Jenn-Air JDSP548H Support and Manuals
Get Help and Manuals for this Jenn-Air item
This item is in your list!
View All Support Options Below
Free Jenn-Air JDSP548H manuals!
Problems with Jenn-Air JDSP548H?
Ask a Question
Free Jenn-Air JDSP548H manuals!
Problems with Jenn-Air JDSP548H?
Ask a Question
Popular Jenn-Air JDSP548H Manual Pages
Warranty - Page 1
... remote locations where an authorized Jenn-Air servicer is provided exclusively by unauthorized service, alteration or modification of the Use and Care Guide or visit https://jennair.custhelp.com.
2. light bulbs, batteries, air or water filters, preservation solutions, etc.).
5. Repairs to parts or systems to review the Troubleshooting or Problem Solver section of the appliance.
9. Please...
Owners Manual - Page 4
... AREAS NEAR UNITS - Only certain types of the range unless specifically recommended in color.
Children should never be stored in use this appliance as aluminum foil. Verify the anti-tip bracket has been properly installed and engaged per installation instructions. Failure to a qualified technician. I User Servicing -
I WARNING: TO REDUCE THE RISK OF BURNS, DO NOT...
Owners Manual - Page 27
...a soft cloth or sponge are cool. If the burner still does not light, do not service the sealed burner yourself. Do not enlarge or distort the port.
Use a straight pin....off cooktop, grates, and caps. If the burner needs to be adjusted, contact a trained repair specialist.
4. Replace burner cap. CARE AND CLEANING
COOKTOP SURFACE
IMPORTANT:
■ Before cleaning, make sure all ...
Owners Manual - Page 35
... See the Installation Instructions for the function you need further assistance or more than 1/2" (1.3 cm) outside the cooking area. See Sabbath Mode section for disabling. TROUBLESHOOTING
First try ...been made of the surface burner and contact a service technician. A Delay Start has been set correctly. The start . The updated cooking mode selected is not the proper size.
Push...
Installation Instructions - Page 6
... and Safety Standard, Title 24 CFR, Part 3280 (formerly the Federal Standard for Manufactured Home Installations, ANSI A225.1/NFPA 501A or local codes. Use an insulated pad or 1/4" (6.4... with local codes. Model/serial/rating plate location/SAID label
(located on the model/serial/rating plate.
To install the anti-tip
D
bracket shipped with installation clearances specified on...
Installation Instructions - Page 9
...service technician. IMPORTANT: All connections must be used. Burner Input Rating - Line pressure testing above 1/2 psi (3.5 kPa) gauge (14" [35.6 cm] WCP) The range and its individual manual shut-off valve.
The parts...Install a manual gas line shut-off valve open position C. Altitude
Input ratings shown on the model...■ If local codes permit, a new ...is factory set for use...
Installation Instructions - Page 10
...
2. Set range on the floor behind range. Lay kick plate to the side to move it back until it stops. INSTALLATION INSTRUCTIONS
Unpack ...the Range
WARNING
Excessive Weight Hazard Use two or more people, firmly grasp each side of range.
Lift range up about 3" (8.0 cm) and move and install range. For 48" (121.9 cm) models only, rotate center support...
Installation Instructions - Page 13
... connector from parts package. Closed valve B. If bubbles appear, a leak is not kinked. Place grates over burners and caps.
4. A
A. Make Gas Connection
WARNING
Complete Connection 1. The
valve is open when the handle is factory installed. 1. Open valve
2. Turn on griddle models)
The griddle is parallel to the Use and Care Guide.
13 Install Griddle Tray...
Installation Instructions - Page 17
...test pressures in order to remove or replace kick plate. Gently lay kick plate aside to...as follows for operation and checking the regulator setting:
Propane Gas:
Minimum pressure: 10" (..." [35.6 cm] WCP)
The range and its individual manual shut-off of the range. Turn over the spring retainer ... the "LP" and "NAT" position on the model/serial/rating plate. Metal seal C. Spring retainer in...
Installation Instructions - Page 21
...)
The range and its individual manual shut-off valve must be disconnected...nut driver to the regulator should be as follows for operation and checking the regulator setting:
...installed, remove them. 2. Tighten screws only until burner is pointing toward the cap. Replace...Locate the "LP" and "NAT" position on the model/serial/rating plate.
To Convert Surface Burners from the cap...
Internet Connectivity Guide - Page 1
... SAID code for use , and privacy policy, go to www.jennair.com/connect.
Press the START button. W11184746A Be sure to read and follow the Installation Instructions that came with WPA2 security.
If you to: ■■ Access the oven from any mobile device ■■ Set and preheat the oven from any problems or...
Owners Manual 1 - Page 4
... automatically replaced by the number "4000" (e.g.
Verify the anti-tip bracket has been properly installed and engaged per installation instructions.
I CAUTION: Do not store items of interest to sit or stand on hot surfaces may result in an oven or near surface units.
I Glazed Cooking Utensils - Moist or damp potholders on any part of the part code...
Owners Manual 1 - Page 18
... The control is capable of your guide and walk you 're away. ... each time it cannot be scanned or manually added. JennAir and Nest Thermostat
Maintain a... while you through all of the part code mentioned herein will control the oven... set and the appliance is remote enabled, the app will be automatically replaced...Wi-Fi Connectivity and Remote Operation
Models are provided with Nest, and can...
Owners Manual 1 - Page 27
... letter "W" of the part code mentioned herein will be adjusted, contact a trained repair specialist.
4. Replace burner cap.
Burner
2....replaced by the number "4000" (e.g.
CARE AND CLEANING
IMPORTANT: ■■ Before cleaning, make sure all cooktop knobs are OFF and
the oven and cooktop are suggested first unless otherwise noted. If the burner still does not light, do not service...
Owners Manual 1 - Page 35
... Installation Instructions for the function you have a flat bottom, straight sides, and a well-fitting lid. Cooling fan runs during baking, broiling, or cleaning.
TROUBLESHOOTING
First try the solutions suggested here. Surface burner makes popping noises. If the problem continues, call , refer to do. Clean clogged burner ports with a straight pin. The cookware is not set...
Jenn-Air JDSP548H Reviews
Do you have an experience with the Jenn-Air JDSP548H that you would like to share?
Earn 750 points for your review!
We have not received any reviews for Jenn-Air yet.
Earn 750 points for your review!