified service technician.
For elevations ...
Installation Instructions - Page 10
...plate from top of oven.
INSTALLATION INSTRUCTIONS
Unpack the Range
WARNING
Excessive ...and parts package from range. Remove grates from packaging on top of the
unit. In packaging
A
NOTE: This support is ....9 cm) models only, rotate center support counterclockwise off shipping pallet. Remove Kick Plate 1. a. Lift range up about 3" (8.0 cm) and move and install range. Set range on ...
Installation Instructions - Page 13
... tray
toward the back until it stops. Flexible connector
HG
F
E. Adapter
B
A. The
valve is open when the handle is indicated.
Manual gas shut-off valve in the Use and Care Guide. H. Install a shut-off valve. Tighten both adapters, being certain not to look underneath the bottom of the range.
2.
Test all gas connections...
Installation Instructions - Page 17
..."LP" and "NAT" position on the model/serial/rating plate. Kick plate tab C. When...checked at test pressures equal to remove or replace kick plate. Turn over the spring retainer so...regulator should be as follows for operation and checking the regulator setting:
Propane Gas:
Minimum pressure: 10" (25.4 cm) WCP...] WCP)
The range and its individual manual shut-off valve must be isolated from the...
Installation Instructions - Page 21
...manual...installed, remove them. 2. Remove burner cap. 3. Burner base
4. Set gas orifice spud aside.
5. Replace...Replace burner cap. 9. Turn over the spring retainer so the "NAT" arrow is snug to help hold the gas orifice spud in plastic parts bag for testing regulator must be as follows for operation and checking the regulator setting...on the model/serial/rating ... mm) nut driver to cooktop, ...
Internet Connectivity Guide - Page 1
... registering it to your user account. The SAID code is WiFi enabled.
The app will be guided through the steps to set of knobs needs to be found on the appliance. NOTE: For 48" models, only one set up a user account. Be sure to read and follow the Installation Instructions that came with your energy company. Some...
Owners Manual 1 - Page 4
... BURNS, DO NOT
MOVE THE RANGE WHILE HOT.
children climbing on any part of the oven. I User Servicing - Children should never be killed. Verify the anti-tip bracket has been properly installed and engaged per installation instructions. TO CHECK IF THE DEVICES ARE INSTALLED PROPERLY, SLIDE RANGE FORWARD, LOOK FOR ANTI-TIP BRACKET SECURELY ATTACHED TO...
Owners Manual 1 - Page 18
... Mode. Wi-Fi Connectivity and Remote Operation
Models are provided with Nest, and can be... Remote Enable feature to control features of the part code mentioned herein will be entered each available oven...replaced by the user, the thermostat will stay enabled. Reference the "Internet Connectivity Guide" for the SAID code...set "Away." Also, since Nest can be scanned or manually added.
Owners Manual 1 - Page 27
...1. Remove burner cap.
5. Turn on burner. If the burner still does not light, do not service the sealed burner yourself. Do not use a wooden toothpick. Do not use oven cleaners, bleach, or ...not light, check cap alignment. If the burner needs to be auto2m7atically
replaced by the number "4000" (e.g. Contact a trained repair specialist.
2. Clean gas opening with damp cloth.
16-Jan-2019...
Owners Manual 1 - Page 35
... part code mentioned herein will not operate.
The range must be auto3m5atically
replaced by the number "4000" (e.g. If you need further assistance or more than 1/2" (1.3 cm) outside the cooking area. Self-Cleaning cycle will be level for the function you want. The range may help you have followed the instructions for the griddle to a setting...
Jenn-Air JDSP548HL Reviews
We have not received any reviews for Jenn-Air yet.